砖烟囱集团装药定向爆破拆除

对一座 40 m 高的砖烟囱,采用TNT集团装药实施定向倒塌拆除爆破.介绍了该烟囱拆除爆破工艺技术,爆破参数和施工方法.     

Preparation and optical properties of CdxHg1-xTe doped silica glass

In this paper, the Cd_xHg_1-xTe (x=1-0.7) doped silica glass was prepared through two step sol-gel process and in-situ growth technique from tetraethoxysilane (TEOS), cadmium acetate, mercury acetate and telluric acid. The influence of various factors on the glass was studied. The structure of the microcrystals was investigated by XRD. The absorption and transmittance spectrum of the composite showed that the shift of absorption edge was in conformity with the quantum size effect. The third-order nonlinear optical susceptibility χ⁽³⁾ was measured by the degenerate four wave mixing (DFWM). The values of χ⁽³⁾ was in the range of 10^-11-10^-12 MO esu at wavelength of 1.06 μm.     

Structural trends and dielectric properties of Bi-based pyrochlores

The crystal structure and dielectric properties of Bi-based pyrochlore ceramics with formula Bi_1.5ZnM_1.5O₇ (M=Nb, Ta or Sb) were investigated. The three composition ceramics crystallize in the same pyrochlore structure, but the lattice parameters decrease with decreasing B-site ionic radius. Raman spectra analyses were performed to look for short-range structural differences and indicate that the Ta and Sb incorporation into B-site induce the A-site cations array to be more disordered. Ta or Sb replacing Nb lead to smaller dielectric constant and higher temperature coefficient values. The common characteristics for the three compositions are that they have rather low dielectric loss and high resistivity. The dielectric behavior with temperature for BZS and BZT samples were more flat than that of the BZN ceramics. Dielectric abnormal behavior at high temperature for all samples is typically associated with losses by conduction.     

具有复合埋层的新型SIMON材料的制备

采用氮氧共注入方法制备了新型的 SIMON(separation by implanted oxygen and nitrogen) SOI材料 .采用不同的制备方法分别制作出样品并进行了结构测试和分析 ,发现 SIMON材料的结构和质量对注入条件和退火工艺非常敏感 .并对各种氮氧复合注入技术做了分析和比较 ,发现氮氧分次注入可以得到更好的结构和性能     

FBOLES—outline of a frequency-based on-line expert system approach for fault diagnoses in nuclear power plants

The basic concept of a novel frequency-based on-line expert system (FBOLES) approach for on-line fault diagnoses in nuclear power plants has been presented previously. This paper reports further progress, and includes how to express the uncertainties of expert opinion in knowledge-bases and propagate then in inferences, and how to deal with imperfect knowledge-bases. It also describes the main elements of FBOLES and outlines how the system works under complex conditions including the dynamic behavior of signals during accidents, multiple failures, and on-line changes of plant operation mode. Its ability to diagnose root causes of accidents has been tested using the main steam and feedwater condensate systems of a full-scale, three-loop, 950 MW nuclear power plant simulated by the Tsinghua simulator. So far the results seem good.     

Using thermally stimulated currents to find defective capacitors

BaTiO₃ multilayer capacitors with a nominal capacitance of 3.5nF have been carefully measured using the thermally stimulated current (TSC) technique. When a 300V polarization voltage is applied at room temperature, a new TSC peak appeared in defective sample A after it has been immersed in water. No new peak was found in good-quality sample B after a similar treatment. The accelerated life test shows that sample A hasa much shorter life than sample B in terms of insulation resistance.     

日本“绿色”包装的系统化理念及其启示

本文通过对日本包装系统的考察和与中国包装现状的对比,阐述了“绿色”包装系统的基本理念和构建要素,总结出必须通过科技、法制等使包装产业形成一个系统化的“生态链”,使包装业真正造福于人类。     

Ti 离子注入 LiNbO_3表面光学性能

本文研究了 x,y,z 三种切向的 LiNbO_3单晶片注入350keV 高能 Ti 离子(注入剂量为1.5×10~(17)/cm~2)后的表面光学性能。利用光谱仪及 AUEL 椭偏仪对三种切向 LiNbO_3试样在不同工艺处理后的光透射率及折射率进行了测试。注入损伤造成的光损耗可通过热处理消除,使晶格结构恢复至与完整晶格排列相近;注入层的折射率可增加11—13％左右。     

胶溶法合成 TiO_2超微粒子

用胶溶法合成了 TiO_2超微粒子。研究了反应物浓度、胶溶剂用量、胶溶温度对胶溶过程的影响,以及表面活性剂 DBS 的量与 Ti 萃取率的关系。探讨了合成超微粒子 TiO_2的最佳条件,分析了产品的特性。200℃热处理得到的产品为非晶型圆球状,粒度均匀,平均6.0nm,在许多有机溶剂中具有良好的分散性和透明性。550℃得到晶态锐钛矿型超微粒子 TiO_2,粒度为8.5nm。700℃热处理得到金红石型TiO_2,粒度为33.2nm。     

地震属性神经网络油气模式识别技术及其在东海的应用

神经网络油气模式识别技术是综合利用地震属性进行油气预测的技术之一 ,它首先通过计算获得多种地震属性 ,综合分析找出对储层油气比较敏感的地震属性组合 ;然后收集油气井与非油气井的井旁道地震属性 ,组成学习样本并进行神经网络学习 ;最后利用学习结果对储层进行油气预测。该技术在东海某工区的应用结果表明 ,振幅统计类和复数道统计类地震属性是对该地区储层油气最敏感的地震属性组合。神经网络油气模式识别技术可以作为东海地区储层油气预测的一种手段。