Restoration of masonry facades, renders and final coats in a severe climate

The restoration of relatively old masonry buildings, 1870-1920, represents about 119930 flats and offices in the 4-5 largest cities in Norway. Driving rain and a severe climate are the key factors for deterioration. The paper describes a case study at the city campus of the University of Oslo.     

Development of a distributed sensing technique using Brillouinscattering

This paper reviews the developments of a distributed strain and temperature sensing technique that uses Brillouin scattering in single-mode optical fibers. This technique is based on strain- and temperature-induced changes in the Brillouin frequency shift. Several approaches for measuring the weak Brillouin line are compared     

Analysis and design-optimization of LCC resonant inverter forhigh-frequency AC distributed power system

The analysis and design of an LCC resonant inverter for a 20 kHz AC distributed power system are presented. Several resonant converter topologies are assessed to determine their suitability for high efficiency power conversion, under resistive and reactive loads. Two LCC-resonant inverter designs were implemented. One with all switches operating with zero voltage switching (ZVS), and another with two switches operating with ZVS and two switches with zero current switching (ZCS). The experimental results are presented along with a performance comparison of the two versions     

Transmission distance of in-line amplifier systems withgroup-velocity-dispersion compensation

Group-velocity dispersion (GVD) compensation in in-line amplifier systems is evaluated from the viewpoint of improving the transmission distance. The nonlinear Schrodinger equation, which simulates signal propagation in optical fibers, is numerically evaluated to clarify the optimum configuration for GVD compensation. It is shown that the optimum amount of GVD compensation is about 100% of the GVD experienced by the transmitted signal. The optimum compensation interval is found to be a function of the bit rate, signal power, and dispersion parameter. For dispersion parameter values ranging from about -0.1 ps/nm/km to -10 ps/nm/km, and an amplifier noise figure of about 6 dB, the optimum compensation configuration can eliminate the GVD from in-line amplifier systems, thus improving transmission distances to those limited by self-phase modulation and higher-order GVD     

Sensitivity of torsional stress predictions of diesel generatorsets to critical parameter values

In the present paper a new method is presented for the evaluation of torsional stressing of diesel-generator sets consisting of components with uncertain torsional characteristics. A frequency scanning technique is implemented for eigenvalue analysis of the elastic system. Due to the uncertainty of the values of stiffness and damping coefficients, a sensitivity analysis method is also presented, suitable for the evaluation of the range of the mechanical stresses. Special consideration is given to the correct simulation of the coupling to the electric network, including the influence of generator regulators and possible network interactions. An exact formula is extracted for the synchronizing and damping torque coefficients. The method presented was checked in a diesel power station of the autonomous electric system of a Greek island     

A capacitor-based device for the measurement of shaft torque

This paper describes a capacitor technique for the measurement of torque in a rotating shaft. The passive rotating part incorporates a capacitor bridge which is connected capacitively to the static part. This device is simple in operation and is relatively easy to manufacture     

Effective scattering area of a three-faced corner cube reflector

Ray representations are used to refine a model for the equivalent aperture of a three-faced corner-cube reflector in which the faces are not perpendicular. This is used in calculating the actual value of the effective scattering area for such a reflector, which gives a correction factor to exclude the error component due to the nonperpendicularity. A table is given of calculated values for the correction factor together with experimental results. Translated from Izmeritel'naya Tekhnika, No. 10, pp. 45–48, October, 1996.