Exciton photoluminescence in doped quasi-1D structures based on silicon

The dependence of carrier density in silicon quantum wires sheathed with SiO₂ on the wire diameter and the position of impurity atoms in respect to the wire center is analyzed theoretically. It is shown that, as the diameter of wires and nanocrystals decreases, the ionization energy of a dopant increases; therefore, the free carrier density decreases, and the screening of the Coulomb attraction becomes ineffective. As a result, the photoluminescence is defined by the radiative recombination of excitons even in the case of heavily doped Si. These conclusions are supported by the data of experimental study of spectral, excitation-power, and temperature dependences of photoluminescence in porous silicon structures fabricated on lightly and heavily doped Si substrates.     

用两亲聚合物制备大颗粒苯丙乳液

分别以两亲聚合物P(C9-AA)和P(DCPD-St-α-St-AA)作乳化荆，研究了制备大颗粒(约1μm)及具有一定稳定性的苯丙乳液的方法，讨论了乳化剂，温度及引发剂用量对乳液性能的影响。结果表明，以P(C9-AA)作乳化剂时，引发剂用量为单体质量的1．2％，90℃时可以合成性能良好的苯丙乳液；以P(DCPD-St-α-St-AA)作乳化荆时，引发剂用量为单体质量的1．2％，80℃时可以合成性能良好的苯丙乳液。     

A Study of AlN Films Prepared by Arc Ion Plating

Hexagonal AlN films have been obtained by arc ion plating at different negative biases ,X-ray diffraction and scanning electron microscopy results show that AlN films with smooth surfaces and (002) preferred orientation are obtained at low biases ,whereas those with coarse surfaces and (100) preferred orientation are obtained at high biases,The formation mechanism of AlN is analyzed and the experiment results are discussed,The effect of bias on adhesion strength has also been examined.     

浅论太阳电池在通信工程中的应用

介绍了太阳电池应用的一般要求和太阳能供电系统的组成及运行，给出了工程设计个常用的太阳电池容量计算方法，并提出太阳能供电系统运行维护注意事项。     

Error Concealment Based on Semantic Prioritization with Hardware‐Based Face Tracking

With video compression standards such as MPEG‐4, a transmission error happens in a video‐packet basis, rather than in a macroblock basis. In this context, we propose a semantic error prioritization method that determines the size of a video packet based on the importance of its contents. A video packet length is made to be short for an important area such as a facial area in order to reduce the possibility of error accumulation. To facilitate the semantic error prioritization, an efficient hardware algorithm for face tracking is proposed. The increase of hardware complexity is minimal because a motion estimation engine is efficiently re‐used for face tracking. Experimental results demonstrate that the facial area is well protected with the proposed scheme.     

Relating the Morphology of Poly(p‐phenylene vinylene)/Methanofullerene Blends to Solar‐Cell Performance

The performance of bulk‐heterojunction solar cells based on a phase‐separated mixture of donor and acceptor materials is known to be critically dependent on the morphology of the active layer. Here we use a combination of techniques to resolve the morphology of spin cast films of poly(p‐phenylene vinylene)/methanofullerene blends in three dimensions on a nanometer scale and relate the results to the performance of the corresponding solar cells. Atomic force microscopy (AFM), transmission electron microscopy (TEM), and depth profiling using dynamic time‐of‐flight secondary ion mass spectrometry (TOF‐SIMS) clearly show that for the two materials used in this study, 1‐(3‐methoxycarbonyl)propyl‐1‐phenyl‐[6,6]‐methanofullerene (PCBM) and poly[2‐methoxy‐5‐(3′,7′‐dimethyloctyloxy)‐1,4‐phenylene vinylene] (MDMO‐PPV), phase separation is not observed up to 50 wt.‐% PCBM. Nanoscale phase separation throughout the film sets in for concentrations of more than 67 wt.‐% PCBM, to give domains of rather pure PCBM in a homogenous matrix of 50:50 wt.‐% MDMO‐PPV/PCBM. Electrical characterization, under illumination and in the dark, of the corresponding photovoltaic devices revealed a strong increase of power conversion efficiency when the phase‐separated network develops, with a sharp increase of the photocurrent and fill factor between 50 and 67 wt.‐% PCBM. As the phase separation sets in, enhanced electron transport and a reduction of bimolecular charge recombination provide the conditions for improved performance. The results are interpreted in terms of a model that proposes a hierarchical build up of two cooperative interpenetrating networks at different length scales.     

Preparation of trichlorosilane by plasma hydrogenation of silicon tetrachloride

We have studied silicon tetrachloride hydrogenation in an rf (40.68 MHz) plasma and have determined the trichlorosilane yield as a function of the molar energy input, H₂: SiCl₄ molar ratio, and pressure. The highest trichlorosilane yield achieved is 60%, and the minimum energy input is 0.3 kW h per mole of SiHCl₃.     

A Micellar Route to Ordered Arrays of Magnetic Nanoparticles: From Size‐Selected Pure Cobalt Dots to Cobalt–Cobalt Oxide Core–Shell Systems

Starting with Co‐salt‐loaded inverse micelles, which form if the diblock copolymer polystyrene‐block‐poly(2‐vinylpyridine) is dissolved in a selective solvent like toluene and CoCl₂ is added to the solution, monomicellar arrays of such micelles exhibiting a significant hexagonal order can be prepared on top of various substrates with tailored intermicellar distances and structure heights. In order to remove the polymer matrix and to finally obtain arrays of pure Co nanoparticles, the micelles are first exposed to an oxygen plasma, followed by a treatment in a hydrogen plasma. Applying in‐situ X‐ray photoelectron spectroscopy, it is demonstrated that: 1) The oxygen plasma completely removes the polymer, though conserving the original order of the micellar array. Furthermore, the resulting nanoparticles are entirely oxidized with a chemical shift of the Co 2p_3/2 line pointing to the formation of Co₃O₄. 2) By the subsequent hydrogen plasma treatment the nanoparticles are fully reduced to metallic Co. 3) By exposing the pure Co nanoparticles for 100 s to various oxygen partial pressures pequation/tex2gif-inf-5.gif, a stepwise oxidation is observed with a still metallic Co core surrounded by an oxide shell. The data allow the extraction of the thickness of the oxide shell as a function of the total exposure to oxygen (pequation/tex2gif-inf-7.gif × time), thus giving the opportunity to control the ferromagnetic–antiferromagnetic composition of an exchange‐biased magnetic system.     

Soft X-ray emission from the plasma of a conductor exploding in a strong longitudinal magnetic field

Previous experiments with the electric explosion of conductors in a strong (50 T) longitudinal magnetic field showed the formation of a relatively low-density plasma around the central part of the explosion channel, which exhibited expansion at a velocity on the order of 10–20 km/s [1, 2]. Expansion of the plasma was accompanied by displacement of the magnetic field from the explosion channel, which was manifested by a diamagnetic signal. An analysis of the plasma energy balance is hindered by the lack of reliable data about radiative energy losses. Here, we report the first experimental results on the radiation pulse kinetics and the first estimates of the radiation energy.     

An NMR magnetometer with frequency modulation

An NMR tracking magnetometer, in which the frequency modulation is used instead of the traditional magnetic modulation, is described. Owing to the proposed digital compensation of modulation shifts, the tracking error is negligibly small and does not exceed the corresponding error for NMR magnetometers with magnetic modulation. The absence of the modulation rings decreases the sizes of the sensors to the utmost and excludes their effect on the surrounding systems. 50%-deuteron saturated solution of lithium chloride in water of 50% deuterons, which is used as a sensor substance, allows one to measure magnetic fields of 0.0625 to 15.3 T with a 10^?7 relative error at the most.