Zinc nutrition in young Chilean adults

To evaluate the effect of dietary factors on plasma zinc levels, dietary zinc intake was estimated and plasma levels were measured in 37 healthy young adults of low and middle socioeconomic status. Our study included 16 males aged 29 +/- 7 and 21 females aged 26 +/- 6 years. Dietary intake of zinc and protein was determined from a 24-hour dietary recall survey. Plasma zinc was measured by atomic absorption spectrophotometry. Alkaline phosphatase (AP) in plasma was also measured and the weight/height percentage for each subject calculated according to Jelliffe's standards. The average diet was composed of cereals, legumes, eggs, bread and noodles, caloric intake was 2051 +/- 154 kcal/day for men and 1767 +/- 158 (x +/- SD) kcal/day for women. The daily intake of zinc was 8.3 +/- 3.0 mg/day for males, and 9.7 +/- 2.0 mg/day for females. Cereals were the main source of zinc for men, while egg and dairy products were for women. Plasma zinc values were 82 +/- 22 micrograms/dl for men and 94 +/- 19 micrograms/dl for women (p less than 0.01). For the whole group plasma zinc concentration was 89 +/- 21 micrograms/dl. Seven males and two females had low plasma zinc values (70 micrograms/dl or less). Alkaline phosphatase (AP) levels were 110 +/- 10 IU for males and 71 +/- 4 IU for females (p less than 0.001). These values did not correlate with the zinc levels. Average weight/height was 99 +/- 18 for men, and 108 +/- 18 for females. Results indicate that on the average, in our study group plasma zinc levels were within the normal range, although they were significantly lower in men. Dietary intake of zinc was below the recommendations, being higher for women as related to values presented by men. The observed low plasma levels of zinc may be caused by a low intake, and/or poor bioavailability.     

Effect of temperature on the separation of some Δ9-cis-trans isomers of methyl esters of fatty acids by open tubular gas chromatography

The influence of temperature on the gas chromatographic separation ofcis-trans isomers of the methyl esters of some monounsaturated fatty acids was studied on capillary columns coated with Apiezon L, BDS and DEGS. As far as methyl oleate and methyl elaidate are concerned, the separation is better at lower temperatures on Apiezon L (180–210 C) and at higher temperatures on polyester phases (BDS, DEGS; 150–180 C). The influence of temperature on the separation ofcis-trans isomers on the three stationary phases under study is explained by the higher values of δECL/δt forcis isomers. The variation of the equivalent carbon chain length with temperature can be used for the identification ofcis-trans isomers in natural mixtures.     

Influence of maize kernel hardness on flour hydration and cooking properties

Knowledge of the association between cooking properties and endosperm hardness may help nutritionist and processors to select raw materials for preparing maize based food products, particularly those eaten as cooked dispersions. Seven commercial maize cultivars differing in hardness were selected to evaluate endosperm hardness on the kernels and some characteristics such as composition and hydration and cooking properties on the grits obtained from those maizes. Results show that the differences in endosperm hardness (directly related to grits protein content) can explain the differences in swelling and amylographic consistencies values. Cultivars with the hardest endosperm show the lowest values at high temperature. They also show the lowest amylographic consistencies. On the other hand softer endosperms present the highest swelling power and the highest amylographic consistencies. These differences are attributed to the restriction for starch swelling caused by the protein matrix. Endosperm hardness measurements and swelling power at 95 degrees C, can be useful to select cultivars that are going to be used to prepare maize based foods like atoles, polenta, etc.     

The potentiometric behaviour of copolymers of methacrylic acid in water-ethanol solutions

Summary The synthesis is reported of copolymers of styrene with methacrylic acid and of methyl methacrylate with methacrylic acid by radical copolymerization, of copolymers of methyl methacrylate with methacrylic acid by partial alkaline hydrolysis of poly(methyl methacrylate), and of block copolymers of styrene with methacrylic acid. Modified titration curves of all these copolymers were recorded in water and water-ethanol solutions. In a solution containing 50 mass.% ethanol, only small differences could be observed between the potentiometric behaviour of the individual copolymers and polymethacrylic acid. Also, there were no essential differences in any of the solvents used between the potentiometric behaviour of block copolymers of styrene with methacrylic acid, on the one hand, and polymethacrylic acid, on the other. On the contrary, maxima and minima were always observed on the modified titration curves of statistical copolymers with a higher content of the hydrophobic comonomer in solutions with a high water content. Thus, using the modified titration curves, it is possible to decide whether a given copolymer is of the block or statistical type.     

Preparation of silica by acid dissolution of sepiolite and study of its reinforcing effect in elastomers

The preparation of amorphous silica by acid treatment of a natural magnesium silicate and its use as reinforcing filler for NR and SBR compounds are studied. Limited to the treatment with nitric acid, the rate constants at different temperatures and acid concentrations and the activation energy are calculated, as a function of percentage of extracted magnesium. The resulting material is basically an amorphous silica (92.5% SiO₂), as shown by X-ray analysis, that keeps the fibrous morphology of the original mineral. According to a preliminary technological study the resulting silica is a suitable reinforcing filler for general purpose rubbers; a comparison between the experimental results and those obtained with a commercial fine particle precipitated silica was made. Using a SBR compound the effect of silane coupling agents on the new silica was studied.     

Coordinate descent with arbitrary sampling I: algorithms and complexity†

We study the problem of minimizing the sum of a smooth convex function and a convex block-separable regularizer and propose a new randomized coordinate descent method, which we call ALPHA. Our method at every iteration updates a random subset of coordinates, following an arbitrary distribution. No coordinate descent methods capable to handle an arbitrary sampling have been studied in the literature before for this problem. ALPHA is a very flexible algorithm: in special cases, it reduces to deterministic and randomized methods such as gradient descent, coordinate descent, parallel coordinate descent and distributed coordinate descent—both in nonaccelerated and accelerated variants. The variants with arbitrary (or importance) sampling are new. We provide a complexity analysis of ALPHA, from which we deduce as a direct corollary complexity bounds for its many variants, all matching or improving best known bounds.     

The vehicle routing problem with restricted mixing of deliveries and pickups

The vehicle routing problem with deliveries and pickups is one of the main problems within reverse logistics. This paper focuses on an important assumption that divides the literature on the topic, namely the restriction that all deliveries must be completed before pickups can be made. A generalised model is presented, together with a mathematical formulation and its resolution. The latter is carried out by adopting a suitable implementation of the reactive tabu search metaheuristic. Results show that significant savings can be achieved by allowing a mixture of delivery and pickup loads on-board and yet not incurring delays and driver inconvenience.     

P distribution in different sediment fraction of a constructed wetland

The aim of this work was to study the accumulation and fractionation of P in the inlet and outlet sediment of a constructed wetland for the wastewater treatment of a metallurgic plant in Argentina. It was important to predict whether P could be released into the water again by changing environmental conditions or retained over time. P-fractionation was performed using a sequential extraction method. Sediment cores were sliced at depths of: 0-3; 3-7 and 7-10 cm. Sediment showed high pH values and anoxic conditions. In the inlet area, P was principally bound to the carbonate fraction, whereas in the outlet area, it was mainly bound in the residual fraction. This behavior was justified by the effluent composition, which is rich in Ca2+ and Fe3+ and presents high values of pH and conductivity. These conditions favor CaCO3 and Fe(OOH)n precipitation and the subsequent sorption of P to their surface. The sediment active layer involved in the exchange reactions was the superficial one (0-3 cm). The wetland is highly efficient in P retention. P was retained by sediment in fractions that will not release it to the water while chemical and environmental conditions of the system are maintained.