浅谈矿产开采类项目水土流失的特点及防治对策

结合水土保持方案编制实践,分析矿产开采类项目建设和生产过程中产生水土流失的特点,主要有扰动和破坏地表面积大、水土流失防治难度大、弃土弃渣现象普遍、临时防护不到位等,造成矿区生态恶化。针对该类项目水土流失的特点确定综合的防治对策,为防治该类建设项目水土流失提供参考。     

Degradation of cyanuric acid in soil by Pseudomonas sp. NRRL B-12227 using bioremediation with self-immobilization system

The rates of degradation of cyanuric acid, a key intermediate in a metabolic pathway of s-triazine herbicides, were measured for Pseudomonas sp. NRRL B-12227. The rate of degradation was affected by the rate of cyanuric acid transport through cell membranes and the activity of cyanuric acid amidohydrolase inside the cells. At low concentrations of cyanuric acid, the acclimation of cells to cyanuric acid and/or added nutrients effectively enhanced the degradation rate. The strain was also applied to bioremediation using a Bioremediation with Self-Immobilization System (BSIS), in which Pseudomonas sp. NRRL B-12227 cells were co-immobilized with Bacillus subtilis, the latter of which secretes a viscous polymer, in a shallow layer of soil packed in a column. More than 70% of the Pseudomonas sp. NRRL B-12227 cells were co-immobilized with the B. subtilis in a 7.5 cm layer of the packed soil by self-aggregation. More than 60% of the 1 mM cyanuric acid supplied to the packed soil was degraded in this layer during a 72 h period.     

Effect of light intensity and frequency of flashing light from blue light emitting diodes on astaxanthin production by Haematococcus pluvialis

Flashing light from blue light emitting diodes is an effective method for the reduction of energy consumption in the bioproduction of astaxanthin by Haematococcus pluvialis. We investigated the effects of light intensity and frequency on the final astaxanthin concentration in bioproduction by H. pluvialis grown mixotrophically. The final astaxanthin concentration under illumination with flashing light, with frequencies ranging from 25 to 200 Hz, was dependent on the light intensity and on the duty cycle and was equivalent, or higher, in comparison with that under illumination with continuous light at the same incident intensity. The light intensity determined the maximum attainable concentration of astaxanthin under continuous illumination. Under illumination with flashing light, the ratio of the final astaxanthin concentration to the maximum concentration at a specific light intensity was correlated to the duty cycle in the frequency range from 25 to 200 Hz. The effect of lower frequencies on enhanced astaxanthin production under flashing light was also studied; at levels as low as 1 Hz, higher final astaxanthin concentrations were observed under flashing light compared to concentrations attained under continuous light.     

Correlation of reactivity to hydrogenation and chemical structure of lignites

Three North Dakota lignites with almost the same percentage carbon have been used to determine the relation between chemical structure and reactivity to hydrogenation. Average structural indices of the lignites were estimated using the pyridine-soluble products after alcohol-alkali treatment, the structural indices obtained at various reaction times being extrapolated to zero reaction time. Hydrogenation was influenced by the average structure, with the lignite having higher aromaticity, higher molecular weight of the pyridine extract from the alcohol-alkali reaction product, larger aromatic ring size and lower content of aliphatic structure, showing a smaller degree of conversion.     

常压蒸馏装置有效能分析探讨

应用了有效能概念 ,把用能过程分成 3个环节 (即能量转化和传输环节、工艺利用环节与能量回收环节 ) ,对南京炼油厂三套常压蒸馏装置的初馏塔、常压炉、常压塔、冷换设备和机泵设备的能量利用进行了计算、分析和探讨。能量及有效能计算的结果 ,用能流图和有效能流图表示 ,确定有效能损失的主要部位 ,并提出进一步节能的方向和措施。     

JSFR key technology evaluation on fuel handling system

A simplified fuel handling system design for the demonstration Japan sodium-cooled fast reactor (JSFR) has been proposed. Fast Reactor Cycle Technology Development project phase I results of key technology evaluations on a pantograph fuel handling machine (FHM), a fuel transfer pot with two core component positions, dry spent fuel cleaning and minor actinide-bearing fresh fuel shipping cask are summarized. A full-scale FHM mockup has been fabricated and tested in the air accumulating performance and seismic tolerance data. A mockup fuel transfer pot with fins and chromium carbide coating has been fabricated and tested with sodium accumulating heat transfer performance data. Several sodium cleaning tests using a dummy subassembly has been conducted accumulating cleaning performance data. For fresh fuel shipping cask, a design tool for evaluation of heat transfer capability has been developed and a helium gas cask shows cooling capability of minor actinide-bearing fresh fuel. Those experimental and analytical efforts have shown that key technologies to develop simplified fuel handling system are matured enough to proceed large-scale sodium experiments and conceptual design study for the demonstration JSFR.     

The effect of neutron irradiation on the fiber/matrix interphase of silicon carbide composites

Given the good stability of mechanical properties of silicon carbide (SiC) under neutron irradiation, the ultimate irradiation tolerance of SiC composite materials may be limited by the fiber/matrix interphase, which is critically important to the performance of these composites. This study investigates the irradiation stability of pyrolytic carbon (PyC) monolayer and PyC/SiC multilayer interphases by tensile and single fiber push-out test techniques. Neutron irradiation was performed to doses of 0.7-7.7 dpa at temperatures from 380 to 1080 °C. Both interfacial debond shear strength and interfacial friction stress apparently decrease by irradiation, although this is not so dramatic when T_irr < 1000 °C. In contrast, the interfacial shear stresses are most affected by the higher temperature irradiation (>1000 °C). Noteworthy, these irradiation effects depend on the type of interphase material, i.e., for the pyrolytic carbon or multilayer SiC variants studied. In the range of irradiation temperature and dose, the degradation in interfacial shear properties, while measurable, is not of a magnitude to degrade the mechanical performance of the composites. This was observed for both interphase types studied. In particular, the proportional limit tensile stress decreases slightly by irradiation while the tensile fracture strength undergoes very minor change.     

Morphologic analysis of the facet joint in the immature lumbosacral spine with special reference to spondylolysis

STUDY DESIGN: Morphological analysis was performed of the facet joint of the normal and spondylolytic lumbosacral spine in children and adolescents. OBJECTIVES: This study was performed to estimate the influence of spondylolysis on growth of the neural arch of the lumbosacral spine. SUMMARY OF BACKGROUND DATA: The development of the facet joint and its relation to spondylolysis have not been documented in the literature. METHODS: The dimension and orientation of the facet joint at L5/S were measured on radiographs and computed tomography scans from 144 boys without pars defects and 104 boys with pars defects. The latter group was further investigated according to the stage of pars defects. Patients in both groups were between 9 and 18 years of age. RESULTS: Growth of the facet joint in the sagittal and transverse directions and the increase of the transverse angle were remarkable up to approximately 13 years of age. Concavity of the facet joints also progressed in children of the same age. The growth of the facet joint in patients with spondylolysis was significantly retarded as the pars defects advanced from the progressive to the terminal stage. The joint surface was more coronal in orientation and flatter in shape compared with controls. CONCLUSIONS: The present results suggest that pars defects occurring in children disturb or retard the growth of the facet joint and that the morphological characteristics of the joint surfaces in patients with spondylolysis are the consequence of these defects.     

A case report on surgery for chylothorax after anterior spinal fusion: usefulness and effectiveness of intraoperative milk administration and postoperative OK-432 administration]

After having reported preliminary results of soft system stabilization according to Graf in a series of 27 patients with degenerative disc disease of the lumbar spine in early 1995 the authors report long term clinical and radiological results of this patient series (n = 25). At a mean period of postoperative observation of 50 months excellent, good, satisfactory, moderate and poor results were obtained in 62, 9%, 11, 1% and 11, 1%, 7, 4% and 7, 4% of the patients, respectively. The well-known phenomenon of loss of disc height at the level of posterolateral fusion and instrumentation as well as overcharge of adjacent segments were not observed after soft system stabilization. Regional as well as global lumbar lordosis were maintained and, although statistically not significant, an increase of intervertebral distance was observed in adjacent segments in flexion of the lumbar spine. These phenomena might represent pressurization of instrumented as well as adjacent discs after the insertion of ligament prostheses. It is the impression of the authors, that the Graf technique leads to good surgical results in degenerative disc disease with destabilization of lumbar motion segment(s) if the following criteria are strictly respected: 1. No or only mild arthrotic changes of the facet joints 2. Preferably minor disc degeneration/only mild loss of intervertebral distance. 3. Well trained low back muscles and 4. A clear-cut, repeatedly demonstrated pain-relief on trial anaesthesia of the corresponding articular nerves and while wearing a probatory jacket.     

Overproduction of Mpd2p suppresses the lethality of protein disulfide isomerase depletion in a CXXC sequence dependent manner

The third multicopy suppressor gene of the PDI1 deletion from Saccharomyces cerevisiae, MPD2, was isolated and characterized. The MPD2 gene encodes a protein with a putative signal sequence, ER retention signal, and a disulfide isomerase active site like sequence. The amino acid sequence around the active site like sequence is similar to the thioredoxin-like domains of PDI and PDI related proteins, although the similarity is comparatively low. A delta-pdi1 strain over-producing Mpd2p showed slow growth and was sensitive to 1 mM dithiothreitol. Mpd2p can be detected in wild type cells and is a glycoprotein. Although the MPD2 gene was not essential for growth, overexpression of the gene partially restored the maturation defect of carboxypeptidase Y caused by the PDI1 deletion. Mutagenesis analysis revealed that Mpd2p can compensate for the loss of PDI with its CXXC sequence.