砂浆立方体抗压强度与底模的关系

建筑砂浆试件的制作目前均执行《建筑砂浆基本性能试验方法》(JGJ70-1990)有关规定，所用底模系含水量不大于2％的普通粘土砖。     

钢筋混凝土结构内的钢筋腐蚀监测

用钢筋混凝土修建的建筑物和构筑物，因受外界因素的影响，其内部钢筋可能会受到腐蚀而生锈，锈蚀严重者将危及安全。根据钢筋在混凝土内的锈蚀是一个电化学过程的特点，在不损伤钢筋混凝土结构的条件下，利用腐蚀监测仪，测量钢筋混凝的电化学特性值，并以此特性值绘制等值线图，利用该图能正确评估混凝土内钢筋受腐蚀的情况。     

青城子矿田小佟家堡子金银矿床地质特征及成矿物质来源探讨

小佟家堡子金银矿床赋存在辽河群大石桥组PtLd^5 3和PtLd^4 3的互层带之中。矿体受层间滑脱构造控制。容矿岩石以自云石大理岩和硅质岩为主，矿体呈层就、似层就。矿石中的金以不可见金为主，金古量与毒砂关系最密切。成矿物质来源于地层——即海底火山喷气和喷流作用形成含矿热卤水，经运移在海盆边缘沉积形成矿源层或维集区，经区域变质作用和岩浆作用的改造，在印支期就位。矿床成因类型为同生沉积-变质一岩浆热液叠加再造型金银矿床。     

Optimal phases for a family of quadriphase CDMA sequences

Signature sequences with good even even and odd (or polyphase) correlations are crucial for asynchronous code-division multiple access (CDMA). When the data sequence is random, the even and odd (or polyphase) correlations are equally important. However, for most known signature sequences, only their even correlations were analyzed. It appears that determining the odd (or the polyphase) correlations is generally a very hard problem since the odd (or the polyphase) correlations depend on the phases of the signature sequences. Sole (1989), Boztas, Hammons, and Kumar (1992) found a family of quadriphase sequences that are asymptotically optimal. These sequences gain a factor √2 in terms of their maximum periodic even correlations when compared with the best possible binary phase-shift keying (BPSK) sequences. We find the optimal phases of these sequences. The optimality is in the sense that at these phases, the mean square values of the even, odd, and the polyphase correlations are minimal, and achieve the Welch (1974) bound-equality simultaneously. Furthermore, we show that at these phases, the average user interference of these sequences is always smaller than that of the ideal random signature sequences. Comprehensive analytical and numerical results show that good phase sequences can offer a nonnegligible amount of gain over bad phase sequences at modest and high signal-to-noise ratios     

校园IC卡系统设计与管理信息系统

本文通过一个实际的IC卡应用系统一校园IC卡系统的设计与实现过程，给出了开发研制IC卡应用系统的基本方法．本文还对校园IC卡管理信息系统作了介绍．该系统的管理软件采用数据库语言FoxProforWindows编写，具有人机界面友好直观、多画面、多窗口、安全可靠等特点．     

Chaotic frequency hopping sequences

This letter describes a novel family of frequency hopping sequences generated by chaotic systems. The sequences give a uniform spread over the entire frequency bandwidth. In addition to having good Hamming correlation properties, they possess ideal linear span. The sequences produce almost as good performance as random hopping patterns when used in frequency hopping code-division multiple-access (FH/CDMA) systems. Many numerical examples based on a digital chaos generator are presented     

拼接式彩色等离子体大屏幕显示驱动电路的研究

针对拼接结构的高分辨率彩色等离子体大屏幕系统的应用，指出了刷新型电路模式的不足之处，提出了一种混合型模式的驱动电路。从彩色模块ＡＣＰＤＰ的结构特性出发，详细讨论了该电路的工作原理，驱动波形以及放电过程。     

精确定位物方焦面位置的简便方法

提出一种利用细激光束和全息光栅精确定位光学系统物方焦平面位置的方法，可用于光学傅里叶交换、光学信息处理系统的调整。其优点是所用光学元件少，操作简便。     

SIR-C data quality and calibration results

The SIR-C/X-SAR imaging radar took its first flight on the Space Shuttle Endeavour in April 1994 and flew for a second time in October 1994. This multifrequency radar has fully polarimetric capability at L- and C-band, and a single polarization at X-band (X-SAR). The Endeavour missions were designated the Space Radar Laboratory-1 (SRL-1) and -2 (SRL-2). Calibration of polarimetric L- and C-band data for all the different modes SIR-C offers is an especially complicated problem. The solution involves extensive analysis of pre-flight test data to come up with a model of the system, analysis of in-flight test data to determine the antenna pattern and gains of the system during operation, and analysis of data from over fourteen calibration sites distributed around the SIR-C/X-SAR orbit track. The SRL missions were the first time a multifrequency polarimetric imaging radar employing a phased array antenna has been flown in space. Calibration of SIR-C data products involved some unique technical problems given the complexity of the radar system. In this paper, the approach adopted for calibration of SIR-C data is described and the calibration performance of the data products is presented     

新型耐磨蚀铸造高铬钢的研制

本文设计了用于含有磨粒的强酸介质的新型耐磨蚀钢的化学成分，采用金相显微镜、Ｘ射线衍射、扫描电子显微镜、腐蚀与磨蚀试验等方法，观察与分析了钢的显微组织与磨蚀形貌，研究了新型铸造高铬钢的性能，并对其磨蚀机理进行了较为深入的探讨。试验结果表明，较高的含铬量和含碳量与适量的钼、铜的复合使用，使新型高铬钢具有比高合金化的ＺＳ２８合金更好的抗磨蚀性能，而且成本比较低，具有广阔的应用前景。