Active Monitoring of Thermal Insulation Protection Status of Pipelines

Refractories and Industrial Ceramics - The article discusses the temperature regimes of transit pipelines for steam and hot water movement. A new device for thermal insulation of high-temperature...     

Exploring the Biosynthesized Metal Nanoparticles for their Catalytic Degradation of Toxic Water Wastes and Antimicrobial Potential

Journal of Inorganic and Organometallic Polymers and Materials - In recent decades, the analysis of nanoparticles is of greater importance for their applications in various fields. This present...     

Experimental investigation of lift enhancement by suction-assisted delayed separation of the boundary layer on NACA 0012 airfoil

In the aerodynamic industry, one of the major problems of interest is the lift enhancement without any increase in the drag. In this paper, an attempt is made to increase the lift coefficient by delayed boundary layer separation using suction at various points, also the study is carried out to identify the optimum location for suction which provides maximum lift augmentation. The experiment is conducted with selected suction pressures of 60, 70, 80, 90?kN/m² at different locations in the range of 40–75% of the chord length of the airfoil. Among the selected pressures, the lowest one at the 70% length provides maximum performance. The critical Reynolds number occurs at around 95% of the length instead of 45% of the length when the same experiment is conducted without suction. The suction also assists in the heat transfer enhancement over the airfoil surface.     

Effect of Heat Treatment on Dendritic Segregation and High-Temperature Strength of Single Crystals of Ni3Al-Base Rhenium-Alloyed Intermetallic Alloys

Metal Science and Heat Treatment - The nature of stability of dendritic microsegregation of rhenium in single crystals of intermetallic (γ′ + γ) alloys based on γ′-Ni3Al...     

Simulation of the Kinetics of Dynamic Recrystallization of Alloy KhN55MBYu-VD During Hot Deformation

Metal Science and Heat Treatment - A facility for physical simulation is used to plot dependences of flow stress on the degree of deformation in the temperature range from 1000 to 1230°C at...     

Polymerization of propylene in liquid monomer using state-of-the-art high-performance titanium-magnesium catalysts

A comparative study of propylene polymerization in liquid monomer is performed under laboratory conditions using the IK-8-21 Ti-Mg catalyst designed at the Boreskov Institute of Catalysis and imported industrial catalysts (conditionally labeled TMC-1, -2, and -3). The activity and stereospecificity of the catalysts are estimated along with properties of the resulting polypropylene (granular composition and physicomechanical characteristics). It is shown that the IK-8-21 catalyst is not inferior to imported counterparts in terms of catalytic properties in the synthesis of polypropylene. The polypropylene powder formed on IK-8-21 is homogeneous and has good morphology. The physicomechanical characteristics of polypropylene synthesized on the domestic IK-8-21 catalyst are similar to those for polypropylene prepared with the imported TMK-1 catalyst.     

Feasibility of Using Titanium Machine Turnings in Powder Metallurgy Processes

JOM - The use of titanium machine turnings has been identified as a possible ultralow-cost method to produce titanium powder. However, very little data are available on the viability of this...     

Absolute Isotherms of Adsorption of Components of Binary Liquid Solutions of Macro- and Microporous Adsorbents

Protection of Metals and Physical Chemistry of Surfaces - The methods of describing absolute adsorption isotherms of binary nonelectrolyte solutions components on macro- and microporous adsorbents...