Psychoanalytic considerations of right extremist orientation of male adolescents

Giving a case example of an male adolescent with radical right-wing attitudes, the lack of male identification as well as in unresolved dyadic fixation to the mother will be shown. Though the radical right-wing orientation the adolescent tries on the basis of a phallic narcissistic conflict to establish bordes against an unresolved dyadic fixation to his mother.     

Neurocontrol for lateral vehicle guidance

A solution to autonomous lateral vehicle guidance using a neurocontroller that can learn from measured human-driving data without knowledge of the physical car parameters is discussed. Simulations and practical tests confirm that a small-size feedforward autonomous neural network (21 neurons) can learn to steer a vehicle at high speeds only from looking at human-driving examples. In this way, the network learns the total closed-loop behavior, including the nonlinear dynamics of the vehicle and the driver's individual driving style. The main result of practical investigations is that the neutral controller trained on human-driving examples exhibits an aperiodic behavior that does not vanish at higher speeds (tests performed up to 130 km/h) and produces fewer lateral deviations than the linear state controller     

Vessel wall detection and blood noise reduction in intravascularultrasound imaging

Scattering from blood limits the contrast between the vessel wall and the lumen in intravascular ultrasound imaging. This makes it difficult to localize the vessel wall, especially on still images. This paper presents a method for automatic detection of vessel walls and reduction of blood noise based on correlation of the RF-signal between adjacent frames. The ultrasound RF-signal is quadrature demodulated, digitized, stored in memory, and transferred to a computer for processing and analysis. The absolute value of the cross-correlation coefficient between two adjacent frames is used to differentiate between stationary and fluctuating signals. Models and numerical calculations presented in this work indicate that the cross-correlation coefficient obtained from a radially dilating vessel wall will be larger than 0.8 under standard 20 MHz imaging conditions. The corresponding value from blood is less than 0.2 for blood velocities exceeding 0.5 cm s^-1 . The blood-noise filter is based on detecting this difference in correlation and displays vessel wall regions with no modifications, while regions detected as blood are rejected. A simplified vessel-wall detector that is suitable for real-time implementation is proposed. The performance of this detector and the blood noise filter are demonstrated by in vitro experiments     

Study of Desorption and Adsorption During Grain Aeration

One requirement in designing and operating and operating system is to minimize the moisture change in stored grain. Moisture transfer during the aeration process is generally believed to be caused by the partial pressure difference between water in grain and water in air (P₃-P₄). A mathematical model was developed for rough rice, which predicts the partial pressure difference under various grain and ambient conditions. Observations of moisture change over 10 aeration tests confirmed the good correlation between sorption phenomena and partial pressure differences. Studies indicated that air relative humidity, air temperature, grain temperature and grain moisture are significant factors influencing the partial pressure differences and, thus, affecting     

Theoretical and Experimental Study of Water Transport in a Hollow Cylinder Applied to the Drying of Round Squid Mantle

Until now, attention has been focused solely in the drying of squid mantle from an experimental point of view, neglecting the transport phenomenon studies of water in squid muscle. This work studies the drying of squid mantle (Loligo brasiliensis), previously salted and smoked by liquid smoking (hickory extract), using a tubular dryer in closed cycle with a silicagel fixed bed in series. The mass transfer phenomenon during drying was studied, based on the Fick's second law, with the effective diffusivity supposed constant, which enabled an analytical solution to the problem. The drying curve calculated with the resulting equation was compared with experimental data. The model was applied to a hollow cylinder geometry (round squid mantle), with its internal surface isolated from the drying environment by a plastic film. The latter was given a tubular form and introduced inside the mantle cavity (impervious wall boundary condition).     

High speed p-type SiGe modulation-doped field-effect transistors

We report on the fabrication and characterization of high-speed p-type modulation-doped field-effect transistors (MODFETs) with 0.7-μm and 1-μm gate-lengths having unity current-gain cut-off frequencies (f_T) of 9.5 GHz and 5.3 GHz, respectively. The devices were fabricated on a high hole mobility SiGe heterostructure grown by ultra-high-vacuum chemical vapor deposition (UHV-CVD). The dc maximum extrinsic transconductance (g_m) is 105 mS/mm (205 mS/mm) at room temperature (77 K) for the 0.7-μm gate length devices. The fabricated devices show good pinch-off characteristics and have a very low gate leakage current of a few μA/mm at room temperature and a few nA/mm at 77 K     

Entfestigungsverhalten des Stahls 50 CrV4 bei der thermomechanischen Behandlung

Softening behaviour of 50 CrV4 steel on thermomechanical treatment Determination of static softening of austenite on thermomechanical treatment of steel by rolling. Analysed was the development of the austenite structure and influencing the work softening processes depending on the deformation-temperature-time mode. The static softening processes were modelled mathematically by using Avrami's relationships.     

Relative permeability measurements for two phase flow in unconsolidated sands

This paper presents the results of laboratory measurements of relative permeability for two phase flow in partially saturated samples of unconsolidated sands. Relative permeabilities for tap water and air, de-aired water and nitrogen were measured using a steady—state technique. Three different sand samples (fine sand, heterogeneous sand and coarse sand) were tested.