Residual phase noise measurements of VHF, UHF, and microwavecomponents

The results of residual phase noise measurements on a number of VHF, UHF, and microwave amplifiers, both silicon (Si) bipolar junction transistor (BJT) and gallium arsenide (GaAs) field effect transistor (FET) based, electronic phase shifters, frequency dividers and multipliers, etc., which are commonly used in a wide variety of frequency source and synthesizer applications are presented. The measurement technique has also been used to evaluate feedback oscillator components, such as the loop and buffer amplifiers, which can play important roles in determining an oscillator's output phase noise spectrum (often in very subtle ways). While some information has previously been published related to component residual phase noise properties, it generally focused on the flicker noise levels of the devices under test, for carrier offset frequencies less than 10 kHz. The work reported herein makes use of an extremely low noise, 500 MHz surface acoustic wave resonator oscillator (SAWRO) test source for residual phase noise measurements, both close-to-and far-from-the-carrier. Using this SAWRO-based test source at 500 MHz, we have been able to achieve a measurement system phase noise floor of -184 dBc/Hz, or better, for carrier offset frequencies greater than 10 kHz, and a system flicker phase noise floor of -150 dBc/Hz, or better, at 1 Hz carrier offset. The paper discusses the results of detailed residual phase noise measurements performed on a number of components using this overall system configuration. Several interesting observations related to the residual phase noise properties of moderate to high power RF amplifiers, i.e., amplifiers with 1 dB gain compression points in the range of +20 to +33 dBm, are highlighted     

Frequency-domain characterization of Kalman filters as applied topower system protection

So far, all tests on Kalman filters have been performed in the time domain. However, it is shown that conventional signal-processing tools such as frequency response can be successfully applied for the performance analysis. The concept of frequency response as applied to Kalman filters is based on its variation with time. Consequently, it is defined with respect to a definite observation window. It is also shown that the ratio of the initial error covariance matrix terms to the measurement noise variance, not the absolute values, is the relevant statistical quantity. The same principle applies to the ratio of the process noise covariance matrix diagonal terms to the noise measurement variance     

Effects of different energy levels, concentrate/forage ratios and lipid supplementation to the diet on the adaptation of the energy metabolism at calving in dairy cows

A low level of energy (110 MJ ME) and a low concentrate/forage ratio (10/90) at calving resulted in low basal concentrations of glucose and insulin, but the cows had the capacity to increase the glucose level after glucagon injections. No signs of disturbances in the metabolic adaptation were observed. High intensity feeding (200 MJ ME and 50% concentrates) resulted in high basal serum insulin levels. The increase in the insulin concentrations after glucagon injections and the changes in insulin levels around calving varied widely between individual cows. The metabolic adaptation period was longer than in cows in the former group. An energy level of 170 MJ ME and variations of concentrate/forage ratios (5/95, 30/70 and 60/40) resulted in small differences in basal glucose and insulin concentrations and in response to glucagon injections. But the cows fed 60% concentrates showed signs of prolonged metabolic adaptation. Increased lipid concentrations in diets containing equal levels of energy and protein resulted in a fall in basal glucose and insulin levels and the metabolism seemed to be directed towards catabolism. Because of these metabolic effects, more needs to be known on fat supplementation if it is used in practical feeding. It is also necessary to take more interest in the effects of protein feeding on the periparturient metabolism.     

Design and characterization of a mode-splitting Ψ-junction

It will he shown In this paper, that the mode conversion factor (MCF) as defined for Y-junctions, can be profitably applied for the design of three branch junctions for splitting the three lowest-order modes of a channel waveguide. Accordingly, these so-called mode-splitting Ψ-junctions were designed for implementation in PECVD SiON-technology. Propagation calculations point to crosstalk levels well below -20 dB at 10-20 mm junction length. The produced Ψ-junctions show crosstalk of less than -17 dB, mainly originating from the nonhomogeneity of the refractive indexes of the SiON layers