Effects of pancreatic polypeptide amylin on ulceration and acid gastric secretion

The effects of the pancreatic polypeptide amyline on ulceration and acid gastric secretion were studied in rat experiments. Pyloric ligation was used as a model of ulceration. Amyline administration caused significantly less gastric mucosal damage in response to pyloric ligation. The severity of gastric mucosal damage averaged 47 +/- 13 mm2 in the control group and 25 +/- 11 mm2 (p < 0.005). The rate of acid gastric secretion in the animals whose pylorus had been ligated as judged by the pH of gastric content was significantly higher than that in the controls (2.87 +/- 0.22 and 2.34 +/- 0.17 (p = 0.05). It is concluded that amyline has a noticeable effect on the gastric mucosa. It is suggested that suppressed acid gastric secretion, i.e. reduced influence of aggressive agents on the gastric mucosa, is a mechanism of antiulcerative action of the peptide.     

X-ray topographic analysis of dislocation line defectsin calcium fluoride crystals

One-to-one correspondence of dislocation etch pits have been established on the matched cleavage faces and on the opposite sides of thin flakes of calcium fluoride crystals. By selecting 022 and 022 reflections and MoKα₁ radiation, stereopair projection x-rays topographs were studied and critically compared with optical micrographs. The dislocation etch pits and dislocation out crop images show a close resemblance. The orientation of the Burgers vectors of the dislocation lines has been identified and these lines lie parallel to the <110> directions. The growth history of the stratigraphical pattern has been studied using x-ray topographic technique.     

Behavior of Compacted Lunar Simulants Using New Vacuum Triaxial Device

Development and study of mechanical properties of engineering materials from locally available materials in space is a vital endeavor toward establishment of bases on the Moon and other planets. The objectives of this study are to create a lunar simulant locally from a basaltic rock, and to design and develop a new vacuum triaxial test device that can permit testing of compacted lunar simulant under cyclic loading with different levels of initial vacuum. Then, triaxial testing is performed in the device itself without removing the compacted specimen; this is achieved by a special mechanism installed within the device. Preliminary constrained compression and triaxial shear tests are performed to identify effects of initial confinements and vacuums. The results are used to define deformation and strength parameters. At this time, vacuum levels up to 10?4 are possible; subsequent research should involve higher vacuum levels, e.g., 10?14?torr as they occur on the Moon. The research can have significant potential toward development of methodology so as to develop compacted materials for various construction applications, and also toward stress‐strain‐strength testing of lunar simulants with different vacuum levels.     

High-volume aspiration as a supplemental scavenging method for reducing ambient nitrous oxide levels in the operatory: a laboratory study

Occupational exposure to low levels of nitrous oxide (N2O) have been associated with adverse health effects. The National Institute for Occupational Safety and Health has established a threshold guideline of 25 ppm N2O. The purpose of this laboratory study was to determine the effectiveness of a high-volume dental aspirator as a supplemental device to reduce ambient N2O levels in the operatory. The investigation evaluated four experimental groups that were assigned based on whether or not the aspirator was used and on the rate at which operatory ventilation was established (5 or 10 room air exchanges per hour). Ambient N2O levels were monitored at 30 cm from the nasal hood using an infrared spectrophotometer. The room air exchange rate was measured with a flow hood and then manipulated to the desired ventilation rate. N2O levels were detected with a spectrophotometer and data were recorded with a microprocessor that continuously collected data. The results demonstrated that both utilization of supplemental oral aspiration and increased operatory ventilation significantly reduced ambient N2O levels. It was concluded that a high-volume aspirator, when used in conjunction with the normal scavenging system, can significantly reduce ambient N2O levels to within the guidelines established by the National Institute for Occupational Safety and Health.     

Detection of apoptosis in human and rat ovarian follicles

OBJECTIVE: The purpose of this study was to determine whether cells acquired from individual human preovulatory follicles undergo apoptosis (physiologic cell death) and, if so, to correlate the degree of apoptosis with characteristics of the follicles or the oocytes derived from the follicles. METHODS: We devised a sensitive nonradioactive method for detecting apoptotic DNA fragmentation in small numbers of cells derived from rat atretic follicles and follicular aspirates of patients undergoing assisted reproductive technologies. RESULTS: Using this method, apoptotic DNA was detected in rat atretic follicles, with optimal detection at 10-100 ng. Furthermore, apoptotic DNA was detected in some, but not all individual human follicular aspirates from several patients, and was found in follicles that produced oocytes that fertilized and developed into embryos. CONCLUSION: Apoptosis occurs in cells from human ovarian preovulatory follicles and may be a normal physiologic process of the follicle during luteinization.     

The effect of aluminum hydroxide dissolution on the bleeding of aluminum lake dyes

The effect of pH on the bleeding of FD&C yellow No. 5 aluminum lake and FD&C red No. 40 aluminum lake was investigated. The pH-bleeding profiles corresponded to the pH-solubility profile of aluminum hydroxide. The similarity of the bleeding profiles of both lake dyes and the pH-solubility profile of aluminum hydroxide indicates that pH related bleeding, other than that occurring by competition with anions, is a result of dissolution of the aluminum hydroxide substrate. This dissolution is related to the properties of the substrate rather than to the structure of adsorbed dye.