Effect of fat content on sensory and physico‐chemical properties of laboratory‐pasteurised calcium‐ and vitamin D‐fortified mixture of cow and buffalo milk

The influence of milk fat on physico‐chemical properties of calcium and vitamin D‐fortified milk was investigated. Sensory scores, curd tension, viscosity, rennet coagulation time and TBA value increased with the increase in fat content. Calcium and vitamin D fortification had no effect on sensory scores, whereas a significant increase was observed in curd tension and viscosity. The TBA value of fortified milk was significantly lower than that of the unfortified milk. The rennet coagulation time of milk increased significantly with addition of calcium phosphate, whereas calcium citrate fortification had no significant effect. All milk samples were stable to alcohol.     

Effect of calcium and vitamin D2 fortification on quality characteristics of dahi

Two levels (500 and 600 ppm) of calcium (calcium phosphate and calcium citrate) along with vitamin D₂ (600 IU/L) were fortified in milk for dahi preparation. pH, water‐holding capacity and syneresis of fortified dahi were not affected significantly (P > 0.05). However, acetaldehyde content decreased and setting time increased upon fortification. Microbial count significantly (P < 0.05) decreased in calcium phosphate‐fortified dahi, whereas no difference was observed in calcium citrate‐fortified dahi. Firmness and viscosity decreased in calcium phosphate‐fortified dahi, whereas it increased in calcium citrate‐fortified dahi as compared to control. All dahi samples showed good sensory acceptability.     

Amebic peritonitis

A total of 18 patients with amebic peritonitis were studied. Fourteen of these cases were due to rupture of amebic liver abscess into the peritoneum and the remaining cases were due to perforation of amebic colitis. No initial suspicion of amebic etiology was made in more than half of the cases. In the group of ruptured liver abscesses, nearly half of the patients showed right lower lung syndrome. The diagnosis in 13 of 14 cases of rupture of liver abscess was confirmed on aspiration. Patients with ruptured amebic liver abcess were of two types: 1. Diffuse type with diffuse signs, shorter duration of illness and poor prognosis. 2. Localized type with longer duration of illness, marked signs of peritonitis and better prognosis. Once the diagnosis of peritonitis was made, the management was surgical. Conservative treatment was tried only in cases with signs of localization. The mortality rate had been 33% in amebic liver abscess rupturing into the peritoneum and 75% in perforation of the intestine. A high index of suspicion of amebiasis in patients with an acute abdomen and institution of early treatment are recommended to help in reducing this mortality. Amebic liver abscess and amebic dysentery should be treated energetically to avoid this fatal complication and surgical intervention whenever indicated should not be delayed.     

Adsorption of casein onto alkali treated bentonite

The adsorption measurements of casein onto alkali treated bentonite were performed at room temperature and fixed pH (11.8) with an object to study the mode of casein adsorption at the alkali treated bentonite surfaces. The adsorption isotherm was found to have a Langmuir nature. The adsorption was pH dependent and increased with a decrease in temperature. The adsorption was quite sensitive to the presence of Cl⁻, SO, and PO ions and showed many interesting variations with increasing concentrations of the added anions. Various kinetic and adsorption parameters such as the adsorption coefficient, rate constants for adsorption and desorption, diffusion constant, and penetration rate constant were calculated. © 2000 John Wiley & Sons, Inc. J Appl Polym Sci 78: 1656–1663, 2000     

Biomineralized and chemically synthesized magnetic nanoparticles: A contrast

Magnetic nanoparticles (MNPs) have widely been synthesized through chemical processes for biomedical applications over the past few decades. Recently, a new class of MNPs, known as bacterial magnetosomes, has been isolated from magnetotactic bacteria, a natural source. These magnetosomes are magnetite or greigite nanocrystals which are biomineralized in the bacterial cell and provide magnet-like properties to it. Contrary to MNPs, bacterial magnetosomes are biocompatible, lower in toxicity, and can be easily cleared from the body due to the presence of a phospholipid bilayer around them. They also do not demonstrate aggregation, which makes them highly advantageous. In this review, we have provided an in-depth comparative account of bacterial magnetosomes and chemically synthesized MNPs in terms of their synthesis, properties, and biomedical applications. In addition, we have also provided a contrast on how magnetosomes might have the potential to successfully substitute synthetic MNPs in therapeutic and imaging applications.     

Tungsten Oxide Thin Film Characterizations for Acetone Gas Detection

The gas sensing properties and topology of tungsten oxide thin films deposited by reactive-ion radio frequency magnetron sputtering at room temperature have been investigated. The abnormalities in behaviour of sensing film are observed when acetone gas is flowed over surface. The reduction reaction of surface and oxidation reaction of acetone gas have been studied. As the gas comes in contact with the surface, the molecules tend to reduce the surface, hence decreasing the resistance. The sensing film was annealed to 500 °C for 1 h for the purpose of achieving a suitable grain size for sensing to take place. Operational optimum temperature for sensing has been computed to be 260 °C. A grain size of 7.3 nm has been computed through analysis of AFM image and a film thickness of 100 nm has been calculated through surface profiler. The SEM image of the film demonstrates the grains developed on the surface. The XRD patterns reveal that the oxide showed up as WO₂. It has been observed that the response percentage is approximately 30% for acetone vapour concentration of 20 ppm and approximately 18% for the concentration of 15 ppm. The response time of the sensor is approximately 5 min and the recovery time is 4 min.     

A finite element solution for the two-dimensional elastic contact problems with friction

A numerical procedure developed for solving the two-dimensional elastic contact problems with friction is presented. This is a generalization of a procedure developed by Francavilla and Zienkiewicz to include frictional effects under proportionate loading. The method uses the flexibility matrix obtained by inversion of condensed stiffness matrix formed by eliminating all the nodes except those where contact is likely to take place and those with external forces. Compatibility of displacements for both normal and tangential directions is applied to those nodes which do not slip. However, for the nodes which slip, compatibility of displacements is applied for normal direction only and slip condition is applied in the tangential direction. The technique has been applied to several problems and very good results have been obtained. The number of iterations needed are very small.     

Discrimination of maize crop with hybrid polarimetric RISAT1 data

Microwave remote sensing provides an attractive approach to determine the spatial variability of crop characteristics. Synthetic aperture radar (SAR) image data provide unique possibility of acquiring data in all weather conditions. Several studies have used fully polarimetric data for extracting crop information, but it is limited by swath width. This study aimed to delineate maize crop using single date hybrid dual polarimetric Radar Imaging Satellite (RISAT)-1, Fine Resolution Stripmap mode (FRS)-1 data. Raney decomposition technique was used for explaining different scattering mechanisms of maize crop. Supervised classification on the decomposition image discriminated maize crop from other land-cover features. Results were compared with Resourcesat-2, Linear Imaging Self Scanner (LISS)-III optical sensor derived information. Spatial agreement of 91% was achieved between outputs generated from Resourcesat-2, LISS-III sensor and RISAT-1 data.     

Corrosion behaviour of Terfenol-D

The corrosion behaviour of pseudo-binary compound Tb_0.3Dy_0.7Fe_1.92 (Terfenol-D) was studied in 3.5% NaCl and 0.01 N Na₂SO₄ solutions using Tafel polarisation, linear polarisation, electrochemical impedance spectroscopy and weight loss techniques. Electrochemical testing revealed the adverse effect of chloride ions, as corrosion rates were higher in 3.5% NaCl solutions than in 0.01 N Na₂SO₄ solutions. The effect of aeration was studied by conducting experiments in freely-aerated, deaerated and fully-aerated conditions. Absence of oxygen accelerated corrosion in chloride environment, due to increased hydrogen interaction in presence of destabilised surface films. The improved corrosion resistance in chloride-free environment was correlated with morphological features of the corroded surfaces. Micro-compositional analysis of the corrosion products revealed that the corrosion products were primarily rich in rare earth elements. A comparison of all experimental techniques showed that Tafel extrapolation and EIS techniques provided reliable estimates of corrosion rate.