Portable sick house syndrome gas monitoring system based on novel colorimetric reagents for the highly selective and sensitive detection of formaldehyde

Formaldehyde (HCHO) emitted from the furniture and the walls in the rooms injures the eyes, nose, and respiratory organs and causes allergies, which is called sick house syndrome. We designed and synthesized novel colorimetric HCHO-sensing molecules (KD-XA01 and KD-XA02) which possess an enaminone structure and developed a hand-held instrument to monitor indoor HCHO gas with the use of KD-XA01. These sensing molecules produced speedy color changes from colorless to yellow under mild conditions, which was caused by the fact that the enaminone structure in the reagent reacts with HCHO to give a lutidine derivative. This reaction took place not only in the solution phase but also in the solid phase (surface of the cellulose paper). To take advantage of this phenomena, a handy and rapid monitoring system has been developed for detecting indoor HCHO gas using a highly sensitive and selective detection tablet constructed from the porous cellulose paper that contains silica gel as an adsorbent, KD-XA01, and phosphoric acid under optimum conditions. This instrument detected the surface color change of the tablet from white to yellow, which was monitored as a function of the intensity of the reflected light illuminated by an LED (475 nm). The response was proportional to the HCHO concentration at a constant sampling time and flow rate; 0.05 ppm HCHO, which is under the standard value set by the World Health Organization, was able to be detected in 5 min. The detection limit was 0.005 ppm. This monitoring system was not interfered by carbonyl compounds such as acetaldehyde and acetone, alcohols, hydrocarbons, and typical gases such as carbon monoxide, carbon dioxide, nitrogen dioxide, etc., which contributes to the measurement of correct HCHO concentrations. It was possible to monitor the HCHO gas in the room of a new apartment and school using this instrument; the response values were in good agreement with those obtained by the standard DNPH method. This highly sensitive, selective, and handy HCHO gas monitor is widely applicable and convenient for users who are not specialists in this field.     

Gluten contamination in food services and industry: A systematic review

Abstract

Gluten-related disorders (GRD) affects approximately 10% of the general population. The only treatment for GRD is still so far is the lifelong complete exclusion of gluten from the daily diet. The correct information about the presence/absence of gluten in food is very important to this group. The present study aimed to evaluate the prevalence of gluten contamination in gluten-free industrial and non-industrial products. In this systematic review, 24 cross-sectional studies were analyzed. The authors developed specific search strategies for Science Direct, Scopus, Web of Science, Google Scholar and ProQuest Dissertations & Theses Global. The authors evaluated the methodological quality of the included studies using criteria from Meta-analysis of Statistics Assessment and Review Instrument (MASTARI). We performed the statistical meta-analysis by metafor package of R program. 95.83% (n?=?23) of the studies presented positive results for contamination (over 20?ppm). In industrial food products, studies showed a contamination prevalence of 13.2% (95% CI: 10.8%–15.7%). In non-industrial food products, studies showed a contamination prevalence of 41.5% (95% CI: 16.6%–66.4%). Despite the non-industrial products presented higher contamination prevalence than the industrial products, the difference was not significant (p?=?0.072). The findings indicate cross-contamination in industrialized and non-industrialized products. As expected, industrial products labeled as gluten-free showed a lower percentage of gluten-contamination than non-industrialized. Despite that, any contaminated sample found in this group present greater relevance than non-labeled foods. It indicates that foods labeled as “gluten-free” should not be considered safe for patients with GRD since information on the label regarding the presence/absence of gluten is unreliable. Therefore, any gluten-contamination in products labeled as gluten-free is a serious problem to whom present GRD. Further studies are needed to estimate gluten cross-contamination in food service meals and industry better.     

High-Temperature Active Oxidation of Chemically Vapor-Deposited Silicon Carbide in CO─CO2 Atmosphere

Active oxidation behavior of CVD-SiC in CO─CO₂ atmospheres was investigated using a thermogravimetric technique in the temperature range between 1823 and 1923 K. The gas pressure ratio, P _CO2/ P _CO, was controlled between 10⁻⁴ and 10⁻¹ at 0.1 MPa. Active oxidation rates (mass loss rates) showed maxima at a certain value of P _CO2/ P _CO, ( P _CO2/ P _CO )^*, In a P _CO2/ P _CO region lower than the ( P _CO2/ P _CO)^* a carbon layer was formed on the SiC surface. In a P _CO2/ P _CO region higher than the ( P _CO2/ P _CO)^*, silica particles or a porous silica layer was observed on the SiC surface.     

NH3／H2O2溶液腐蚀下多孔硅光致荧光

用光致荧光谱、傅里叶变换红外光谱（ＦＴＩＲ）和扫描电子显微镜（ＳＥＭ）对用阳极氧化法制成的多孔硅层在１％ＮＨ３／Ｈ２Ｏ２溶液中的腐蚀现象进行了研究。红外分析表明，Ｓｉ－Ｏ键和Ｈ－Ｏ键的强度随ＮＨ３／Ｈ２Ｏ２溶液的腐蚀时间的增加而增加，Ｓｉ－Ｈ键强主匠随腐蚀时间增加而减少。光致荧光谱的峰值在腐蚀开始时先下降后上升，半高宽变窄，谱峰的以边明显蓝移。分析研究表明，１％ＮＨ３／Ｈ２Ｏ２溶液对多孔硅层有腐蚀     

Phase behavior of N‐isopropylacrylamide/acrylic acid copolymer hydrogels prepared with ultrasound

N‐Isopropylacrylamide/acrylic acid copolymer hydrogels were synthesized with ultrasound. The thermoresponsive phase behaviors of gels synthesized with ultrasound (US gels) were investigated and compared with those of gels synthesized in the absence of ultrasound (FR gels). The US gels showed thermoresponsive swelling behavior with a large hysteresis over a wide range of temperatures around its phase‐transition temperature. The hysteresis became larger with an increasing copolymerized acrylic acid content. The US gels were also characterized from the viewpoint of chemical, hydration, and macroscopic physical structures. Little difference was observed in the chemical and hydration structures of the FR gels and US gels. The macroscopic physical structure of the US gels was, however, distinct from that of the FR gels. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 2449–2452, 2003     

采用TAB快速测定EMD性能

TAB(聚四氟乙烯乙炔黑)是好的导电和粘结合二为一的材料,采用该材料能快速评定EMD的性能。     

Effect of Ultrasonication on the Microstructure and Tensile Elongation of Zirconia-Dispersed Alumina Ceramics Prepared by Colloidal Processing

To obtain dense, fine-grained ceramics, fine particles and advanced powder processing, such as colloidal processing, are needed. Al₂O₃ and ZrO₂ particles are dispersed in colloidal suspensions by electrosteric repulsion because of polyelectrolyte absorbed on their surfaces. However, additional redispersion treatment such as ultrasonication is required to obtain dispersed suspensions because fine particles tend to agglomerate. The results demonstrate that ultrasonication is effective in improving particle dispersion in suspensions and producing a homogeneous fine microstructure of sintered materials. Superplastic tensile ductility is improved by ultrasonication in preparing suspensions because of the dense and homogeneous fine microstructure.     

The electrical delivery of a sublimable II–VI compound by vapor transport in carbon nanotubes

Progress in the field of femtogram (10⁻¹⁵ g) mass delivery relies on finding dependable transport vehicles and uncomplicated methods to tailor the deposition of active substances. Here, current-conductive containers consisting of turbostratic carbon nanotubes were used to store a light-emitting ternary alloy and guide its delivery on demand. We found that the electrically-activated delivery process of this sublimable compound, performed inside a transmission electron microscope, was highly dependent on factors such as the substrate type and current injection mode. Furthermore, our observations suggest that the alleged “missing matter” problem is not solely due to surface migration. Besides extending the field of electrical delivery to the realm of functional materials, the extrusion and mass transport of a sublimable II–VI compound demonstrates that it is possible to guide vapor migration using a carbon nanotube support.     

Electrophoretic Deposition Behavior of Aqueous Nanosized Zinc Oxide Suspensions

The rheological behavior and electrophoretic deposition (EPD) of ZnO nanopowder (nano-ZnO) in aqueous media have been described. A cationic polyelectrolyte (polyethylenimine, PEI) was used to disperse and modify the surfaces of the ZnO nanoparticles. The rheological properties of the ZnO aqueous suspension were investigated by measuring the viscosity versus the pH and amount of dispersant. The EPD processing was conducted via cathodic electrodeposition, using stable suspensions with low viscosity, and the depositional behavior was investigated. Bubble-free nano-ZnO deposits with uniform microstructures were successfully obtained, which was an indication of good sintering behavior.