高强度炮钢的断裂韧度

近代火炮在服役期内有相当长的一段时间是在身管内膛存在裂纹的情况下使用的。裂纹的生成、扩展及断裂恰好为断裂韧度（ＫＩＣ）所描述。ＫＩＣ值对炮管材质及生产工艺的偏差也十分敏感，为检验产品质量的有效指标。所以，ＫＩＣ值已成为高强度炮钢机械性能中的一项重要指标。但ＫＩＣ值的量化和在工程设计中的应用是一个复杂的问题。概述了近代火炮的特点、炮钢ＫＩＣ值的意义并通过模拟试验与实弹射击试验将ＫＩＣ值进行标定，使之成为工程设计上控制火炮质量的定量指标。     

Rational approximation via selective modal analysis

We describe a recently developed framework for exploring the structure of linear time-invariant models of large systems, and for constructing interpretable or physically-based, reduced-order models that reproduce selected modes of the original systems to a desired accuracy. Application of this framework to constructing lumped approximations for interconnections of lumped and distributed systems is briefly explored.Support for this work has come partially from the Electric Power Research Institute, Palo Alto, California, under Contract RP 1764-8 monitored by Dr. Neal Balu, and for the second author from the I.T.P. Foundation, Madrid, Spain.     

Integrated optic electrooptic modulator electrode analysis

Integrated optical (IO) switches and modulators are based on the electrooptic effect obtained by applying a voltage between electrodes fabricated on the surface of a crystal (for example, LiNbO3). In this paper, we calculate the change in the optical propagation constant in single modeZ-cut LiNbO3:Ti-diffused waveguides for a variety of electrode configurations. These calculations are compared to experimental data from IO devices. The calculations predict the observed variations in switching voltage with wavelength and electrode separation.     

Intelligible Crosstalk Between Two FDM/FM Carriers Accessing Double Cascaded Nonlinear Amplifiers

A method of evaluating double intelligible crosstalk between two frequency division multiplexed frequency modulated (FDM/FM) carriers accessing the same earth station high-power amplifier (HPA) and satellite transponder traveling wave tube amplifier (TWTA) has been developed. The analysis takes into consideration the AM/AM and AM/PM characteristics of the two cascaded memoryless nonlinear amplifiers, and the amplitude and group delay variations of transmission paths preceding the first nonlinear amplifier and of the path between the two nonlinear amplifiers. Results of the double intelligible crosstalk evaluation show the existence of significant distortion cross terms caused by the two cascaded nonlinearities and filters, in addition to individual distortion terms by each nonlinearity. Specific illustrative examples are discussed, and some practical suggestions are given for controlling crosstalk impairment effects in satellite channels with double cascaded nonlinear amplifiers.     

Radiation cones from feed-support struts of symmetric paraboloidal antennas

Wide-angle radiation associated with the plane-wave component of the field in the focal space of a paraboloidal reflector is computed by integrating the currents induced on the feed-support struts. This component of radiation is locally maximum on radiation cones which lie along the axis of each strut. Comparison with data measured for the Dwingeloo radio telescope indicates good agreement for the position, width, and intensity of these cones, even at levels 50 dB below the peak of the main beam.     

High-strength small reinforcement for spliced optical fibre

A high-strength small reinforcement using a nylon and a steel wire has been developed. The size of the reinforcement is 1 mm in diameter and 35 mm in length. An average tensile strength of 5.4 kg has been achieved with negligible loss increase.     

New chemical etching solution for InP and GaInAsP gratings

A new chemical etching solution of bromine-water system, which is suitable for transforming the fine resist grating mask pattern onto InP and GaInAsP surfaces, is reported. The Br2:H2O:H3PO4 (or HCl) solution does not dissolve AZ 1350 photoresist and exhibits both moderate etching rate and a pit-free etched surface.     

Carbon in silicon: Properties and impact on devices

The properties, origin and analysis of carbon in silicon and its influence on the electrical characteristics of devices are investigated and reviewed. The typical carbon concentrations in electronic-grade silicon are still some 10¹⁶ cm^?3. The small distribution coefficient (k₀ = 0.058) causes an inhomogeneous incorporation of carbon along the crystal axis and across the crystal diameter during crystal growth. Carbon concentrations exceeding about 5 × 10¹⁶ cm^?3 in float-zoned silicon can lead to the formation of process-induced defects in the fabrication of power rectifiers and thyristors. These defects which are frequently arranged in a swirl-like pattern strongly deteriorate the electrical characteristics of these devices. It is shown that carbon is involved primarily in the generation of the defect nuclei whereas the defects finally observed form via precipitation of oxygen and agglomeration of silicon interstitials. Reasons for the benign behavior of high carbon concentrations in the processing of integrated circuits are discussed. In powder device processing the formation of carbon-induced defects is safely avoided by application of silicon containing carbon less than 5 × 10¹⁶ cm^?3.     

Dietary linoleic acid and polyunsaturated fatty acids in rat brain and other organs. Minimal requirements of linoleic acid

Starting three weeks before mating, 12 groups of female rats were fed different amounts of linoleic acid (18∶2n−6). Their male pups were killed when 21-days-old. Varying the dietary 18∶2n−6 content between 150 and 6200 mg/100 g food intake had the following results. Linoleic acid levels remained very low in brain, myelin, synaptosomes, and retina. In contrast, 18∶2n−6 levels increased in sciatic nerve. In heart, linoleic acid levels were high, but were not related to dietary linoleic acid intake. Levels of 18∶2n−6 were significantly increased in liver, lung, kidney, and testicle and were even higher in muscle and adipose tissue. On the other hand, in heart a constant amount of 18∶2n−6 was found at a low level of dietary 18∶2n−6. Constant levels of arachidonic acid (20∶4n−6) were reached at 150 mg/100 g diet in all nerve structures, and at 300 mg/100g diet in testicle and muscle, at 800 mg/100 g diet in kidney, and at 1200 mg/100 g diet in liver, lung, and heart. Constant adrenic acid (22∶4n−6) levels were obtained at 150, 900, and 1200 mg/100 g diet in myelin, sciatic nerve, and brain, respectively. Minimal levels were difficult to determine. In all fractions examined accumulation of docosapentaenoic acid (22∶5n−6) was the most direct and specific consequence of increasing amounts of dietary 18∶2n−6. Tissue eicosapentaenoic acid (20∶5n−3) and 22∶5n−3 levels were relatively independent of dietary 18∶2n−6 intake, except in lung, liver, and kidney. In several organs (muscle, lung, kidney, liver, heart) as well as in myelin, very low levels of dietary linoleic acid led to an increase in 20∶5n−3. Dietary requirements for 18∶2n−6 varied from 150 to 1200 mg/100 g food intake, depending on the organ and the nature of the tissue fatty acid. Therefore, the minimum dietary requirement is estimated to be about 1200 mg/100 g (i.e., the level that ensures stable and constant amounts of arachidonic acid).