Using ion implantation to adjust the transition temperature of superconducting films

We summarize a continuing investigation into using ion implantation to alter the transition temperature of superconducting thin films. The primary motivation for the work presented here was to study the feasibility of using magnetic ion doping to replace the bi-layer T_c control process currently used for certain cryogenic detector applications at National Institute for Standards and Technology. The results from work with various ion species implanted into aluminum, molybdenum, titanium and tungsten host films are presented.     

Synthesis and Properties of NdMCr2O5 (M = Na, K, Cs) and NdMgCr2O5.5 Chromites

NdMCr₂O₅ (M = Na, K, Cs) and NdMgCr₂O_5.5 are prepared by solid-state reactions between appropriate oxides and carbonates and are shown to have a tetragonal structure. The heat capacity of these chromites, measured from 298.15 to 673 K, exhibits sharp changes attributable to second-order phase transitions. The C _p ⁰(T) data are represented by quadratic best fit equations. The electrical resistivity of the chromites is measured between 303 and 493 K. The results attest to semiconducting behavior of the materials in certain temperature ranges.     

Preparation and Properties of Er- and Yb-Activated TeO2–WO3 Glasses

TeO₂–WO₃ glasses coactivated with Er³⁺ and Yb³⁺ are prepared. The effect of Yb content on the efficiency of Er photoluminescence (PL) in the visible and IR spectral regions is studied. The highest PL efficiency is achieved at an Er : Yb atomic ratio of 1 : 1. The PL lifetime for the Er^{3+ 4} I _13/2 level is determined to be 7–9 ms.     

On energy arguments applied to the hydrodynamic impact force

The hydrodynamic impact problem is investigated within the framework of potential-flow theory. The vertical load acting on the rigid body is derived based on either momentum or energy conservation, and using the concept of added mass together with a homogeneous Dirichlet condition for the potential on the free surface as usually done to model an impact problem. It is demonstrated that the use of this simplified dynamic free-surface condition, instead of the fully nonlinear one, has a direct influence on the computation of the loads. In particular, the equivalence of momentum and energy analysis is in general not recovered. The situation is then highlighted by performing an asymptotic analysis of the two-dimensional blunt-body asymmetric impact problem. The asymptotic solution is given explicitly and validated through comparisons with experimental results. The energy distribution is then studied. It is shown that the contradiction between momentum and energy analysis can be removed, provided that the flux of energy through the jets is taken into account in the energy balance. If the simplified free-surface condition is indeed valid in the far-field, nonlinear terms must be retained near the body, in the spray-root domains. To leading order, the energy distribution during the gravity-free inertia stage does not depend on the blunt-body shape. The general analysis based on momentum or energy conservation suggests that this result also applies for arbitrary body shape as soon as a homogeneous Dirichlet condition can be applied as a dynamical free-surface boundary condition. In this case, and for a constant vertical impact velocity, half the work performed by the body would seem to be transferred to the fluid as kinetic energy within the spray.     

Electrical conductivity and gas sensitivity of Zn-Sb-O thick films

The thick film of Zn-Sb-O was prepared by coating the paste of nanoparticles mixture (Sb₂O₃:ZnO=1:3) on the alumina substrate, followed by sintering at 500-900 °C for 2 h in air. The electrical resistance and gas-sensing properties to benzene, alcohol and acetone of Zn-Sb-O films were found to be dependent on the change of phase structure caused by sintering temperature.     

The Influence of Ir and Pt Addition on the Synthesis of Fullerenes at Atmospheric Pressure

The addition of metallic Ir and Pt to a fullerene-forming, atmospheric-pressure plasma reactor was found to influence the generation of carbonaceous products. It was observed that the added metals were efficiently dispersed into the plasma and that their presence increased the yield of fullerenes. The addition of Ir led to a noticeable shift in the fullerene distribution towards C₆₀, whereas the addition of Pt increased the proportion of C₆₀ oxides and decreased the proportion of higher fullerenes. Addition of Ir also caused a reduction of the soot particle size and the formation of a considerable quantity of carbon nanotubes.     

Dimension-structure dependences for the strength of two-phase polycrystalline inorganic materials

Examples are considered of experimental dependences of the strength of two-phase inorganic materials on the shape and size of structural elements, and also dimensional parameters: the mean value of the free path and the mean distance between particles. The structural condition for achieving the maximum strength values for two-phase metallic, cermet, and ceramic materials with a high second phase content is established and substantiated by experiment. An approximate analysis of the dislocation structure of interphase boundaries is performed and their contribution to strengthening of two-phase materials with a dispersed and microlayered structure is demonstrated.Translated from Problemy Prochnosti, No. 1, pp. 3–14, January, 1991.     

High performance biofilm process for treating wastewater discharged from coal refining plants containing nitrogen, cyanide and thiocyanate.

Wastewater discharge from coal refining plants contains a number of biologically toxic compounds; 2000-2500 mg/l of COD of which 40% is composed of phenol, 100-400 mg/l of thiocyanate, 10-40 mg/l of cyanide, 100-250 mg/l of NH4+-N and 150-300 mg/l of total nitrogen. In order to treat this kind of high strength wastewater, we have developed a high performance biofilm process using fluidizing bio-carriers of the tube chip type. The fluidizing biofilm carriers are made of a composite of polyethylene and several inorganic materials, whose density is controlled at 0.97-0.98 g/ml. The fluidizing biofilm carriers show sound fluidization characteristics inside bioreactors. The wastewater is treated using three consecutive series reactors in oxic-anoxic-oxic arrangement. Each reactor is charged with the fluidizing biofilm carriers of 50 vol%. Furthermore, newly cultured active microorganisms for the thiocyanate biodegradation are added in the biofilm process. At total hydraulic retention time of 2.2 days, this process can achieve steady state removal efficiencies: COD, 99%; thiocyanate, 99%; NH4+-N, 99% and total nitrogen, 90%.