Development of mobile miniature natural gas liquefiers

With increasing consumption of natural gas (NG), small NG reservoirs, such as coalbed methane and oil field associated gas, have recently drawn significant attention. Owing to their special characteristics (e.g., scattered distribution and small output), small-scale NG liquefiers are highly required. Similarly, the mixed refrigerant cycle (MRC) is suitable for small-scale liquefaction systems due to its moderate complexity and power consumption. In consideration of the above, this paper reviews the development of mobile miniature NG liquefiers in Technical Institute of Physics and Chemistry (TIPC), China. To effectively liquefy the scattered NG and overcome the drawbacks of existing technologies, three main improvements, i.e., low-pressure MRC process driven by oil-lubricated screw compressor, compact cold box with the new designed heat exchangers, and standardized equipment manufacturing and integrated process technology have been made. The development pattern of “rapid cluster application and flexible liquefaction center” has been eventually proposed. The small-scale NG liquefier developed by TIPC has reached a minimum liquefaction power consumption of about 0.35 kW·h/Nm³. It is suitable to exploit small remote gas reserves which can also be used in boil-off gas reliquefaction and distributed peak-shaving of pipe networks.     

Corrosion resistance of Al–Cr-slag containing chromium–corundum refractories to slags with different basicity

Al–Cr slag is the solid waste generated by the smelting of Cr metal. It presents a range of environmental hazards. This study addressed the corrosion resistance of Al–Cr slag containing chromium–corundum refractories to slags with different basicity. Herein, we provide suggestions for the use of Cr–corundum of different basicity in kilns. Al–Cr slag, brown fused Al₂O₃, and chrome green were used as the raw materials, with pure calcium aluminate cement being used as a binder. The brick samples, prepared using different blends of chrome green and corundum, were fired at 1600?°C, and subsequently subjected to a slag corrosion test. After corrosion by slag of different basicity, the phase composition and microstructure of the sample were analyzed by X-ray diffraction, energy dispersive spectrometer and scanning electron microscopy. There were two major findings. First, Cr–corundum brick made from Al–Cr slag has a better slag corrosion resistance than that made from Cr₂O₃ and brown fused Al₂O₃. Second, Cr–corundum brick made from Al–Cr slag has superior corrosion resistance to slag with a CaO:SiO₂ ratio of 2:1.     

象山煤矿11~#煤层带压开采危险性预测

采用突水系数法对象山煤矿北一采区11#煤层突水危险性进行了预测,结果显示,北一采区西北角、东南角属于相对安全区,突水系数0.06 MPa/m,北一采区北部B6孔附近为相对危险区,突水系数在0.1~0.119 MPa/m之间,其它区域处在临界区。该研究成果可为矿井防治水提供参考依据。     

基于Q-learning的不确定环境BDI Agent最优策略规划研究

BDI模型能够很好地解决在特定环境下的Agent的推理和决策问题,但在动态和不确定环境下缺少决策和学习的能力。强化学习解决了Agent在未知环境下的决策问题,却缺少BDI模型中的规则描述和逻辑推理。针对BDI在未知和动态环境下的策略规划问题,提出基于强化学习Q-learning算法来实现BDI Agent学习和规划的方法,并针对BDI的实现模型ASL的决策机制做出了改进,最后在ASL的仿真平台Jason上建立了迷宫的仿真,仿真实验表明,在加入Q-learning学习机制后的新的ASL系统中,Agent在不确定环境下依然可以完成任务。     

基于振动实测的非均质地层钻头失效分析与对策

四川盆地作为国内页岩气开发的重点区域,通过近几年的不断攻关和实践,机械钻速得到了提高,但由于受地层复杂、可钻性差、非均质性强等地质因素的影响,导致井下钻柱系统不良振动剧烈,容易出现钻头损坏严重、钻速较低等问题,严重影响了钻井时效。为了解决上述难题,以该盆地涪陵工区上二叠统龙潭组—中二叠统茅口组为例,采用井下振动高频测量工具的实测手段,测量了钻头—钻柱系统的动态振动加速度参数,结合地层的岩性和矿物组分分析,研究钻头失效原因与对策,并开展了现场试验。研究结果表明:①在非均质地层中钻进的钻头—钻柱系统产生了大于40 m/s~2的高幅值瞬时冲击振动,高幅值的瞬时冲击是导致钻头先期失效的主要原因;②提出了抑制高幅值的瞬时冲击振动采用"减振+增压"工具组合和避免井下工具共振的钻井参数;③采用钻井新参数的试验井比邻井的高幅值瞬时振动降低了17%,单只钻头进尺增加24%,钻头工作环境得到了较大的改善,钻头使用数量减少。结论认为,该研究成果能够有效地改善钻头—钻柱系统的振动状态,有利于达成延长钻头使用寿命的目标。     

脱硫活性焦水洗再生过程实验研究

对5种活性焦水洗再生前后的脱硫性能进行实验研究，通过比表面积（BET）、X射线光电子能谱（XPS）方法表征水洗再生工艺对活性焦孔隙结构和表面化学性质的影响，揭示影响活性焦水洗再生性能的关键因素。结果表明:活性焦脱硫硫容的大小和水洗再生率的高低没有直接关系；微孔比表面积较大的活性焦脱硫性能较好，中大孔孔容较大的活性焦水洗再生率较高，同时具备较大的微孔比表面积和中大孔孔容结构的活性焦适宜水洗再生工艺；活性焦表面极性含氧官能团含量越高水洗再生效果越好；活性焦AC5经过6次水洗再生循环，微孔中的硫酸经过多次累积后可以被水洗出，稳定再生率保持在45%~50%，最适用于活性焦水洗再生工艺。     

汽轮机组在启动中调速油压剧降的原因分析

针对中国大唐集团公司洛阳热电厂BΠT-25-4型汽轮机定速后出现了调速油泵停运的问题,对调速油压不稳定状况进行了分析,并找出了解决办法,为其他类型汽轮机组解决同类问题提供了参考。     

二极管侧面抽运薄片激光器耦合系统研究

设计了二极管侧面抽运Nd:YAG薄片激光器,耦合系统由消像差透镜组和空心光波导组成,对二极管快轴和慢轴方向的抽运光进行压缩和均匀化.采用光线追迹法,同时考虑二极管在快轴和慢轴方向的发散特性及薄片侧面的散射特性,模拟并分析了光线在耦合系统内的传输和薄片内抽运光分布的规律.模拟结果表明耦合系统具有98.1%的耦合效率,同时薄片内具有理想的抽运光分布.     

Fenton氧化法去除酱油生产废水中焦糖色素的研究

着重考察了Fenton试剂对水中焦糖色素降解的影响因素.从试验中得出,这些影响因素包括pH、催化剂的投加方式、催化剂与氧化剂的化学计量数以及反应时间等.Fenton反应中,pH4的条件下处理效果最好,反应进行40min时去除率达到90%.