电化学除氯处理后的混凝土微观结构研究

为了研究电化学除氯对混凝土中离子分布和微观结构的影响规律,采用压汞法、SEM电子显微镜分析等方法对电化学除氯后不同水灰比混凝土试件中钢筋附近和表面层的氯离子和钾钠离子含量、孔隙结构、显微结构进行对比分析.结果显示,电化学除氯后,钢筋附近混凝土与外层混凝土相比,氯离子含量约为1/2,钾离子含量约为5～10倍,钠离子含量约为8～18倍,水化物颗粒间结合不连续、部分水化产物分解.钢筋附近区域混凝土中的氯离子含量明显低于外表层混凝土,钾、钠离子在钢筋阴极附近大量聚集.经过电化学处理后的混凝土试件钢筋附近区域的孔隙率和大孔含量增多,结构疏松;而外表层混凝土结构致密,孔隙细化,水化产物成网络状结合良好.     

Visible light localization algorithm based on multi-measurements constraints

In the indoor visible light transmission environment with complex noise, traditional received signal strength indication(RSSI)localization algorithm and imaging localization algorithm are unable to accurately determine the reason of the inaccurate localization model and inadequate constraints of position coordinates. In order to solve the problems, a visible light localization algorithm based on multi-measurements constraints is presented in the paper. The algorithm first constructs a joint localization state space model based on RSSI localization and the imaging localization algorithm. Then, states, measurements and their equations are constructed based on the space model. Finally, the equations are resolved using the unscented Kalman filter(UKF). Compared with RSSI localization and imaging localization, simulation results show that the RMSE of the proposed algorithm could be closer to the Cramer Rao bound. Besides, the localization probability of the proposed algorithm is higher than that of RSSI localization and imaging localization algorithm.     

Effects of coating thickness and residual stresses on the bond strength of ASTM C633-79 thermal spray coating test specimens

Wire-arc-sprayed nickel-aluminum is widely used in the aircraft industry for dimensional restoration of worn parts and as a bond coat for thermal barrier coatings and other top coats. Some repair applications require thick coatings, which often result in lower bond strength. A mechanism being investigated to ex-plain this decrease in bond strength is the free edge effect, which includes both coating residual stresses and coating thickness. The layer-removal method was used to determine experimentally the residual stresses in wire-arc-sprayed nickel-aluminum coatings of different thicknesses. Bond strength evalu-ations were performed using an improved ASTM C 633-79 test specimen. Finite-element analysis and fracture mechanics were used to investigate the effects of coating thickness and residual stress state on coating bond strength.     

Effect of solid fraction on steel-mushy Cu-graphite pressing bonding

The pressing bonding of steel plate to QTi3.5-3.5graphite slurry was studied. The bonding conditions were 620℃ for preheating temperature of steel plate, 530℃ for preheating temperature of dies, 50 MPa for pressure and 2 min for pressing time. The relationship between the solid fraction of QTi3.5-3.5graphite slurry and the interracial mechanical property of bonding plate was obtained. The results show that when the solid fraction of QTi3.5-3.5graphite slurry is smaller than 45.8%, the interracial shear strength of bonding plate increases with the increasing of solid fraction. When the solid fraction is larger than 45.8%, the interracial shear strength decreases with the increasing of solid fraction. When the solid fraction is 45.8%, the largest interracial shear strength of bonding plate 127 MPa can be got, and the interface is made up of Fe-Cu solid solution.     

Effect of theθ-α-Al2O3 transformation on the oxidation behavior ofβ-NiAl + Zr

Isothermal oxidation of NiAl + Zr has been performed over the temperature range of 800–1200°C and studied by TGA, XRD, and SEM. A discontinuous decrease in growth rate of two orders of magnitude was observed at 1000° C due to the formation of -Al₂O₃ from -Al₂O₃. This transformation also resulted in a dramatic change in the surface morphology of the scales, as a whisker topography was changed into a weblike network of oxide ridges and radial transformation cracks. It is believed that the ridges are evidence for a shortcircuit outward aluminum diffusion growth mechanism that has been documented in a number of¹⁸O tracer studies.     

基于神经网络的FCD絮凝控制系统的研究

神经网络具有很强的自学习和自适应能力,对于大滞后、非线性的复杂系统有较好的控制效果.针对水处理过程中系统环境不断变化,特别是流量有较大、频繁变化的情况下,在FCD絮凝控制系统的基础上,提出了神经网络控制方法.解决了混凝控制中的目标等效直径动态确定问题.实际运行表明,该方法取得了很好的控制效果,具有广阔的应用前景.     

Determination of N-nitrosodimethylamine at part-per-trillion levels in drinking waters and contaminated groundwaters

The carcinogen N-nitrosodimethylamine (NDMA) may be quantitated routinely at ultratrace (ng/L) levels in drinking water or contaminated groundwater. The aqueous sample is passed through a preconditioned Empore C18 filter disk to remove neutral nonpolar species and then extracted continuously overnight with highest purity dichloromethane. The latter is then concentrated to 1 mL, and a large aliquot (up to 200 microL) is loaded onto a dual-stage carbon sorbent trap, after which the solvent is removed with ultrapure helium. The concentrated residues are then injected onto a gas chromatographic column using a short-path thermal desorber. NDMA is selectively detected using a chemiluminescent nitrogen detector (CLND) operated in its nitrosamine-selective mode. The reporting limit for this procedure, evaluated using two independent statistically unbiased protocols, is 2 ng of NDMA/L. A related procedure, employing an automatic sampler instead of the short-path thermal desorber, provides convenient analysis of heavily contaminated samples and exhibits a reporting limit (same protocols cited previously) of 110 ng of NDMA/L. When the two methods are used together in a "two-tiered" protocol, NDMA concentrations spanning 4 orders of magnitude (ng/L to microgram/L levels) may be measured routinely. The low-level procedure employing only the short-path thermal desorber was applied successfully to three sources of drinking water, where NDMA concentrations ranged between 2 and 10 ng of NDMA/L. The two-tiered protocol was applied to a series of contaminated groundwaters whose NMDA concentrations ranged between approximately 10-7000 ng of NDMA/L. The results agreed with those obtained from an independent collaborating laboratory, which used a different analytical procedure.     

Improved measurement of transketolase activity in the assessment of "TPP effect"

The indirect estimation of thiamine levels in human blood by measuring thiamine pyrophosphate effect on erythrocyte transketolase activity is the method of choice in most clinical laboratories. We describe here an optimized, time-saving, and accurate method to determine the thiamine pyrophosphate effect in as many as 16 blood samples simultaneously. The method is based on a multi-point determination using a computer remote-controlled microplate reader. For multiple sample handling, three pooled reaction mixtures are freshly prepared and loaded onto a 96 well microtitre plate. A pre-written software is then initiated to remote-control the system. The data is retrieved and processed to calculate thiamine pyrophosphate effect by a self-written "macro" on a "Quattro-Pro" worksheet database. This method proves to be highly accurate (coefficient of variance: 2.7%), reproducible (coefficient of variance: 4.1%) and economical.     

Effects of antioxidant state on individual susceptibility to silicosis (an experimental study)

The authors proved that animals having higher natural antioxidant activity and lower intensity of lipid peroxidation are more resistant to fibrogenic effects of quartz. The peritoneal macrophages obtained from those animals show higher resistance to quartz exposure "in vitro". Parameters characterizing antioxidant system should be included into a group of indexes describing propensity to silicosis.