首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   3519篇
  免费   104篇
  国内免费   88篇
电工技术   36篇
综合类   123篇
化学工业   118篇
金属工艺   118篇
机械仪表   72篇
建筑科学   223篇
矿业工程   31篇
能源动力   17篇
轻工业   77篇
水利工程   33篇
石油天然气   40篇
武器工业   24篇
无线电   128篇
一般工业技术   250篇
冶金工业   2311篇
原子能技术   29篇
自动化技术   81篇
  2024年   3篇
  2023年   17篇
  2022年   45篇
  2021年   47篇
  2020年   37篇
  2019年   38篇
  2018年   36篇
  2017年   37篇
  2016年   25篇
  2015年   43篇
  2014年   44篇
  2013年   78篇
  2012年   80篇
  2011年   79篇
  2010年   74篇
  2009年   80篇
  2008年   66篇
  2007年   88篇
  2006年   103篇
  2005年   73篇
  2004年   60篇
  2003年   55篇
  2002年   47篇
  2001年   32篇
  2000年   28篇
  1999年   95篇
  1998年   681篇
  1997年   425篇
  1996年   266篇
  1995年   160篇
  1994年   135篇
  1993年   178篇
  1992年   28篇
  1991年   27篇
  1990年   31篇
  1989年   37篇
  1988年   22篇
  1987年   26篇
  1986年   18篇
  1985年   16篇
  1983年   4篇
  1982年   10篇
  1981年   10篇
  1980年   15篇
  1978年   6篇
  1977年   59篇
  1976年   135篇
  1975年   6篇
  1955年   3篇
  1954年   1篇
排序方式: 共有3711条查询结果,搜索用时 0 毫秒
41.
为了研究钢纤维混凝土(SFRC)常温以及经历400和800℃高温后的动态压缩性能,采用改进的分离式Hopkinson压杆装置,结合应变直测技术对其进行了单轴冲击压缩试验.结果表明:经历400和800℃高温后,未掺钢纤维混凝土的峰值应力分别只有常温时的79.2%和38.9%,弹性模量分别降为常温时的82.8%和56.2%,同时,试件的能量吸收能力大幅度下降;钢纤维混凝土400,800℃对应的峰值应力分别降为常温时的76.8%和39.0%,弹性模量稍有降低,分别为常温的91.8%和82.7%,较基准混凝土有了较大的提高.钢纤维的加入可以增加混凝土的极限应力对应应变,曲线的下降段较为平缓,同时增强了混凝土的能量吸收能力,在20,400和800℃时,分别提高了38.5%,27.5%和25%.  相似文献   
42.
为了研究电化学除氯对混凝土中离子分布和微观结构的影响规律,采用压汞法、SEM电子显微镜分析等方法对电化学除氯后不同水灰比混凝土试件中钢筋附近和表面层的氯离子和钾钠离子含量、孔隙结构、显微结构进行对比分析.结果显示,电化学除氯后,钢筋附近混凝土与外层混凝土相比,氯离子含量约为1/2,钾离子含量约为5~10倍,钠离子含量约为8~18倍,水化物颗粒间结合不连续、部分水化产物分解.钢筋附近区域混凝土中的氯离子含量明显低于外表层混凝土,钾、钠离子在钢筋阴极附近大量聚集.经过电化学处理后的混凝土试件钢筋附近区域的孔隙率和大孔含量增多,结构疏松;而外表层混凝土结构致密,孔隙细化,水化产物成网络状结合良好.  相似文献   
43.
In the indoor visible light transmission environment with complex noise, traditional received signal strength indication(RSSI)localization algorithm and imaging localization algorithm are unable to accurately determine the reason of the inaccurate localization model and inadequate constraints of position coordinates. In order to solve the problems, a visible light localization algorithm based on multi-measurements constraints is presented in the paper. The algorithm first constructs a joint localization state space model based on RSSI localization and the imaging localization algorithm. Then, states, measurements and their equations are constructed based on the space model. Finally, the equations are resolved using the unscented Kalman filter(UKF). Compared with RSSI localization and imaging localization, simulation results show that the RMSE of the proposed algorithm could be closer to the Cramer Rao bound. Besides, the localization probability of the proposed algorithm is higher than that of RSSI localization and imaging localization algorithm.  相似文献   
44.
The pressing bonding of steel plate to QTi3.5-3.5graphite slurry was studied. The bonding conditions were 620℃ for preheating temperature of steel plate, 530℃ for preheating temperature of dies, 50 MPa for pressure and 2 min for pressing time. The relationship between the solid fraction of QTi3.5-3.5graphite slurry and the interracial mechanical property of bonding plate was obtained. The results show that when the solid fraction of QTi3.5-3.5graphite slurry is smaller than 45.8%, the interracial shear strength of bonding plate increases with the increasing of solid fraction. When the solid fraction is larger than 45.8%, the interracial shear strength decreases with the increasing of solid fraction. When the solid fraction is 45.8%, the largest interracial shear strength of bonding plate 127 MPa can be got, and the interface is made up of Fe-Cu solid solution.  相似文献   
45.
神经网络具有很强的自学习和自适应能力,对于大滞后、非线性的复杂系统有较好的控制效果.针对水处理过程中系统环境不断变化,特别是流量有较大、频繁变化的情况下,在FCD絮凝控制系统的基础上,提出了神经网络控制方法.解决了混凝控制中的目标等效直径动态确定问题.实际运行表明,该方法取得了很好的控制效果,具有广阔的应用前景.  相似文献   
46.
The carcinogen N-nitrosodimethylamine (NDMA) may be quantitated routinely at ultratrace (ng/L) levels in drinking water or contaminated groundwater. The aqueous sample is passed through a preconditioned Empore C18 filter disk to remove neutral nonpolar species and then extracted continuously overnight with highest purity dichloromethane. The latter is then concentrated to 1 mL, and a large aliquot (up to 200 microL) is loaded onto a dual-stage carbon sorbent trap, after which the solvent is removed with ultrapure helium. The concentrated residues are then injected onto a gas chromatographic column using a short-path thermal desorber. NDMA is selectively detected using a chemiluminescent nitrogen detector (CLND) operated in its nitrosamine-selective mode. The reporting limit for this procedure, evaluated using two independent statistically unbiased protocols, is 2 ng of NDMA/L. A related procedure, employing an automatic sampler instead of the short-path thermal desorber, provides convenient analysis of heavily contaminated samples and exhibits a reporting limit (same protocols cited previously) of 110 ng of NDMA/L. When the two methods are used together in a "two-tiered" protocol, NDMA concentrations spanning 4 orders of magnitude (ng/L to microgram/L levels) may be measured routinely. The low-level procedure employing only the short-path thermal desorber was applied successfully to three sources of drinking water, where NDMA concentrations ranged between 2 and 10 ng of NDMA/L. The two-tiered protocol was applied to a series of contaminated groundwaters whose NMDA concentrations ranged between approximately 10-7000 ng of NDMA/L. The results agreed with those obtained from an independent collaborating laboratory, which used a different analytical procedure.  相似文献   
47.
The indirect estimation of thiamine levels in human blood by measuring thiamine pyrophosphate effect on erythrocyte transketolase activity is the method of choice in most clinical laboratories. We describe here an optimized, time-saving, and accurate method to determine the thiamine pyrophosphate effect in as many as 16 blood samples simultaneously. The method is based on a multi-point determination using a computer remote-controlled microplate reader. For multiple sample handling, three pooled reaction mixtures are freshly prepared and loaded onto a 96 well microtitre plate. A pre-written software is then initiated to remote-control the system. The data is retrieved and processed to calculate thiamine pyrophosphate effect by a self-written "macro" on a "Quattro-Pro" worksheet database. This method proves to be highly accurate (coefficient of variance: 2.7%), reproducible (coefficient of variance: 4.1%) and economical.  相似文献   
48.
The authors proved that animals having higher natural antioxidant activity and lower intensity of lipid peroxidation are more resistant to fibrogenic effects of quartz. The peritoneal macrophages obtained from those animals show higher resistance to quartz exposure "in vitro". Parameters characterizing antioxidant system should be included into a group of indexes describing propensity to silicosis.  相似文献   
49.
Results from a number of studies have shown that individuals with profound developmental disabilities often show differential approach behavior to stimuli presented in a variety of formats, and that such behavior is a reasonably good predictor of reinforcement effects when these "preferred" stimuli are used subsequently in a contingent arrangement. Recent data suggest that reinforcement effects may be enhanced further by allowing individuals to select, just prior to training sessions, which (of several) preferred stimuli would be used as reinforcers, but whether this method is superior to one based on selection by a teacher or therapist has not been adequately addressed. We compared the effects of these two methods of reinforcer selection on rates of responding on a free-operant task, using stimuli previously identified as potential reinforcers. Results obtained with 4 subjects indicated little or no difference in reinforcement effects when stimuli were selected by subjects rather than experimenters. Implications of these results with respect to choice and its relation to reinforcement are discussed.  相似文献   
50.
用负压真空冷冻干燥机在-20℃条件下冷冻干燥48h制备珍珠层粉/壳聚糖复合多孔支架。用扫描电子显微镜(SEM)观察支架表面形貌,通过X射线衍射分析(XRD)、傅里叶红外光谱(FTIR)等手段对材料进行表征测试,检测其降解性能,并将兔骨髓间充质干细胞与支架共培养检测材料细胞毒性。结果表明复合支架具有稳固的三维多孔结构,孔隙率最大至91.64%,孔径在100~300μm范围,降解性能适宜,且冷冻干燥制备方法对珍珠层粉的结构无明显破坏,并具有良好的生物相容性,有利于细胞的生长。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号