Tribological Characteristics of SiC Ceramics in High-Temperature and High-Pressure Water

The effects of temperature and sliding speed on the tribological behavior of a SiC ceramic by sliding on the same material in deoxygenated water were investigated from room temperature to 300°C under the corresponding saturated vapor pressures. The friction coefficient and specific wear rates of both plates and disks increased at elevated temperatures at all sliding speeds, but decreased with increasing sliding speed at 120° and 300°C. Fine mirrorlike worn surfaces were observed without wear debris under all sliding conditions. The wear mechanism appears to consist of hydrothermal oxidation of SiC and dissolution of reaction products such as silica.     

Transient analysis of the release and reduction of NOx using a Pt/Ba/Al2O3 catalyst

The release and reduction of NO_x in a NO_x storage-reduction (NSR) catalyst were studied with a transient reaction analysis in the millisecond range, which was made possible by the combination of pulsed injection of gases and time resolved time-of-flight mass spectrometry. After an O₂ pulse and a subsequent NO pulse were injected into a pellet of the Pt/Ba/Al₂O₃ catalyst, the time profiles of several gas products, NO, N₂, NH₃ and H₂O, were obtained as a result of the release and reduction of NO_x caused by H₂ injection. Comparing the time profiles in another analysis, which were obtained using a model catalyst consisting of a flat 5 nmPt/Ba(NO₃)₂/cordierite plate, the release and reduction of NO_x on Pt/Ba/Al₂O₃ catalyst that stored NO_x took the following two steps; in the first step NO molecules were released from Ba and in the second step the released NO was reduced into N₂ by H₂ pulse injection. When this H₂ pulse was injected in a large amount, NO was reduced to NH₃ instead of N₂.

A only small amount of H₂O was detected because of the strong affinity for alumina support. We can analyze the NO_x regeneration process to separate two steps of the NO_x release and reduction by a detailed analysis of the time profiles using a two-step reaction model. From the result of the analysis, it is found that the rate constant for NO_x release increased as temperature increase.     

Microstructures of functionally graded materials fabricated by centrifugal solid-particle andin-situ methods

Functionally graded materials (FGMs) belong to a relatively new class of inhomogeneous composite materials, in which the composition and/or microstructure undergo a gradual change along some directions. In this review article, the microstructures and composition gradients in Al/SiC, Al/Shirasu (volcanic eruptions commonly found in south Kyushu in Japan), Al/Al₃Ti, Al/Al₃Ni, Al/Al₂Cu FGMs have been investigated. The Al/SiC, Al/Shirasu and Al/Al₃Ti FGMs are fabricated by the centrifugal solid particle method where the distribution particles of SiC, Shirasu and Al₃Ti are solids in the melts. On the other hand, Al/Al₃Ni and Al/Al₂Cu FGMs are fabricated by the centrifugalin-situ method where Al/Al₃Ni and Al/Al₂Cu systems have lower liquidus temperatures than the processing temperatures. The feature of Al/(Al₃Ti−Al₃Ni) hydrid FGM, which is fabricated by a method combining both the centrifugal solid-particle andin-situ methods, is also shown.     

Relationship between crystallinity and device characteristics of In‐Sn‐Zn oxide

We have reported that the transistors having the c‐axis‐aligned crystalline (CAAC) In‐Ga‐Zn oxide (IGZO) show good performance. Recently, In‐Sn‐Zn Oxide (ITZO) has attracted much attention because of its high electron mobility, as well as IGZO. However, it has been reported that ITZO field effect transistors (FET) tend to have positive Vth (normally‐on characteristics) and poor reliability compared with IGZO‐FETs. We have reported that high‐performance and high‐reliability OS‐FETs can be fabricated by using CAAC‐IGZO, which has high crystallinity and has no clear grain boundaries, as an active layer. Therefore, we have fabricated CAAC‐ITZO thin films to improve performance of ITZO‐FETs by using CAAC‐ITZO as an active layer. In addition, FETs employing CAAC‐ITZO have better characteristics and reliability than FETs using nano‐crystal ITZO. Furthermore, constant photocurrent method (CPM) measurement was carried out in order to estimate density of deep‐level defect states caused by oxygen vacancies in oxide semiconductors. The results show that CAAC‐ITZO has lower density of deep‐level defect states than nano‐crystal ITZO. We attribute the improvement in reliability of ITZO‐FETs to a decrease in deep‐level defect states of an ITZO active layer, as is the case with IGZO.     

Emergency response to the nuclear accident at the Fukushima Daiichi Nuclear Power Plants using mobile rescue robots

On March 11, 2011, a massive earthquake (magnitude 9.0) and accompanying tsunami hit the Tohoku region of eastern Japan. Since then, the Fukushima Daiichi Nuclear Power Plants have been facing a crisis due to the loss of all power that resulted from the meltdown accidents. Three buildings housing nuclear reactors were seriously damaged from hydrogen explosions, and, in one building, the nuclear reactions became out of control. It was too dangerous for humans to enter the buildings to inspect the damage because radioactive materials were also being released. In response to this crisis, it was decided that mobile rescue robots would be used to carry out surveillance missions. The mobile rescue robots needed could not be delivered to the Tokyo Electric Power Company (TEPCO) until various technical issues were resolved. Those issues involved hardware reliability, communication functions, and the ability of the robots' electronic components to withstand radiation. Additional sensors and functionality that would enable the robots to respond effectively to the crisis were also needed. Available robots were therefore retrofitted for the disaster reponse missions. First, the radiation tolerance of the electronic componenets was checked by means of gamma ray irradiation tests, which were conducted using the facilities of the Japan Atomic Energy Agency (JAEA). The commercial electronic devices used in the original robot systems operated long enough (more than 100 h at a 10% safety margin) in the assumed environment (100 mGy/h). Next, the usability of wireless communication in the target environment was assessed. Such tests were not possible in the target environment itself, so they were performed at the Hamaoka Daiichi Nuclear Power Plants, which are similar to the target environment. As previously predicted, the test results indicated that robust wireless communication would not be possible in the reactor buildings. It was therefore determined that a wired communication device would need to be installed. After TEPCO's official urgent mission proposal was received, the team mounted additional devices to facilitate the installation of a water gauge in the basement of the reactor buildings to determine flooding levels. While these preparations were taking place, prospective robot operators from TEPCO trained in a laboratory environment. Finally, one of the robots was delivered to the Fukushima Daiichi Nuclear Power Plants on June 20, 2011, where it performed a number of important missions inside the buildings. In this paper, the requirements for the exploration mission in the Fukushima Daiichi Nuclear Power Plants are presented, the implementation is discussed, and the results of the mission are reported.     

Stochastic Resonance in Recurrent Neural Network with Hopfield-Type Memory

Stochastic resonance (SR) is known as a phenomenon in which the presence of noise helps a nonlinear system in amplifying a weak (under barrier) signal. In this paper, we investigate how SR behavior can be observed in practical autoassociative neural networks with the Hopfield-type memory under the stochastic dynamics. We focus on SR responses in two systems which consist of three and 156 neurons. These cases are considered as effective double-well and multi-well models. It is demonstrated that the neural network can enhance weak subthreshold signals composed of the stored pattern trains and have higher coherence abilities between stimulus and response.     

A Review on InGaSb Growth under Microgravity and Terrestrial Conditions Towards Future Crystal Growth Project Using Chinese Recovery Satellite SJ-10

The paper reviewed the previous microgravity experiment using Chinese recovery satellite, the in-situ measurement of composition profile in the solution by X-ray penetration method and homogeneous growth of InGaSb by temperature freezing method under terrestrial condition for making clear the effect of gravity on the growth of InGaSb ternary alloy semiconductor crystals. The previous experimental results showed that the shape of solid/liquid interfaces and composition profile in the solution were significantly affected by gravity. Based on the previous microgravity experimental results, experimental conditions were investigated to grow homogeneous In _xGa _1?xSb with higher indium composition at Chinese recovery satellite SJ-10 in near future.     

A new quadruple therapy for the eradication of Helicobacter pylori. Effect of pretreatment with omeprazole on the cure rate

The aim of the study was to assess the speech discrimination ability of postlingually deaf adults implanted with the Combi 40 cochlear implant and to compare the results with the postoperative data published for other devices. The postoperative open and closed set speech perception performance of 21 consecutive patients was tested using a standardized test battery comprising a number, monosyllable, sentence, consonant and vowel discrimination test as well as a rhyme test in the sound only condition. Mean values achieved for each test 1, 6 and 12 months after "switch on" were evaluated. The results demonstrate that all patients have a substantial benefit from their implant and show a continuous improvement in their speech perception abilities with increased device experience. The mean percentages of correct answers after 12 months were 93.4 for numbers, 44.6 for monosyllables, 78.5 for sentences, 67.6 for the rhyme test, 59.8 for vowel, and 67.3 for consonant discrimination. Preoperatively, the mean discrimination score for monosyllables was 0%. The speech discrimination scores of our patients were similar or higher than described for similar patient groups implanted with other devices. The high stimulation rate of the implant system using the continuous interleaved speech processing strategy as well as a deep atraumatic electrode insertion into the apicalmost regions of the scala tympani may be the reason for good performance.     

Propositus with Weaver syndrome and his mildly-affected mother: implication of nontraditional inheritance?

AIMS AND BACKGROUND: Gliomas of the conus medullaris often show characteristic clinical, radiological, and intraoperative features which differ from gliomas involving other parts of the spinal cord. METHODS: Eight patients with histologically verified gliomas of the conus medullaris were diagnosed and studied. RESULTS: There were five men and three women ranging in age from 21 to 59 years. Predominant initial symptoms were back pain (4 cases) and leg weakness (4 cases). The most common findings on admission were flaccid paraparesis with impaired sensation and bladder dysfunction. Postoperative magnetic resonance (MR) images with more than 95% removal of a tumour were defined as "subtotal removal" (noted in 4 of 8 cases), and less than 95% as "partial removal" (4 of 8 cases). All patients had postoperative radiotherapy. During the follow-up period ranging from 3 to 10 years, there was no tumour recurrence or regrowth on MR images. CONCLUSIONS: The postoperative radiotherapy in gliomas of the conus medullaris where total resection is not possible seems provide a beneficial effect on preventing tumour regrowth.     

Analysis of right ventricular function during bypass of the left side of the heart by afterload alterations in both normal and failing hearts

This study investigated the mechanism of right ventricular failure during bypass of the left side of the heart by precisely assessing right ventricular function with use of a conductance catheter. Bypass of the left side of the heart was established with a centrifugal pump in 10 mongrel dogs weighing 11 to 19 kg. Right ventricular function during left heart bypass was evaluated by two parameters that were both derived from measurement of relative change in right ventricular volume by the conductance catheter technique. One parameter was the right ventricular end-systolic pressure-volume relationship as a load-independent index, and the other was the peak right ventricular pressure-right ventricular stroke volume relationship as a "force-velocity relationship." These parameters were measured in both normal and failing hearts while afterload was increased by bilateral intrapulmonary balloon inflation. Moreover, changes in these relationships were observed by varying assist ratios of left heart bypass from 0% to 100%. Failing heart models were induced by normothermic aortic clamping for 20 minutes. The right ventricular end-systolic pressure-volume relationship in normal hearts did not change, irrespective of the assist ratio of left heart bypass, whereas that in failing hearts decreased from 4.25 +/- 1.41 mm Hg/ml without bypass of the left side of the heart to 3.53 +/- 1.30 mm Hg/ml after 100% assist of left heart bypass (p < 0.05). In the peak right ventricular pressure-right ventricular stroke volume relationship, right ventricular stroke volume was almost constant in normal hearts when afterload was increased regardless of the assist ratio of left heart bypass. Moreover, right ventricular stroke volume was maintained at a higher level during bypass of the left side of the heart compared with that without left heart bypass. However, that slope of the relationship in failing hearts was inversely linear and became significantly steeper after 100% assist of bypass of the left side of the heart compared with that without left heart bypass (-0.131 +/- 0.042 versus -0.051 +/- 0.038, p < 0.005). Therefore ++these two slopes of the relationship intersected at a point that was considered the critical point of afterload during bypass of the left side of the heart. In other words, right ventricular stroke volume was decreased by 100% left heart bypass above the critical point of afterload. In conclusion, this study demonstrates not only that bypass of the left side of the heart results in an increase in right ventricular stroke volume in both normal and failing hearts at the physiologic range of afterload, but also that right ventricular function against higher afterload is impaired by 100% assist of bypass of the left side of the heart in failing hearts.