Effect of spinning speed on the propagation of ultrasound and the anisotropy of acoustical characteristics in hdyrocellulose films

Conclusions It has been shown that there is a close connection between the change in spinning speed of hydrocellulose films and their acoustical characteristics: rate of propagation of ultrasound and damping cellulose of ultrasound, which permits one to use a nondestructive control method in the technological practice of hydrocellulose film preparation.A close connection has been found between the strength of hydrocellulose film and the propagation rate and damping coefficient of ultrasonic waves.Translated from Khimicheskie Volokna, No. 4, pp. 36–38, July–August, 1985.     

B-cell and T-cell immunoblastic lymphomas of baboons

The results of morphological study of B- and T-cellular immunoblast baboon lymphomas are presented. Differences are found both in the structure of tumour cells and in the histostructure of tumours as a whole. The tumor cells of B-immunoblastic lymphomas expressed mainly IgM. The tumour cells of certain T-immunoblastic lymphomas being investigated by means of monoclonal OKT4 antibodies had a surface phenotype peculiar to T-helper cells.     

Mutagenicity of three agricultural soils

A chemical and biological testing protocol was employed to evaluate the mutagenic potential of the organic compounds extracted from three agricultural soils. The analytical procedures used included bioassays with Salmonella typhimurium and Aspergillus nidulans for the detection of point mutations and a gas chromatography/mass spectrometry/computer system to identify major organic constituents. The extracts of all three soils exhibited mutagenic response in the bioassays. At a dose level of 1000 micrograms per plate, the organic extract of the Bastrop clay induced 434 net revertants; while at the same dose level the Norwood sandy clay and the Sassafrass sandy loam induced 35 and 178 net revertants, respectively, in the Salmonella assay with metabolic activation. In the Aspergillus assay, the extract of the Norwood and Bastrop soils induced a positive response without metabolic activation; this effect was reduced or eliminated in the presence of metabolic activation. Chemical analysis identified a variety of initiators, promotors, inhibitors, and cocarcinogens; however, there were no mutagenic compounds identified in any of the soil extracts. The results of this combined testing protocol indicate that the agricultural soils tested had an inherent level of mutagenic activity, which was not detected by GC/MS analysis alone, and this activity may be related to the past history of agricultural practices, including biocide applications, fertilization, and cultivation.     

Optimum Design for RF-to-Optical Up-Converter in Coherent Optical OFDM Systems

In this letter, we conduct analysis on the optimum design for RF-to-optical up-converter in coherent optical OFDM systems using an optical I/Q modulator. We first derive closed-form expressions for the nonlinearity in the optical I/Q modulator, represented by two-tone intermodulation products as a function of the bias point and modulation index. Additionally, we perform a numerical simulation to identify Q-penalty and the excess modulation insertion loss under various transmitter conditions. We find that in contrast to the direct-detected system, the optimal modulator bias point for the coherent system is pi, where the Q-penalty and excess loss are minimized     

Room electromagnetics

In analogy with the established discipline of room acoustics, various aspects of diffuse wideband microwave propagation in a room are treated. It is shown that an equivalent to Sabine's equation for reverberation time in a room is valid for the completely diffused field, depending only on the volume, the surface area, and an effective absorption coefficient. An exponential decay of the power as a function of the delay is a consequence of the assumptions. Furthermore, the concept of a reverberation distance is also valid. This is the distance from a transmitting antenna where the received diffuse, randomly scattered power equals the direct line-of-sight received power, such that the diffuse power dominates for distances larger than the reverberation distance. A number of measurements in a large room support the theory with an effective absorption coefficient of 0.5. The power delay profiles around the room from a transmitter in the ceiling vary only in the first arriving part of the impulse, whereas the tail, being dominated by the diffuse field, has the same power level for a given delay and the same decay rate all over the room. It is also a consequence of the theory that the diffuse fields incident on an antenna are uniformly distributed in angle.     

Optical Endless Polarization Stabilization at 9 krad/s With FPGA-Based Controller

We demonstrate endless polarization stabilization with a control speed of up to 9 krad/s, over random Poincare sphere trajectories. These are in total >35 Mrad long, are composed in particular of difficult-to-track circles with all radii and orientations, and thereby include all possible worst cases. The maximum polarization mismatch and relative intensity errors are 0.13 rad and 0.43%, respectively. The controller runs on a field-programmable gate array and uses a commercial multistage LiNbO₃ polarization transformer as the control device.     

The Silicon Backplane Design for an LCOS Polarization-Insensitive Phase Hologram SLM

Polarization-insensitivity is achieved in a reflective spatial light modulator by laying a quarter-wave plate (QWP) at the incident wavelength directly over the mirror pixels of a silicon backplane, and forming a nematic Freedrickcz cell over the QWP to modulate the reflected phase. To achieve the highest drive voltage from the available silicon process, a switched voltage common front electrode design is described, with variable amplitude square wave drive to the pixels to maintain constant root-mean-square drive and minimize phase fluctuations during the dc balance refresh cycle. The silicon has been fabricated and liquid-crystal-on-silicon cells both with and without the QWP assembled; applications include optically transparent switches for optical networks, beam steering for add-drop multiplexers for wavelength-division-multiplexing telecommunications, television multicast, and holographic projection.     

Progress toward roll-to-roll processing of inorganic monolithic electrochromic devices on polymeric substrates

As electrochromic device (ECD) emerges into the market, the necessity of cost reduction via high-throughput manufacturing is unavoidable. Inorganic monolithic ECD has compatibility in its manufacturing steps, allows continuous processing and hence low-cost ECD. A roll-to-roll (R2R) production is the industrial standard for high-throughput processing and was chosen to synthesize ECD on polymeric substrates. Preliminary success by implementing methods compatible to the aforementioned R2R processing has been achieved; however, continuous test-runs on an R2R machine are still limited.