Interferometric monitoring of satellite longitudes

This paper proposes a technique for monitoring the longitudinal motion of geosynchronous satellites. A two‐antenna interferometer is used, with the baseline orientation adjusted to a particular horizontal azimuth. The interferometer then becomes insensitive to the north–south motion of the satellite, and this enables direct measurement of the satellite's longitudinal motion. Longitudes are monitored continuously, with no delay when orbital manoeuvres occur. The proposed technique is particularly useful when two or more satellites are operating in close proximity and their longitudes must be precisely monitored for safety control. Copyright © 2005 John Wiley & Sons, Ltd.     

Identify unrepairability to speed-up spare allocation for repairing memories

In this paper, we discuss some strategies for identifying unrepairable memories, and from that to introduce a novel theorem that can make more precise identification. A new algorithm for searching repair solutions is also proposed, which characterizes the rows, and columns of defective memory cells with revised effective coefficients. We have simulated it on many generated example maps, and compared it with the previous algorithms to verify its efficiency. It's combined with those arranged strategies of judging unrepairability to generate a complete flow. The complete algorithm has also been run on many examples with various memory sizes, defect numbers, and distribution types. The simulation results further show that identifying unrepairability in advance can help the reconfiguration procedure run much faster than searching solutions directly.     

An experimental study of an optical burst switching network based on wavelength-selective optical switches

In this article we report the system structure and test results of an experimental optical burst switching network with three edge router's and one core node. Wavelength-selective switches developed for this system and their characteristics are depicted. The implementation and performance of our new scheme for the just-in-time protocol are described. We also report experimental results of FTP and VOD services on this system. Some parameters, including traffic rate, average burst data length, and assembly time, are studied.     

Frequency notched printed slot antenna with parasitic open-circuit stub

A new frequency notched ultra-wideband microstrip slot antenna with a parasitic tuning stub is proposed. The antenna is similar in configuration to a conventional microstrip slot antenna; by introducing a parasitic open-circuit tuning stub, flexible frequency notched function is achieved. Several properties of the antenna, such as frequency notched function, antenna transfer function and gain, have been investigated. As is reported, the operation bandwidth of the antenna is 2.91-11.16 GHz, in which a frequency notched band of 5.10-5.85 GHz has been achieved. Furthermore, good ultra-wideband linear transmission performance over the entire operation frequency range has also been achieved.     

Nanoscale structural characteristics and electron field emission properties of transition metal–fullerene compound TiC60 films

Transition-metal compound TiC₆₀ thin films were grown by co-deposition from two separated sources of fullerene C₆₀ powder and titanium. Study of structural properties of the films, by Raman spectroscopy, atomic force microscopy, and scanning tunneling spectroscopy reveals that the films have a deformed C₆₀ structure with certain amount of sp³ bonds and a rough surface with a large number of nanoclusters. z–V tunnelling spectroscopic measurements suggest that several charge transport mechanisms are involved in as the tip penetrates into the thin film. Conventional field electron emission (FEE) measurements show a high emission current density of 10 mA/cm² and a low turn-on field less than 8 V/μm, with the field enhancement factors being 659 and 1947 for low-field region and high-field region, respectively. By exploiting STM tunneling spectroscopy, local FEE on nanometer scale has also been characterized in comparison with the conventional FEE. The respective field enhancement factors are estimated to be 99–355 for a gap varying from 36 to 6 nm. The enhanced FEE of TiC₆₀ thin films can be ascribed to structural variation of C₆₀ in the films and the electrical conducting paths formed by titanium nanocrystallites embedded in C₆₀ matrix.     

Grazing incidence reflection absorption Fourier transform infrared (GIRA-FTIR) spectroscopic studies on the ferroelectric behavior of poly(vinylidene fluoride–trifluoroethylene) ultrathin films

Grazing incidence reflection absorption Fourier transform infrared (GIRA-FTIR) spectroscopy was used to characterize the ferroelectric behavior of a thin poly(vinylidene fluoride–trifluoroethylene) P(VDF–TrFE) copolymer. The lab-built GIRA-FTIR apparatus allowed the heating and corona poling process to be carried out whilst collecting the GIRA spectra of the thin polymer film. The Curie transition from the ferroelectric to paraelectric phase was confirmed from the abrupt change in intensity of the 849 cm⁻¹ band in the RA-FTIR spectrum. It was found that the Curie temperature dropped dramatically when the film thickness was lowered to below a certain critical value of approximately 100 nm. The switching of the CF₂ dipoles in the ferroelectric crystals after applying the external electric field could be determined by monitoring the change in the 849 cm⁻¹ band intensity. For the 600 nm thick P(VDF–TrFE) film, the switching of the dipoles appears to occur almost instantaneously, while the kinetics of dipole switching of the 75 nm thick film were significantly retarded. The repeated switchability of the CF₂ dipoles upon the application of a bipolar cyclic electric field was also confirmed. The bistability of the film due to remnant polarization was also confirmed from the absorbance of the 849 cm⁻¹ band after removing the applied voltage during corona poling.     

Mechanical improvement of concrete by irradiated polypropylene fibers

Fiber reinforced concrete (FRC) contains fibers physically mixed with gravel, sand, cement, and water. So far, adequate mechanical performance of FRC has been obtained at high cost and using complex technologies; important here is the geometry and surface characteristics of the polymers. We have modified polymeric‐fiber surfaces by using gamma radiation. Irradiated polypropylene (PP) fibers were submitted to 0, 5, 10, 50, and 100 kGy of gamma irradiation dosages. First, tensile strength of PP fibers was evaluated, and then fibers blended at 0, 1.0, 1.5, and 2.0% in volume with Portland cement, gravel, sand, and water. The highest values of compressive strength were obtained with irradiated‐fibers at 10 kGy and 1.5% in volume of fiber. The result is 101 MPa, as compared to 35 MPa for simple concrete without fibers. POLYM. ENG. SCI., 45:1426–1431, 2005. © 2005 Society of Plastics Engineers     

Relating catalyst structure and composition to the water–gas shift activity of Cu–Zn-based mixed-oxide catalysts

In order to investigate the effect of cerium oxide on Cu–Zn-based mixed-oxide catalysts four catalyst samples were characterized by means of XRD, in situ XANES and thermogravimetric analysis. The activity of the catalyst samples was tested for the forward water–gas shift reaction. Cerium oxide was found to increase the crystallinity of the ZnO phase indicating a segregation of the Cu and ZnO phases. The TOF of the water–gas shift reaction based on chemisorption data was found to be independent of composition and preparation conditions of the four catalyst samples. In contrast, the catalyst stability depends on composition and preparation conditions. Cerium oxide impregnated before calcination of the hydrotalcite-based Cu–Zn precursors leads to a more stable water–gas shift catalyst.     

Dynamics of plastic polygonal plates with rounded corners

A method of calculating the dynamic deflection of rigidly plastic plates resting on a viscoelastic bed with complex piecewise-smooth support contours composed of sections of straight lines and circles under impact and explosion loading is presented. The general solution, which includes previously known partial solutions for circular and polygonal plates, is obtained. The results of calculation of the deflection of a square hinge-supported plate with rounded corners are presented for the case of the presence and absence of a plastic base.Translated from Problemy Prochnosti, No. 9, pp. 62–66, September, 1991.     

Modelling the effects of dam removal on migratory walleye (Sander vitreus) early life‐history stages

Many dams in the USA have outlived their intended purpose and an increasing number are being considered for removal. Yet, quantitative studies of the potential physical, biological and ecological responses are needed to assess dam removal decisions. In this paper, the responses of migratory walleye (Sander vitreus) to increased spawning habitat availability as a result of dam removal was studied by comparing scenarios with and without a high‐head dam in the Sandusky River (Ohio), a major tributary to Lake Erie. A conceptual, ecological model was proposed to define the relationship between hydrodynamics and walleye spawning, egg hatching, larval drift and survival. A mathematical, ecological model of the early life‐history stages was then developed and coupled with time series of depth and velocity predictions over the spawning grounds from a 1‐D hydrodynamic model. Model simulations were run for 1984–1993 for both the with‐ and without‐dam scenarios to assess the potential benefit of dam removal. The simulation results demonstrated that velocity, depth and water temperature are major factors influencing adult walleye spawning success. Without the dam, 10 times the amount of spawning habitat would be available for walleye to spawn. This increase in spawning habitat area resulted in up to five times the total egg deposition and seven times the larval output to the nursing grounds, based on the assumption that 5% of the walleye population of Lake Erie migrated up the Sandusky River to spawn. We concluded that the spawning habitat in the current condition (with the dam) is limiting and additional spawning habitat upstream could significantly increase the number of larval walleye drifting to Lake Erie. The model sensitivity analysis showed that the number of walleye migrating up the river in spring is the dominant factor for larval recruitment to the lake. Copyright © 2006 John Wiley & Sons, Ltd.