Detecting oxidized contaminants in water using sulfur-oxidizing bacteria

For the rapid and reliable detection of oxidized contaminants (i.e., nitrite, nitrate, perchlorate, dichromate) in water, a novel toxicity detection methodology based on sulfur-oxidizing bacteria (SOB) has been developed. The methodology exploits the ability of SOB to oxidize elemental sulfur to sulfuric acid in the presence of oxygen. The reaction results in an increase in electrical conductivity (EC) and a decrease in pH. When oxidized contaminants were added to the system, the effluent EC decreased and the pH increased due to the inhibition of the SOB. We found that the system can detect these contaminants in the 5-50 ppb range (in the case of NO(3)(-), 10 ppm was detected), which is lower than many whole-cell biosensors to date. At low pH, the oxidized contaminants are mostly in their acid or nonpolar, protonated form which act as uncouplers and make the SOB biosensor more sensitive than other whole-cell biosensors which operate at higher pH values where the contaminants exist as dissociated anions. The SOB biosensor can detect toxicity on the order of minutes to hours which can serve as an early warning so as to not pollute the environment and affect public health.     

GPS‐Based Orbit Determination for KOMPSAT‐5 Satellite

Korea Multi‐Purpose Satellite‐5 (KOMPSAT‐5) is the first satellite in Korea that provides 1 m resolution synthetic aperture radar (SAR) images. Precise orbit determination (POD) using a dual‐frequency IGOR receiver data is performed to conduct high‐resolution SAR images. We suggest orbit determination strategies based on a differential GPS technique. Double‐differenced phase observations are sampled every 30 seconds. A dynamic model approach using an estimation of general empirical acceleration every 6 minutes through a batch least‐squares estimator is applied. The orbit accuracy is validated using real data from GRACE and KOMPSAT‐2 as well as simulated KOMPSAT‐5 data. The POD results using GRACE satellite are adjusted through satellite laser ranging data and compared with publicly available reference orbit data. Operational orbit determination satisfies 5 m root sum square (RSS) in one sigma, and POD meets the orbit accuracy requirements of less than 20 cm and 0.003 cm/s RSS in position and velocity, respectively.     

Highly Power‐Efficient Rack‐Level DC Power Architecture Combined with Node‐Level DC UPS

This letter presents a highly efficient rack‐level DC power architecture combined with a node‐level DC uninterruptible power supply (UPS). The proposed system can provide almost the equivalent power efficiency of a high‐voltage DC data center without any change in the existing power infrastructure. The node‐level DC UPS combined with a power distribution board provides high power efficiency as well as lower UPS installation costs. Implemented on a rack, the entire power system can be monitored through a network.     

Streaming RFID: Robust Stream Transmission over Passive RFID

This paper proposes the streaming radio frequency identification (RFID) protocol to support robust data streaming in a passive communication, which is extended from the ISO18000‐6 Type C RFID standard. By observing and modeling the unique bit error behavior through detailed analysis in this paper, we found that performance is significantly limited by inaccurate and unstable link frequencies as well as low SNR which are inevitable for passive devices. Based on the analysis, we propose a simple and efficient protocol to adaptively insert extra error control sequences in a packet for tolerating tough link condition while maximizing the throughput and preserving the minimal implementation cost. To evaluate effectiveness of our proposal in real‐time streaming applications, we experimented on real‐time H.264 video streaming and prototyped the system on FPGA. To our best knowledge, our paper is the first work to take analytical approach for maximizing the throughput and demonstrate the possibility of the real‐time multimedia streaming transmission in the passive RFID system.     

Sub‐Nanometer Level Size Tuning of a Monodisperse Nanoparticle Array Via Block Copolymer Lithography

The fabrication and catalytic application of a size‐tunable monodisperse nanoparticle array enabled by block copolymer lithography is demonstrated. Highly uniform vertical cylinder nanodomains are achieved in poly(styrene‐block‐4‐vinylpyridine) (PS‐b‐P4VP) diblock copolymer thin‐films by solvent annealing. The prominent diffusion of the anionic metal complexes into the protonated P4VP cylinder nanodomains occurs through specific electrostatic interactions in a weakly acidic aqueous solution. This well‐defined diffusion with nanoscale confinement enables preparation of the laterally ordered monodisperse nanoparticle array with sub‐nanometer level precise size tuning. The controlled growth of monodisperse nanoparticle arrays is proven by their catalytic use for vertical carbon nanotube (CNT) growth via plasma enhanced chemical vapor deposition (PECVD). Since the size of the catalyst particles is the decisive parameter for the diameters and wall‐numbers of CNTs, the highly selective growth of double‐walled or triple‐walled CNTs could be accomplished using monodisperse nanoparticle arrays.     

Relations among Security Models for Authenticated Key Exchange

Usually, key‐establishment protocols are suggested in a security model. However, there exist several different security models in the literature defined by their respective security notions. In this paper, we study the relations between the security models of key establishment. For the chosen security models, we first show that some proven key‐establishment protocols are not secure in the more restricted security models. We then suggest two compilers by which we can convert a key‐establishment protocol that is secure in a specific security model into a key‐establishment protocol that is still secure in a more restricted security model.     

Pollutant destruction in a reverse-flow chromatographic reactor

A reverse-flow chromatographic reactor (RFCR) is a packed reactor in which the flow direction is reversed periodically and in which one of the reactants is strongly adsorbed on the catalyst. We study the performance of a RFCR used to destruct a pollutant A by a reaction with a reactant B, the emission level of which is subject to even stricter restrictions. Due to safety considerations, this reactant B is introduced in the center of the reactor. The RFCR operation enables a reduction of the regulated effluent products well below the minimum attainable under a steady-state operation of the same packed-bed reactor. Moreover, it can respond effectively to any perturbations in the pollutant feed rate and/or concentration. When the environmental regulations on the emission of B are stricter than those of A, it is often advantageous to feed slightly less B than the amount needed for complete conversion of A. We present a methodology for finding the operating conditions that lead to the minimal level of weighted emission of both A and B. A continuous feed of the reactant B is superior to operation in which the same amount of B is fed during each semi-cycle but in a non-continuous fashion.     

Experimental study on the treatment of volatile organic compound vapors using a photoreactor equipped with photocatalyst‐coated fabrics

In this study, methods were developed to enlarge the scope of traditional applications of titanium dioxide (TiO₂) and to increase the value of felted fabric by allowing volatile organic compound (VOC) degradation as well as dust filtration in a photoreacting fabric filter. In the past, when a V–Ti mixed catalyst was used, the application of felted fabric as a support material for the catalyst was difficult because the active temperature of the catalyst ranged from 250 to 400°C. Thus, in this study catalyst‐coated felted fabric was manufactured at normal temperature conditions, and then fundamental de‐VOC performance tests were conducted under irradiation condition to develop a fabric filter having a de‐VOC function in addition to a dust‐filtration function. Toluene vapor was selected as a sample VOC because it poses health hazards, has been widely used as an organic solvent, and has been known as a compound that is difficult to dissociate. To manufacture and use a fabric filter that degrades VOC_S, and removes dust particles through using photocatalyst‐coated fabrics and light sources, optimum operating conditions were obtained by observing the degradation attributed to varying the toluene‐vapor flow rate, the initial toluene concentration, flue gas humidity, TiO₂ loading onto the surface of the fabric, and the intensity and wavelength of a near ultraviolet light lamp. To keep the flue gas humidity at a relatively constant level, a system to automatically control the humidity was constructed. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 91: 3174–3179, 2004     

Equine oocyte-cumulus morphology as affected by follicular size

From the ovaries of 256 slaughtered mares a total of 1713 follicles were isolated from which 1641 (95.8%) oocytes were recovered (6.4/mare). A total of 564 follicles and oocytes were evaluated for the degree of vascularisation of the follicle wall, the appearance of the follicular fluid and the location and morphology of the cumulus-oocyte-complex. Follicles with a diameter of >10 mm displayed more numerous, well branched and more pronounced blood vessels than the smaller ones (4-10 mm diameter) and most of them contained clear, yellowish fluid with few granulosa cells. The percentage of oocytes with compact cumuli increased significantly with an increasing diameter of the follicle, being 233%, 43.9%, 55.6% and 64.2% (P<0.01) for the follicles with diameters of 4-10, 11-15, 16-20 and 21-35 mm, respectively. The percentage of oocytes attached to the follicle wall also increased with increasing follicle size, being 48.0%, 59.6%, 81.5% and 90.1% (P<0.01), respectively. On the contrary, the percentage of oocytes floating in the follicular fluid decreased with increasing follicle diameter, from 52.0% in the smallest follicles to 9.9% in the biggest ones. A significantly greater percentage of oocytes found on the follicular wall than in the follicular fluid had a compact cumulus (56.6 versus 21.3%; P<0.01). For in vitro culture were accepted 30.4%, 54.3%, 60.7% and 77.8% (P<0.01) of oocytes from the follicles with diameters of 4-10, 11-15, 16-20 and 21-35 mm, respectively. After culture for 28-40 h in TCM 199 medium, 90 of a total of 165 (54.5%) oocytes reached the metaphase II stage of maturation.     

Static valuation of combat force potential by the analytichierarchy process

A hierarchical weapon systems valuation model framework is discussed and the applicability of the analytic hierarchy process (AHP) in establishing relative values of military weapon systems is investigated. The model is a modified version of the weapon effectiveness index/weighted unit value method (WEI/WUV), a conventional method of static valuation of ground weapon systems as well as a combat unit's force potential. The hierarchical structures gives some unique features to the application of AHP. A calibration study for the model with AHP-based pairwise comparisons has been conducted for some weapon systems in Korea. Its results confirm the applicability and practicality of the 1-9 scale AHP by group judgments in measuring the relative values of weapons