码头建筑物对水位影响的模型试验及计算方法

河岸码头建筑物势必导致其上游水位壅高及对码头附近水流流态产生影响。以汉江沙洋河段为对象 ,通过定床概化物理模型试验研究了码头建筑物对河道水位与流速场的影响。并基于能量平衡原理 ,采用河道恒定非均匀流水面曲线基本方程 ,结合物理模型试验资料 ,计算了码头建筑物附近的水位变化值 ,并提出了码头建筑物产生的水位壅高值的计算方法。     

纯镍材料焊接工艺优化

1　引言纯镍是在工业生产中各种苛刻腐蚀环境下采用的金属材料。鉴于石油化工生产过程中高温、高压和介质强腐蚀性的特点 ,石油化工装置设备选材的要求很高 ,烧碱装置的关键设备碱蒸发器就是采用纯镍制造的。我国石化行业烧碱装置的碱蒸发器过去基本是随装置从国外引进的 ,近年来 ,该设备已初步进行国产化。由于碱蒸发器的制造涉及到纯镍材料的焊接 ,因此 ,如何对纯镍材料进行焊接工艺优化 ,成为保证设备制造质量的关键。由于纯镍材料本身固有的物理、化学特性 ,在焊接过程中极易出现裂纹、气孔及晶粒粗大等缺陷 ,严重影响到设备的制造质量…     

宽带抽运情况下乙醇、丙酮溶液中受激拉曼散射光谱的实验研究

研究了乙醇、丙酮两种拉曼介质在宽带抽运情况下啁啾激光脉冲的受激拉曼散射频谱特性 ,得到的一级Stokes光频谱宽度与抽运光基本相当 ,且具有较高的转换效率 ,从而表明了利用“展宽—受激拉曼散射—压缩”的办法获得波长近 1μm的飞秒级超短脉冲激光信号源的实验方案具有可行性     

Modeling of the bulk free radical polymerization up to high conversion—three stage polymerization model. II. Number-average molecular weight and apparent initiator efficiency

The equations for predicting the number-average molecular weight are derived on the basis of the three stage polymerization model (TSPM) in this paper. By applying the equations, a plotting approach is proposed to determine the apparent initiator efficiency defined as f[(α_td+1)/2] and the constant of chain transfer to monomer, where f is the initiator efficiency and α_td denotes the fraction of the termination rate constants by disproportionation. Using the approach to plot the experimental data in the literature, it is found that the chain transfer to monomer can be neglected for both methylmethacrylate (MMA) and styrene (St) polymerizations, but it can exert a significant effect on ethylmethacrylate (EMA) polymerization. In addition, the apparent initiator efficiency is found to be independent of reaction temperature and initiator concentration at each stage. The values of f[(α_td+1)/2] at gel effect stage are slightly reduced as compared with that at low conversion stage for MMA and EMA polymerizations. However, it decreases significantly at gel effect stage for St polymerization. Using the equations derived and the apparent initiator efficiencies obtained from TSPM plots, the number-average molecular weights at different conversions can be predicted. Comparisons show that the agreement between predictions and experimental data is satisfactory.     

Peripheral noxious stimulation induces CREM expression in dorsal horn: involvement of glutamate

Thermal washout curves have been proposed as noninvasive tools for analysing lower airway dimensions and pulmonary blood flow, but how upper airway heat transfer affects these washout curves is unclear. The present study was designed to compare extrathoracic and tracheobronchial contributions to thermal washout curves. Respiratory frequency, air ambient temperature, and body core temperature (tc) were varied in six male subjects before and after immersion in cold (1.1 degrees C) water for up to 2 h under three conditions: 1) control: ambient temperature (tamb) = 25 degrees C, rectal temperature change (delta tre) = 0 degrees C; 2) pre-immersion: tamb = 4 degrees C, delta tre = 0 degrees C; and 3) post-immersion: tamb = 25 degrees C, delta tre = -0.7 degrees C. Both peak expiratory nasal (tpn) and oral (tpo) airstream temperatures were measured. Each subject was tested twice. Expiratory tpo was generally higher than tpn in all conditions. Increasing breathing rates lowered tpn and tpo in the control and cold air environments. Orifice temperatures, which are presumed to reflect upper airway blood temperatures, correlated with both tpn and tpo. Lowering tc had no effect on washout curves during quiet breathing and affected only tpn during rapid breathing. The results suggest that while tracheobronchial conditions may contribute to thermal washout curves, extrathoracic conditions predominate. Strong correlations between orifice temperatures, peak expiratory nasal temperatures and peak expiratory oral temperature demonstrate the dominant role of upper airway heat exchange in determining thermal washout curves.     

板式换热器热端跑冷问题的分析及处理

１００００ｍ３／ｈ制氧机板式换热器损坏修复后，热端跑冷严重，氧气取出量不足，制氧机工况恶化，通过分析找出了原因是因某单元氧通道堵塞，并采取了处理措施。     

高含硫钻井液缓蚀剂的合成及性能研究

本文合成了抑制H₂S腐蚀的咪唑啉类缓蚀剂,并研究了它们的性能。正交试验表明,最佳合成条件是:反应温度:190～200℃;酸:胺(mol比)=1:1.05;反应时间以3～5小时为宜。根据以上条件合成的缓蚀剂,在含有3200mg/lH₂S的泥浆中,用量为0.2%时,抑制效果能达到80～90%,与碱式碳酸锌复配使用时,能提高缓蚀效率和降低碱式碳酸锌的用量,并发现缓蚀剂与CaO之间具有明显的协同效应。泥浆流变性能试验表明,缓蚀剂能提高泥浆的动切力和动塑比,对失水量影响不大。此外,利用X-射线衍射试验证明:(1)低碳钢在含H₂S的泥浆中,腐蚀产物的主要组成为Fe₉S₆;(2)H₂S会破坏FCLS的稳定性,分解出Fe²⁺,与H₂S反应生成面心立方的Fe₂S₄。     

Exploratory analysis of brain connectivity with ICA.

Covariance-based methods of exploration of functional connectivity of the brain from functional magnetic resonance imaging (fMRI) experiments, such as principal component analysis (PCA) and structural equation modeling (SEM), require a priori knowledge such as an anatomical model to infer functional connectivity. In this research, a hybrid method, combining independent component analysis (ICA) and SEM, which is capable of deriving functional connectivity in an exploratory manner without the need of a prior model is introduced. The spatial ICA (SICA) derives independent neural systems or sources involved in task-related brain activation, while an automated method based on the SEM finds the structure of the connectivity among the elements in independent neural systems. Unlike second-order approaches used in earlier studies, the task-related neural systems derived from the ICA provide brain connectivity in the complete statistical sense. The use and efficacy of this approach is illustrated on two fMRI datasets obtained from a visual task and a language reading task.     

论GPS星座组成及若干抗AS方案

本文首先讨论GPS星座组成及美国的用政策，阐述了AS措施及其对GPS测量的影响。然后，对抗AS的若干方案进行介绍，分别对平方法、互相关法、码相关干法及P－W技术（Ashtech法）进行叙述和评论，指出它们的优缺点，评述它们在GPS技术发展过程所起的作用。最后，对GPS星座建成后的形势作了小结，并对当前我国GPS事业的有关问题提出四点建议。