A modified transverse resonance method for the analysis ofmultilayered, multiconductor quasiplanar structures with finiteconductor thickness and mounting grooves

A modified transverse resonance method is presented for analyzing generalized multilayered, multiconductor quasiplanar structures with practical parameters such as finite conductor thickness and mounting grooves. Recurrence relations are obtained by using network theory for obtaining the overall transverse equivalent network. while the discontinuity involving the finite-thickness metal sheet and mounting groove is carried out by a field-theory-based multimodal variational formulation. The frequency behaviors of propagating, evanescent, and complex modes are obtained for several commonly used quasiplanar lines, showing good agreement with published results. Furthermore, a leaky-wave study is carried out for open structures, since the open condition can be included in this formulation without difficulties     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

矩形光脉冲光电响应后沿拖曳性状研究

本文对矩形光脉冲光电响应后沿拖曳的形成机制进行了详尽的实验研究和理论分析，认为形成该光电响应时滞后曳的主要根源在于光生电子与空穴的多声子慢态复合．我们给出了削减后沿拖曳、提高光电响应速度的有效措施，从而促进解决宽带光通讯的速度瓶颈问题．     

北京谱仪端盖簇射计数器工作气体的研究

为使北京谱仪端盖族射计数器更好地工作在自猝灭流光ＳＱＳ模式下，提高其能量分辨以及线性等指标，用Ａｒ，ＣＯ２，Ｌｓｏｂｕｔａｎｅ三元工作气体对探测器的工作性能进行了仔细研究，找出了一适合于主雇地数器的工作气体，此外，还研究了异丁的纯度对探测器性能的影响。     

Non-destructive evaluation of residual stresses in thin films via x-ray diffraction topography methods

Quantitative x-ray diffraction topography techniques have been used to measure the residual strain magnitude and uniformity of deposition for Mo and W sputtered films on Si(100) substrates. High sensitivity rocking curve measurements were able to determine differential strains for films as thin as 2.5 nm; while Bragg angle contour mapping had similar sensitivity and was also able to assess coating uniformity and stress distribution over areas covering a whole wafer. Measurements of strain versus film thickness over a range of 2.5 nm to 80 nm showed that a critical thickness exists for maximum residual strain. Growth beyond this range produces stress relaxation. This non-destructive type of analysis could be employed on a wide range of film-substrate combinations.     

辐射制备缓释抗癌药阿糖胞苷的研究

报告了甲基丙烯酸酯类在室温下进行辐射聚合制备缓释抗癌药阿糖胞苷（Ａｒａ－Ｃ）的研究结果。结果表明，不仅亲水性单体，而且疏水性单体（包括ＭＭＡ、ＥＭＡ和ＢＭＡ等）都可用于辐射固化。加入到亲水性基质中的疏水性单体可以延缓药物的离体释放，其顺序是ＭＭＡ＜ＥＭＡ＜ＢＭＡ，央ＭＭＡ－ＨＥＭＡ共聚物中，Ａｒａ－Ｃ释放率随着基质中的ＭＭＡ含量增加而降低。药物的离体释放还受许多困素的控制，结果显示：药物释放量随着     

3mm波段极近距离雷达

提出一种极近距离雷达概念，并导出其作用距离公式，在此基础上研制出一台３ｍｍ波段极近距离多普勒雷达样机．试验结果表明该雷达结构简单，成本低廉，在作用距离为零点几米至几米范围内可获得较高的定距精度．     

静态水热脱铝处理对HZSM-5分子筛的结构、酸性和催化性能的影响

开发了一种静态水热脱铝的方法。HZSM-5经此法处理后,正戊烷的裂解活性增加,脱氢和芳构化性能加强。可用改变处理温度的方法来控制脱铝的程度。用XRD和吡啶吸附红外技术进行了研究。HZSM-5分子筛催化剂性能的变化用非骨架铝产生的强L酸中心来解释。     

空分设备的酸性腐蚀及预防

以切换式换热器空分设备为例 ,分析了空分设备酸性腐蚀的原因、可能造成的危害 ,提出了预防措施。     

Ka-band solid-state pulsed Gunn oscillator and power combiner

GaAs Gunn diodes were fabricated for pulse source application at 8 mm wave band and operated with pulsewidths of 0.05 to 2.0 microseconds and duty cycles of 0.001 to 0.01. Peak pulse output power levels of 0.8–1.2W are achieved and the maximum available power is 1.6W with the highest efficiency of 6.5 percent. A simple and compact pulsed power combiner is also given in this paper.