Virtual circuit connection method for RSVP multicasting supportingheterogeneous receivers on the ATM network

The authors suggest a novel virtual circuit connection method based on the reverse traversing technique to minimise the waste of network bandwidth resources, when the Internet protocol multicast is interoperated using the resource reservation protocol over an asynchronous transfer mode network. Simulation results show that, as the number of receivers increases, the bandwidth requirements on all links of the network of the proposed scheme become more advantageous than those of other conventional methods     

Propagation of a quasi-shear horizontal acoustic wave in Z-Xlithium niobate plates [and conductivity sensor application]

It is found that an acoustic wave which is nearly polarized in the shear horizontal (SH) direction can propagate along the X axis of a Z-cut lithium niobate plate if the ratio h/λ, where h=plate thickness and λ=acoustic wavelength, is less than about 0.5. Attractive properties of this quasi-SH wave include: (1) phase velocity nearly constant for all values of h/λ; (2) ability to propagate in contact with a liquid medium; and (3) electromechanical coupling coefficient as high as 0.15. These properties make the wave attractive for use in a variety of sensor and signal processing applications. An example of sensor applications is illustrated by using the wave to measure conductivity of liquids (aqueous KCl solution). The frequency of a 12-MHz quasi-SH mode oscillator fabricated on a 0.48 wavelength thick Z-X lithium niobate plate is found to vary by more than 80 kHz for variation in KCI concentration from 0 to 0.15%     

Directly Compressible Acetaminophen Compositions Prepared by Fluidized-Bed Granulation

Polyvinylpyrrolidone (PVP) in aqueous solution was used as a binding agent in a fluidized-bed system to agglomerate acetaminophen powder into directly compressible granules. It was found that a minimal amount of 5% w/w PVP in a concentration of 7.5% w/v or less was needed to produce granules with an acceptable flow and the corresponding tablets having enough hardness without capping. There was a strong correlation between the time for 80% dissolved (T₈₀) and the logarithm of granule volume-surface mean diameter. A directly compressible acetaminophen composition to manufacture tablets having a T₈₀ value less than 30 min can be prepared simply by adding an appropriate amount of disintegrant (crospovidone, sodium starch glycolate, or pregelatinized starch) to the agglomerated granules.     

Potential difference and photovoltaic effect arising from distortion of the electron wave function in a GaAs quantum well with a thin AlGaAs barrier

This paper discusses changes in the spectrum and distortion of the electron wave function of a GaAs quantum well when a thin AlGaAs barrier is introduced into it. The potential difference generated across the quantum well by distortion of the electron wave function is calculated, along with its dependence on the position of the barrier in the quantum well. The photovoltaic response of the structure to optical intersubband excitations is also calculated, along with the role of wave function and electronic spectrum distortion as well as intersubband nonradiative transitions in generating this response. The suitability of a GaAs quantum well with a thin barrier for use as an infrared detector is considered. Fiz. Tekh. Poluprovodn. 32, 1246–1250 (October 1998)     

An in vitro model of traumatic neuronal injury: loading rate-dependent changes in acute cytosolic calcium and lactate dehydrogenase release

We developed a new in vitro model of neuronal injury using NT2-N cells to examine the effects of hydrodynamic loading rate on intraneuronal calcium dynamics and lactate dehydrogenase (LDH) release. Our apparatus consisted of a parallel disk viscometer which induced fluid shear stress with well-defined magnitudes and loading rates to cultured cells. We found that the deformation response of the cells was dependent on the severity of the insult, with increased cellular strains generated for higher shear stresses at a constant loading rate. Peak intracellular free calcium concentration correlated with strain, suggesting that mechanical deformation may regulate calcium response. Slowly applied fluid shear stress elicited no response, whereas high loading rates resulted in peak calcium increases 2.9 to 3.6 times baseline values as injury severity was increased. LDH release measured within 5 min after the insult correlated with loading rate. In addition, LDH release continued to increase out to 24 h following high loading rate conditions, demonstrating that the application of fluid shear stress led to prolonged cell damage. The acute response in NT2-N cells subjected to an insult with the CSID is dependent on the loading rate, and these results suggest that initial membrane deformation may trigger subsequent events.     

Interfacial reactions in the squeeze-cast (SAFFIL+C)/SAE 329 Al composite

Interfacial reactions in the squeeze-cast SAE 329 Al alloy reinforced with SAFFIL and carbon fibers were investigated using scanning and transmission electron microscopy and secondary ion mass spectroscopy. The SiO₂ layer added as a binder for the preform of SAFFIL fiber appeared to prevent excessive reaction between the fiber and the molten Al alloy during casting. In the as-cast composite, the reaction between the SiO₂ layer and the Al alloy is considered to produce MgO crystals in the vicinity of SAFFIL fiber. With subsequent heat treatment of the composite to the T6 condition, small crystals of MgO and MgAl₂O₄ were found to form at the surface of SAFFIL fiber as a result of interfacial reaction between the SiO₂ layer and the Al alloy. Even at the T6 condition, significant reactions between the Al alloy and SAFFIL fiber itself were not observed, indicating the effective role of the binder layer in suppressing the degradation of SAFFIL fiber by reaction with the Al alloy.     

A novel method for elimination of line-current harmonics insingle-stage PFC switching regulators

This paper studies a particular single-stage power-factor-correction (PFC) switching regulator employing a discontinuous-conduction-mode (DCM) boost-input cell and a continuous-current-mode (CCM) forward output cell. Although this single-stage PFC regulator can provide a reasonably high power factor when its PFC stage is operating in discontinuous mode, substantial reduction in line-current harmonics is possible by applying a suitable frequency-modulation scheme. This paper derives a frequency-modulation scheme and proposes a practical implementation using a simple translinear analog circuit. A quantitative analysis on the total harmonic distortion (THD) of the line current when the circuit is subject to a limited range of frequency variations is presented along with some considerations for practical design. Experimental data obtained from a prototype confirms the effectiveness of the proposed frequency-modulation scheme. The proposed analog translinear circuit allows custom integrated circuit implementation, making it a viable low-cost solution to the elimination of line-current harmonics in switching regulators     

Tomsk complex for neutron-transmutation doping of silicon

All-Union Scientific-Research Institute of Nuclear Physics at the S. M. Kirov Tomsk Polytechnical University. Translated from Atomnaya énergiya, Vol. 79, No. 1, pp. 38–40, July, 1995.