有杆泵抽油系统可靠性分析

抽油机井有杆果采油装置检泵故障数据的特点在于相邻两次检泵间隔之间的时间并非总是来自同一总体，可能有某种趋势的变化。通过对故障数据的趋势性检验，可验证其对某一随机过程模型的适应性，从而判定某一口井或某一批工况大致相同油井的运行可靠性，实现对生产井运行可靠性的定量评估。还通过实例说明了有杆泵抽油系统检泵故障数据的可靠性分析方法。     

线性规划模型的自动生成与求解

本文描述了《有色企业经济活动分析决策支持系统》模型库中线性规划模型的自动生成与求解系统的设计思想、方法及实现     

采用同调约束快速识别的有功校正控制计算

本文发展了文(5)提出的同调约束概念,将同调约束进一步分为正同调约束和反同调约束两组。文中提出了一种新的同调约束识别方法,不必增加任何计算便可快速识别出正反同调约束,显著地降低了解题规模。IEEE30节点样本网络的计算实例证实了本文方法的有效性。     

Monolithic SiGe Up‐/Down‐Conversion Mixers with Active Baluns

The purpose of this paper is to describe the implementation of monolithically matching circuits, interface circuits, and RF core circuits to the same substrate. We designed and fabricated on‐chip 1 to 6 GHz up‐conversion and 1 to 8 GHz down‐conversion mixers using a 0.8 µm SiGe hetero‐junction bipolar transistor (HBT) process technology. To fabricate a SiGe HBT, we used a reduced pressure chemical vapor deposition (RPCVD) system to grow a base epitaxial layer, and we adopted local oxidation of silicon (LOCOS) isolation to separate the device terminals. An up‐conversion mixer was implemented on‐chip using an intermediate frequency (IF) matching circuit, local oscillator (LO)/radio frequency (RF) wideband matching circuits, LO/IF input balun circuits, and an RF output balun circuit. The measured results of the fabricated up‐conversion mixer show a positive power conversion gain from 1 to 6 GHz and a bandwidth of about 4.5 GHz. Also, the down‐conversion mixer was implemented on‐chip using LO/RF wideband matching circuits, LO/RF input balun circuits, and an IF output balun circuit. The measured results of the fabricated down‐conversion mixer show a positive power conversion gain from 1 to 8 GHz and a bandwidth of about 4.5 GHz.     

Luminescence Characterization of Mg Doped Y2O2S:Ti Long Afterglow Phosphor

Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors with long afterglow were synthesized by solid state reaction route. The photoluminescence spectra, decay curves, thermoluminescent spectra and chromaticity coordinate curves were investigated. The results show that the luminescence intensity of Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors decrease gradually with increasing Mg2 ion content, and the shape of luminescence spectra and chromaticity coordinate change as well. Furthermore, two thermoluminescent peaks in single Ti-doped Y2O2S sample are found at 91.8 and 221.5 ℃, respectively. Nevertheless, significant different spectra were found for the Mg, Ti co-doped Y2O2S samples that three thermoluminescence peaks appear at 52.3, 141.7 and 226.8 ℃, respectively. These results indicate that the co-doped Mg ion changes the inherent trap depth of single Ti-doped Y2O2S:Ti phosphor, and induces simultaneously a new trap level in the Y1.94-xMgxO2S:0.06Ti phosphor. Based on the analysis of thermoluminescent spectra, photoluminescent spectra, decay curve and crystal structure defect, it was proposed that the varied structure defect and introduced new trap level by the doped Mg2 ions should be responsible for reducing luminescence intensity and varying color in the Y1.94-xMgxO2S:0.06Ti phosphor.     

JEC-FDTD for 2-D conducting cylinder coated by anisotropic magnetized plasma

The JE convolution finite-difference-time-domain (JEC-FDTD) method is extended to the anisotropic magnetized plasma which incorporates both anisotropy and frequency dispersion at the same time, enabling the transient solution of the electromagnetic wave propagation in anisotropic magnetized plasmas. Two-dimensional JEC-FDTD formulations for magnetized plasma are derived. The back scattering radar cross section (RCS) of a perfectly conducting cylinder coated by a layer of magnetized plasmas is calculated.     

Computational Implementation of Asymmetric Integral Imaging by Use of Two Crossed Lenticular Sheets

We propose an asymmetric integral imaging method to adjust the resolution and depth of a three‐dimensional image. Our method is obtained by use of two lenticular sheets with different pitches fabricated under the same F/#. The asymmetric integral imaging is the generalized version of integral imaging, including both conventional integral imaging and one‐dimensional integral imaging. We present experimental results to test and verify the performance of our method computationally.     

剂量率对聚四氟乙烯辐射裂解的影响

本文研究了在以电子加速器的电子射线为辐射源时,剂量率对PTFE辐射裂解的影响。在剂量相同的条件下,剂量率从1.44×10~4 rad/s增至5.75×10~4 rad/s,裂解效率提高3.3倍。剂量率和各断裂参数(单位剂量裂解度a_0,G(s)值等)均成线性关系。当裂解度一定时,剂量率与剂量成反变关系。     

冲击回波法检测隧洞混凝土衬砌厚度

冲击回波法是通过接收、分析在混凝土中传播的回波信号，判断结构混凝土厚度和内部质量的新型无损检测技术。室内试验和工程应用研究表明，该方法为隧洞混凝土衬砌厚度检测提供了一个有效的测试手段。     

A Silicon–Silica Nanocomposite Material

The synthesis and characterization of a novel silicon–silica nanocomposite material are reported. A self‐assembly method allows the encapsulation of silicon nanoclusters within the channels of a periodic mesoporous silica thin film. The result is the formation of a silicon–silica nanocomposite film with bright, room‐temperature photoluminescence in the visible range, and a nanosecond luminescence lifetime. The properties of the nanocomposite material have been studied by several analytical techniques, which collectively show the existence within the channels of non‐diamondoid‐structure‐type silicon nanoclusters with various hydrogenated silicon sites. It is estimated that the silicon nanoclusters in the silica mesoporous films occupy up to 39 % of the accessible pore volume. The nanocomposite film shows improved resistance to air oxidation compared to crystalline silicon. The high loading and chemical stability to oxidation under ambient conditions are important advantages in terms of the development of silicon‐based light‐emitting diodes from this class of materials.