Influence of additives on the impact toughness of Al–10.8% Si near-eutectic cast alloys

This article investigates the effects of melt treatment and addition of alloying elements on the impact toughness of as-cast and heat-treated Al–10.8% Si near-eutectic alloys. Increasingly precise impact behaviors are discussed in the context of differentiating between initiation and propagation energies, including the ductility index, which is the ratio of the propagation to initiation energies; total energy as a useful measure is also discussed. Details concerning the evaluation of tensile properties are reported in a separate article [Mohamed AMA, Samuel FH, Samuel AM, Doty HW. Influence of additives on the microstructure and tensile properties of near-eutectic Al–10.8%Si cast alloy. Mater Des, in press]. The concentration of elements in the alloys was changed to the following range: Fe 0.5–1 wt%, Mn 0.5–1 wt%, Cu 2.25–3.25 wt%, and Mg 0.3–0.5 wt%, while the impact toughness upon artificial aging in a temperature range of 155–240 °C for 5 h was also investigated. The results indicate that the morphology of fibrous Si in Sr-modified alloys enhances toughness because of its profound effect on crack initiation and crack propagation resistance. The combined addition of modifier and grain refiner leads to a 33% increase in the impact strength compared to the untreated alloy. In alloys containing high levels of iron, such as the RF2 (1% Fe, 1% Mn) and RF4 (1% Fe, 0.5% Mn) alloys, the addition of iron leads to an increased precipitation of sludge or β-Fe platelets, respectively; these particles also act as crack initiation sites and reduce the impact properties noticeably. In alloys already containing high levels of copper, such as the RC2 (3.25% Cu, 0.3% Mg) and RC5(0.3.25% Cu, 0.5% Mg) alloys, increasing the copper level lowers the impact properties significantly, in view of the fact that the fracture behavior is now predominantly influenced by the Al₂Cu phase rather than by the Si particles. The average crack propagation speed of impact-tested samples shows a good inverse relationship to impact energy. Crack propagation speed can thus provide a qualitative estimation of the impact energy expected for special alloy conditions.     

A retrospective study of changes in physical symptoms and body image after reduction mammaplasty

Reduction mammaplasty is performed typically to alleviate the painful physical symptoms of macromastia. Women who suffer from macromastia also frequently present to the plastic surgeon with heightened body image dissatisfaction and maladaptive behavioral changes in response to their breast size. Numerous investigations have demonstrated improvement in physical symptoms after breast reduction surgery. Studies have also suggested that psychological improvement occurs postoperatively; however, they have not used well-validated, standardized psychological measures. The present study is a retrospective analysis of the physical and psychological status of women who underwent reduction mammaplasty. One hundred ten patients who underwent a reduction mammaplasty between 1982 and 1996 were mailed a packet of questionnaires designed to assess current physical symptoms and body image. Sixty-one of the 110 patients (55 percent) responded. The vast majority reported substantial improvement or elimination of neck, back, shoulder, and breast pain, grooving from bra straps, poor posture, skin irritation, and social embarrassment. In addition, they reported significantly less dissatisfaction with their breasts as compared with a sample of breast reduction patients assessed preoperatively. Symptom relief and improved body image occurred independently of preoperative body weight, as we found few significant differences between obese and non-obese women concerning the resolution of physical symptoms or improvement in body image. Results provide further evidence of the efficacy of reduction mammaplasty not only for relief of physical symptoms but also for alleviation of body image dissatisfaction.     

The impact of diaphragm management on prolonged ventilator support after thoracoabdominal aortic repair

PURPOSE: The relationship of the division of the diaphragm during thoracoabdominal aortic repair to prolonged ventilator support has not been studied. The purpose of this study was (1) to determine whether preservation of diaphragm integrity has a significant effect on postoperative ventilator duration and (2) to elucidate other pulmonary risk factors related to thoracoabdominal aortic surgery and to study the relationship of these factors to the intact diaphragm technique. METHODS:Between February 1991 and January 1997, we repaired 397 descending and thoracoabdominal aortic aneurysms. Descending thoracic aneurysms were not included in the study because their repair does not include the diaphragm. A total of 256 patients participated in this study. The diaphragm was divided in 150 patients and left intact in 106 patients. Examined as potential risk factors were patient demographics, history and physical findings, aneurysm extent, urgency of the procedure, acute dissection, cross-clamp time, homologous and autologous blood product consumption, and adjunctive operative techniques. FEV1 also was considered in the 197 patients for whom preoperative spirometry was available. Prolonged mechanical ventilation was defined as ventilator support for >72 hours. Data were analyzed by univariate contingency table and multiple logistic regression methods. RESULTS: Increasing age (odds ratio [OR], 1.02/y; P <.02), current smoking (OR, 2.6; P <.0008), total cross-clamp time (OR, 1.0/min; P <.008), units packed red blood cells transfused (OR, 1.06/unit; P <.008), and division of the diaphragm (OR, 2.03; P <.02) were significant, independent predictors of prolonged ventilation. Sixty-seven percent of patients (71 of 106) whose diaphragms were preserved were extubated in <72 hours compared with 52% of patients (78 of 150) who underwent diaphragm division (OR, 0.53; P <.02). CONCLUSION: Independently of well known pulmonary risk factors, an intact diaphragm during thoracoabdominal aortic repair results in a higher probability of early ventilator weaning.     

Growth hormone improves body composition, fat utilization, physical strength and agility, and growth in Prader-Willi syndrome: A controlled study

BACKGROUND: Obesity and hypotonia in children with Prader-Willi syndrome (PWS) are accompanied by abnormal body composition and diminished energy expenditure resembling a growth hormone deficient state. Hypothalamic dysfunction in PWS often includes decreased growth hormone (GH) secretion, suggesting a possible therapeutic role for exogenous GH treatment. OBJECTIVES AND METHODS: After 6 months of observation to determine baseline growth rate, and with the use of a 12-month randomized controlled study design, the effects of GH treatment (1 mg/m2/d) on growth, body composition, strength and agility, pulmonary function, resting energy expenditure (REE), and fat utilization were assessed in 54 children with PWS (n = 35 treatment and n = 19 control). Percent body fat and bone mineral density were measured by dual x-ray absorptiometry. Indirect calorimetry was used to determine REE and to calculate respiratory quotients. RESULTS: Stimulated levels of GH in response to clonidine testing were low in all patients (peak, 2.0 ng/mL). After 12 months, GH-treated subjects showed significantly increased height velocity Z scores (mean, 1.0 1.7 to 4.6 2.9; P <.001), decreased percent body fat (mean, 46.3% 8.4% to 38.3% 10.7%; P <.001), and improved respiratory muscle function, physical strength, and agility (sit-ups, weight-lifts, running speed, and coordination). A significant decline in respiratory quotients occurred during GH therapy (0.81 to 0.77, P <.001), but total REE did not change. CONCLUSIONS: GH treatment of children with PWS accelerated growth, decreased percent body fat, and increased fat oxidation but did not significantly increase total REE. Improvements in respiratory muscle strength, physical strength, and agility also occurred, suggesting that GH treatment may have value in reducing some physical disabilities experienced by children with PWS.     

Conversion of 3-chlorocatechol by various catechol 2,3-dioxygenases and sequence analysis of the chlorocatechol dioxygenase region of Pseudomonas putida GJ31

Pseudomonas putida GJ31 contains an unusual catechol 2,3-dioxygenase that converts 3-chlorocatechol and 3-methylcatechol, which enables the organism to use both chloroaromatics and methylaromatics for growth. A 3.1-kb region of genomic DNA of strain GJ31 containing the gene for this chlorocatechol 2,3-dioxygenase (cbzE) was cloned and sequenced. The cbzE gene appeared to be plasmid localized and was found in a region that also harbors genes encoding a transposase, a ferredoxin that was homologous to XylT, an open reading frame with similarity to a protein of a meta-cleavage pathway with unknown function, and a 2-hydroxymuconic semialdehyde dehydrogenase. CbzE was most similar to catechol 2,3-dioxygenases of the 2.C subfamily of type 1 extradiol dioxygenases (L. D. Eltis and J. T. Bolin, J. Bacteriol. 178:5930-5937, 1996). The substrate range and turnover capacity with 3-chlorocatechol were determined for CbzE and four related catechol 2,3-dioxygenases. The results showed that CbzE was the only enzyme that could productively convert 3-chlorocatechol. Besides, CbzE was less susceptible to inactivation by methylated catechols. Hybrid enzymes that were made of CzbE and the catechol 2, 3-dioxygenase of P. putida UCC2 (TdnC) showed that the resistance of CbzE to suicide inactivation and its substrate specificity were mainly determined by the C-terminal region of the protein.