Finite element study of the effect of material properties on reaction forces produced by solitary wave propagation in granular chains

The response of a granular chain to impulse loading was investigated as a function of material properties. Using COMSOL Multiphysics, the elastic modulus and density of the grains were varied while the piston and force sensor properties remained fixed. The result of solitary wave propagation through the granular chain was recorded at the force sensor as a series of reaction force waves. It was found that wave velocity and amplitude increased with elastic modulus. Increasing density caused a decrease in wave velocity and an increase in amplitude. In addition, higher density granular chains exhibited a decrease in the number of waves in their respective reaction force wave trains. LS-DYNA was then used to explore the response of a variety of ceramic and metallic granular chains. Density, elastic modulus, and Poisson’s ratio were all set to representative values for the respective material. It was found that solitary wave development and decay occurred at different rates for different materials. In addition, the kinetic energy decay of the impactor was slower for glass compared with tungsten. Finally, it was shown that a single reaction force wave with no train could be produced by impacting a high density, high modulus chain such as tungsten with a glass piston, which has relatively low density and elastic modulus. Increasing impact velocity for this case resulted in a single high-amplitude wave with no train.     

Systems and Virtualization Management: Standards and the Cloud. A report on SVM 2013

Hosted by the Distributed Management Task Force (DMTF) and collocated with the International Conference on Network and Service Management, SVM 2013 was the seventh International DMTF Academic Alliance Workshop on Systems and Virtualization Management (SVM). SVM 2013 was held in Zurich, Switzerland on October 18, 2013. Featuring seven presentations surrounding cloud, OpenSAF, open standards, and CIM, SVM 2013 also included a joint poster session with another workshop, an invited talk by a guest speaker, a keynote speech given by the DMTF President, Jeff Hilland, and closed with an informal interactive group discussion.     

磷酸硼对樟子松的阻燃影响

采用磷酸硼对木材进行改性处理,测定了处理后试材的阻燃性、抗流失性、吸湿性、力学性能.研究结果表明,磷酸硼处理后试材,吸药量达到20.47 kg/m3以上时,垂直燃烧实验可达到到F-0级水平；通过灼烧实验,磷酸硼处理的木粉在500℃灼烧时残留率可达到97.997％;此改性剂具有较好阻燃性能和一定的抗流失性,常压下磷酸硼处理的樟子松试件LRV为50.28％；木材顺纹抗压强度平均下降了 8.67％,无明显变化;木材抗弯曲压强度平均下降了 27.95％.但磷酸硼阻燃剂在高湿条件下有一定的吸湿性,使用性能有待改进,并应注意采取防护措施.     

2,4,6-三甲基苯乙酸的合成新方法

以2,4,6-三甲基苯甲醛为原料,通过相转移催化反应在水-氯仿体系中先合成α-羟基-2,4,6-三甲基苯乙酸(收率52%);再通过次磷酸还原α-羟基-2,4,6-三甲基苯乙酸得到最终产物2,4,6-三甲基苯乙酸(收率91%)。此法绿色便捷,成本相对较低。     

稀土与L-酪氨酸甘氨酸三元固态配合物的合成与表征

在乙醇溶液中合成了四种稀土与 L-酪氨酸、甘氨酸的三元固态配合物 RE( Tyr) 1.5 ( Gly) 4 ( Cl O4) 3( RE=La3+、Ce3+、Gd3+、Y3+) ,并通过摩尔电导、热分析、红外光谱等进行了表征。     

Minor components ofLesquerella fendleri seed oil

Routine analysis of fatty ester fractions ofLesquerella fendleri oil suggested the presence of epoxy compounds and other minor components. By a combination of open silica column and high performance liquid chromatography (HPLC) fractionations of the methyl esters prepared from the oil, these constitutents were isolated and then characterized by thin-layer chromatography-mass spectrometry (GC-MS—electron ionization, EI, and chemical ionization, CI) and nuclear magnetic resonance (NMR—¹H and¹³C). Three epoxy acids, 15,16-epoxy-9,12-octadecadienoic, 9,10-epoxy-12-octadecenoic and 9,10-epoxy-octadecanoic, were found. Hydroxy acids present included a C-22 homologue of lesquerolic acid (16-hydroxy-12-docosenoic acid) and 14,15-dihydroxy-tricosanoic acid. Other minor ocmponents included four sterols, brassicasterol, campesterol, β-sitosterol and stigmasterol, and a series of saturated and unsaturated fatty acids up to C30. Visiting postdoctoral scientist sponsored by the government of India.     

Friction stir scribe welding technique for dissimilar joining of aluminium and galvanised steel

Friction stir scribe technology, a derivative of friction stir welding, was applied for the dissimilar lap welding of an aluminium alloy and galvanised mild steel sheets. During the process, the rotating tool with a cobalt steel scribe first penetrated the top material – aluminium – and then the scribe cuts the bottom material – steel. The steel was displaced into the upper material to produce a characteristic hook feature. Lap welds were shear tested, and their fracture paths were studied. Welding parameters affected the welding features, including hook height, which turned out to be highly related to fracture position. Therefore, in this paper, the relationships among welding parameters, hook height, joint strength and fracture position are presented. In addition, the influence of zinc coating on joint strength was also studied.     

H∞混合灵敏度控制在主汽压系统中的应用

主蒸汽压力是电厂热工过程控制中的重要参数,由于锅炉燃烧工况变化较大,主汽压对象模型具有不确定性,常规控制方法很难得到预期的控制效果。为提高系统控制品质,提出了主汽压系统的H∞混合灵敏度设计方法,给出了选择加权函数的具体方法,采用MATLAB软件进行仿真计算,得到H∞最优控制器。仿真结果表明,在对象模型参数发生较大变化时,与常规PID调节方法相比,H∞最优控制器能使主汽压控制系统具有良好的鲁棒稳定性和动态性能。     

New Standards Release Sets Stage for 5G Future

Over the past year or so,wireless companies have begun to roll out fifth-generation (5G),the latest generation wireless network[1].For today's consumers,moving ...     

Tributary confluences are dynamic thermal refuges for a juvenile salmonid in a warming river network

As rivers warm, cold‐water fish species may alleviate thermal stress by moving into localized thermal refuges such as cold‐water plumes created by cool tributary inflows. We quantified use of two tributary confluence plumes by juvenile steelhead, Oncorhynchus mykiss, throughout the summer, including how trout positioned themselves in relation to temperature within confluence plumes. At two confluences, Cedar and Elder creeks, along the South Fork Eel River, California, USA, we monitored temperatures using in situ logger grids throughout summer 2016. Fish were counted within confluences via snorkel surveys five times a day on 5 days at each site. We found diel and seasonal dependence on confluence use by steelhead, especially at the Cedar Creek confluence, where mainstem temperatures exceeded 28°C. At this site, fish moved into the confluence on the warmest days and warmest times of the day. Fish observed within the Cedar Creek confluence plume were most common in locations between 20–22°C, rather than the coldest locations (14.5°C). At Elder Creek, where mainstem temperatures remained below 24°C, there was little relationship between mainstem temperature and steelhead presence in the confluence plume. At both sites, steelhead distribution within plumes was influenced by spatial variation of temperature and mean temperature in surveyed grid cells. Our results show that cool tributaries flowing into warmer mainstem reaches (over 24°C) likely create important thermal refuges for juvenile steelhead. As mainstem rivers warm with climate change, cool‐water tributary inputs may become more important for sustaining cold‐water salmonids near the southern end of their range.