Electrophoretic deposition of graphene oxide on carbon brush as bioanode for microbial fuel cell operated with real wastewater

Microbial fuel cell (MFC) is a promising technology for simultaneous wastewater treatment and energy harvesting. The properties of the anode material play a critical role in the performance of the MFC. In this study, graphene oxide was prepared by a modified hummer's method. A thin layer of graphene oxide was incorporated on the carbon brush using an electrophoretic technique. The deoxygenated graphene oxide formed on the surface of the carbon brush (RGO-CB) was investigated as a bio-anode in MFC operated with real wastewater. The performance of the MFC using the RGO-CB was compared with that using plain carbon brush anode (PCB). Results showed that electrophoretic deposition of graphene oxide on the surface of carbon brush significantly enhanced the performance of the MFC, where the power density increased more than 10 times (from 33 mWm^?2 to 381 mWm^?2). Although the COD removal was nearly similar for the two MFCs, i.e., with PCB and RGO-CB; the columbic efficiency significantly increased in the case of RGO-CB anode. The improved performance in the case of the modified electrode was related to the role of the graphene in improving the electron transfer from the microorganism to the anode surface, as confirmed from the electrochemical impedance spectroscopy measurements.     

Compact UWB-MIMO Triple Notched Antenna for Isolation Reduction

Wireless Personal Communications - In this article compact multiple input multiple output (MIMO) antenna with triple notch at the ultra-wideband application having two identical monopole antennas...     

The Possibility of Dense Materials Based on Obtaining an AlN–SiC Solid Solution by Self-Propagating High-Temperature Synthesis Gasostating

Russian Journal of Non-Ferrous Metals - The synthesis and sintering of the (AlN)x(SiC)1 – x solid solution have been studied under conditions of self-propagating high-temperature synthesis...     

Design and Optimization of Thick-Walled Cylinders with Load Localization Near the End Face

Strength of Materials - The paper presents a procedure for determining the design parameters of multilayer thick-walled structures with a local load on the inner surface portion located near the...     

3D Investigation of 8-nm Tapered n-FinFET Model

The miniaturization has become a key word for advanced integrated circuits over the last few years. It is within this context that the fin field effect tra     

A practical Equivalent Electrical Circuit model for Proton Exchange Membrane Fuel Cell (PEMFC) systems

An alternative Equivalent Electrical Circuit for Proton Exchange Membrane Fuel Cells is modelled in this study. Both I–V characteristics and H₂ consumptions corresponding to generated power under load and no-load conditions are investigated. For this purpose, H₂ consumptions and I–V characteristics of three different sized PEMFCs are tested. There is a very good harmony between the model results and measured values (relative error %0.7, %6.4 and %2.5 for FC-A, FC-B and FC-C respectively). In the proposed model current passes only on parallel resistance and not on serial resistance at no-load condition. Thus, a FC with higher parallel resistance should be preferred. Another key output of this study is that based on the proposed model, performance comparison of FCs can be performed with the parameters defined in this work. Proposals made in this study can easily be used for performance analysis of FCs under for both steady state and transient analysis.     

Viscosity of Fe90B x Si(10 − x) melts

High Temperature - The temperature dependences of the viscosity of liquid Fe90B x Si(10 − x) alloys are studied in the mode of heating and subsequent cooling. The temperature dependences of...