Quantized based image watermarking in an independent domain

This paper presents a performance study for two well known quantized based watermarking schemes Scalar Costa Scheme (SCS), and Trellis Coded Quantization scheme (TCQ) in an independent domain. For our study, the independent domain is obtained by the combination of the cited schemes with Independent Component Analysis (ICA). The Independent Component Analysis is used while inserting and extracting the message. Thus a performance compromise improvement of the original SCS and TCQ schemes in terms of robustness, capacity, and security is shown. Then the obtained schemes performances are compared to the Spread Transform (ST) based scheme well known for its proven good robustness properties. Our results show that, using watermarking with side information in independent domain permits to improve the global SCS and TCQ schemes performances. For example, in the case of SCS, by studying the Bit Error Rate (BER) in function of the watermark to noise ratio (WNR), the robustness has been improved by 20 dB (1 decade) when WNR is equal to 0 dB. Moreover, the capacity study shows for the same WNR=0 dB, the amount of information to be transmitted without error for a given noise level of the proposed SCS combined with ICA scheme (SCS-ICA) is much higher than that of the existing schemes. Finally, the study of the probability density functions (PDF) of the original and marked signals has shown that the Cachin-security level of the TCQ in an independent domain scheme (TCQ-ICA) is the best one compared to the other known schemes.     

High‐dose cefazolin on consecutive hemodialysis in anuric patients with Staphylococcal bacteremia

Methicillin‐sensitive Staphylococcus aureus (MSSA) bacteremia is a leading cause of infection in hemodialysis (HD) patients. Cloxacillin, cefazolin, and vancomycin are the mainstay antimicrobials. Cloxacillin administration leads to frequent drug dosing, longer length of stay (LOS), and higher cost, while resistance and poorer outcomes are associated with vancomycin use. Dosing cefazolin during HD allows for prolonged blood therapeutic levels. We assessed the outcomes and safety of a strategy of treating MSSA bacteremia with 2–3 g cefazolin on HD only. All HD patients with MSSA bacteremia admitted in June–December 2009 at our center and receiving this regime were compared with historical controls who received cloxacillin. Demographic characteristics and outcome measures like mortality, LOS, cost, recrudescence, and adverse drug reactions were assessed. Of 27 consecutive episodes reviewed, 14 and 13 patients received cefazolin and cloxacillin, respectively. Baseline demographics were comparable between the 2 treatment groups. More than one‐third of the bacteremia was related to tunneled catheter infection. The 30‐day mortality of cloxacillin‐ and cefazolin‐treated patients was 15% and 7%, respectively (P=0.14). Two of the 11 survivors treated with cloxacillin (18%) had recrudescent bacteremia while none was observed in cefazolin‐treated survivors. Cefazolin was associated with shorter LOS (10 vs. 20 days, P<0.05) and lower cost (US$8262.00 vs. US$15,367.00, P<0.05). Cefazolin use resulted in 3 idiosyncratic adverse drug reactions. Cefazolin dosed on each HD in MSSA bacteremia leads to earlier discharge and less cost. Larger prospective studies are, however, warranted to fully assess its safety and efficacy.     

Microstructure and texture analysis of YBCO thick film with peritectic growth on unoriented silver substrate

YBCO textured thick film was prepared by direct periteetic growth method. Microstructure of the film was characterized. Electron backscattered diffraction (EBSD) technique was applied to the film for quantitative texture analysis. The main difficulty in resolving the ori-entation of YBCO pseudo-cubic structure was investigated. Automated orientation mapping was performed on YBCO thick film. Local tex-ture was presented in the form of orientation maps. Misorientation distribution and crystal growth characterization in the YBCO thick film were revealed. Large domains with well-aligned YBCO grains were formed. Each domain presented clear in-plane and out-plane textures.     

Size Effect on Properties of Varistors Made From Zinc Oxide Nanoparticles Through Low Temperature Spark Plasma Sintering

Conditions for the elaboration of nanostructured varistors by spark plasma sintering (SPS) are investigated, using 8‐nm zinc oxide nanoparticles synthesized following an organometallic approach. A binary system constituted of zinc oxide and bismuth oxide nanoparticles is used for this purpose. It is synthesized at room temperature in an organic solution through the hydrolysis of dicyclohexylzinc and bismuth acetate precursors. Sintering of this material is performed by SPS at various temperatures and dwell times. The determination of the microstructure and the chemical composition of the as‐prepared ceramics are based on scanning electron microscopy and X‐ray diffraction analysis. The nonlinear electrical characteristics are evidenced by current–voltage measurements. The breakdown voltage of these nanostructured varistors strongly depends on grain sizes. The results show that nanostructured varistors are obtained by SPS at sintering temperatures ranging from 550 to 600 °C.     

Densification of nanocrystalline Y2O3 ceramic powder by spark plasma sintering

Nanocrystalline Y₂O₃ powders with 18 nm crystallite size were sintered using spark plasma sintering (SPS) at different conditions between 1100 and 1600 °C. Dense specimens were fabricated at 100 MPa and 1400 °C for 5 min duration. A maximum in density was observed at 1400 °C. The grain size continuously increased with the SPS temperature into the micrometer size range. The maximum in density arises from competition between densification and grain growth. Retarded densification above 1400 °C is associated with enhanced grain growth that resulted in residual pores within the grains. Analysis of the grain growth kinetics resulted in activation energy of 150 kJ mol^?1 and associated diffusion coefficients higher by 10³ than expected for Y³⁺ grain boundary diffusion. The enhanced diffusion may be explained by combined surface diffusion and particle coarsening during the heating up with grain boundary diffusion at the SPS temperature.     

Mercury speciation in the French seasonal snow cover

Snow samples have been collected in the French Alps in 1998, 1999 and 2000 in order to measure both total Hg (HgT) and reactive Hg (HgR). Concentrations of HgT were between 13 and 130 pg g(-1) and HgR concentrations were below the detection limit (approximately 0.8 pg g(-1)). Hg speciation in snow was evaluated on the basis of ionic complexation equilibrium with chloride, hydroxide, oxalate. The pH of the snow was found to be an important parameter for Hg speciation. For pH values near 3, HgC2O4 is predominant in snow samples except for snow strongly influenced by anthropogenic sources (in which case HgCl2 predominates). When pH > 4, Hg(OH)2 and HgOHCl are predominant. These latter pH values are observed for precipitation not influenced by anthropogenic sources but more by soil erosion, e.g. Saharan dusts. The knowledge of Hgr speciation in snow is a key question for understanding the mechanisms of transformation of these complexes in snow after precipitation.     

Optical properties of the synthetic nanocomposites SiO2/CdS/poly(styrene-co-maleic anhydride) and SiO2/CdS/poly(styrene-co-maleimide)

Hybrid materials consisting of SiO2/CdS particles dispersed in poly(styrene-co-maleic anhydride) and poly(styrene-co-maleimide) have been synthesized and characterized. The polymer nanocomposites were synthesised in situ in the presence of previously prepared inorganic fillers (SiO2/CdS). The nanocomposites were synthesized with the use of as-prepared or surface-modified SiO2/CdS fillers. For both types of nanocomposites, the optical properties were evaluated and the observation of size quantization effects in the optical spectra is discussed. In this context, the influence of the inorganic fillers and polymer matrices on the optical properties of the final nanocomposites was investigated.     

Toward tunable thin-film filters for wavelength division multiplexing applications

We provide a detailed analysis of the various problems connected with the development of tunable thin-film filters for wavelength-division multiplexing applications. We examine the relation between the change in layer thickness and the central wavelength shift for various configurations and point out the significance of the structure of the reflectors, the spacer thickness, and the location of the active layers. We describe and compare practical arrangements using either temperature or an electric field as the driving parameter.