Estimation and Optimization of the Principal H-Maser Parameters

The scale along the coordinate axes in the equations of motion hitherto used for an H-maser (in relative units) is shown to depend on Q as the quality factor for an H-maser. This hinders both analysis of the operation of the H-maser and optimization of its parameters. The modified equations of motion proposed here do not have that shortcoming. We determine the atomic flux into the bulb that gives the H-maser the best metrological characteristics.     

Evanescently coupled photodiodes integrating a double-stage taper for 40-Gb/s applications-compared performance with side-illuminated photodiodes

The design, fabrication, and performance of double-stage taper photodiodes (DSTPs) are reported. The objective of this work is to develop devices compatible with 40-Gb/s applications. Such devices require high efficiency, ultrawide band, high optical power handling capability, and compatibility with low-cost module fabrication. The integration of mode size converters improves both the coupling efficiency and the responsivity with a large fiber mode diameter. Responsivity of 0.6 A/W and 0.45 A/W are achieved with a 6-/spl mu/m fiber mode diameter and cleaved fiber, respectively, providing relaxed alignment tolerances (/spl plusmn/1.6 /spl mu/m and /spl plusmn/2 /spl mu/m, respectively), compatible with cost-effective packaging techniques. DSTPs also offer a wide bandwidth greater than 40 GHz and transverse-electric/transverse-magnetic polarization dependence lower than 0.2 dB. Furthermore, a DSTP saturation current as high as 11 mA results in optical power handling greater than +10 dBm and a high output voltage of 0.8 V. These capabilities allow the photodiode to drive the decision circuit without the need of a broad-band electrical amplifier. The DSTP devices presented here demonstrate higher responsivities with large fiber mode diameter and better optical power handling capabilities and are compared with classical side-illuminated photodiodes.     

An optical instrumentation using a sensor with a sensordummyagainst noises on sensor and transmission line

This short paper discusses the method of effectively canceling equal status normal mode noise not only on a sensor line but also on a transmission line of an optical instrument using a sensor with a sensordummy resistance     

1/f noise sources

This survey deals with 1/f noise in homogeneous semiconductor samples. A distinction is made between mobility noise and number noise. It is shown that there always is mobility noise with an α value with a magnitude in the order of 10^-4. Damaging the crystal has a strong influence on α, α may increase by orders of magnitude. Some theoretical models are briefly discussed none of them can explain all experimental results. The α values of several semiconductors are given. These values can be used in calculations of 1/f noise in devices     

Metal diffraction gratings as laser power or energy dividers

The authors survey published results on the application of metal diffraction gratings as laser power or energy dividers when the laser beam is split into two approximately equal pans. The normal incidence of laser radiation on metal diffraction gratings of various profiles in the case of three propagating diffraction orders n=0, ±1 is discussed, along with the case of oblique incidence with only two propagating diffraction orders n=0 and n =–1.Translated from Izmeritel'naya Tekhnika, No. 2, pp. 22–26, February, 1994.     

Effect of pulse time gate on CsI(T1) light output

The mass and charge identification of secondary particles with Z < 4 by a large CsI(T1) scintillation detector is performed using pulse shape analysis and time-of-flight methods. The dependence of the light output on E, A and Z is studied in the energy range of 1–20 MeV/A and special attention is paid to the integration time of the photomultiplier anode signal. It is found that the behaviour of the calibration curves strongly depends on the choice of the integration time interval.     

Serum vanadium levels in chronic hemodialysis patients

Serum vanadium, aluminum, silicon and beta 2-microglobulin levels as well as the red cell count, hemoglobin and systolic blood pressure were simultaneously measured in 80 chronic hemodialysis patients. The serum vanadium level was positively correlated with the serum levels of aluminum, silicon and beta 2-microglobulin as well as the systolic blood pressure, and was inversely correlated with the red cell count and hemoglobin. The mean serum vanadium level was 18.4 +/- 7.6 ng/ml before hemodialysis and decreased to 13.0 +/- 5.30 ng/ml at the completion of dialysis. The dialysate vanadium level increased from 0.4 +/- 0.2 (inflow) to 1.0 +/- 0.4 ng/ml (outflow). It was concluded that vanadium was transferred from blood to dialysate when purified water was used in the preparation of the dialysate.     

The pharmacokinetics of pancuronium bromide in infants, children and adults

Laparoscopic retroperitoneal lymph node dissection is a new surgical procedure used to enhance staging in men with clinical stage I nonseminomatous germ cell tumors of the testis. The procedure has been performed in a limited number of patients at several centers with extensive laparoscopic experience. Laparoscopic retroperitoneal lymphadenectomy is a technically demanding procedure which can be successfully completed in the majority of patients. However, the risk of complications is greater than in patients who undergo standard open retroperitoneal lymph node dissection. The primary advantage of a laparoscopic approach is shortened hospitalization and rapid return to normal activity. The role of laparoscopy in the management of patients with testis malignancy has not been defined. The use of this staging procedure may help minimize the need for surveillance studies following surgery and may be best utilized in men with a lower likelihood of nodal metastases. Ultimately, prospective study in large groups of patients will be necessary to determine the role of laparoscopic retroperitoneal lymph node dissection in patients with testis cancer.     

Control of stroma-dependent hematopoiesis by basic fibroblast growth factor: stromal phenotypic plasticity and modified myelopoietic functions

The immunological agglutination reactions of physically absorbed F(ab')2 molecules onto anionic and cationic latex particles have been investigated by means of optical absorbance measurements. These measurements have been conducted under different conditions to determine the most influential factors. Surface F(ab')2 and BSA densities, particle concentration in the reaction medium and polyethylene glycol concentration are some of these factors. Sensitized cationic and anionic latexes differ considerably with respect to their colloidal stability and reactivity. As a general rule, the sensitized cationic latex has a relatively higher colloidal stability and hence, it provides reagents with a better optical response. Less than 0.025 microgram/ml of C-reactive protein has been detected using this particle enhanced optical immunoassay.