Characterization of the Residence Time Distribution in Spray Dryers

In this work it is presented a study on the residence time distribution (RTD) of particles in a co-current pilot-plant spray dryer operated with a rotary atomization system. A nuclear technique is applied to investigate the RTD responses of spray dryers. The methodology is based on the injection of a radioisotope tracer in the feed stream followed by the monitoring of its concentration at the outlet stream. The experiments were performed during the drying of aqueous suspensions of gadolinium oxide. The RTD responses obtained experimentally presented good reproducibility, indicating that the technique applied is well suited to investigating fluid-dynamics of spray dryers. In addition to the experimental investigation, a mathematical model was used to describe the RTD experimental curves.     

Evanescently coupled photodiodes integrating a double-stage taper for 40-Gb/s applications-compared performance with side-illuminated photodiodes

The design, fabrication, and performance of double-stage taper photodiodes (DSTPs) are reported. The objective of this work is to develop devices compatible with 40-Gb/s applications. Such devices require high efficiency, ultrawide band, high optical power handling capability, and compatibility with low-cost module fabrication. The integration of mode size converters improves both the coupling efficiency and the responsivity with a large fiber mode diameter. Responsivity of 0.6 A/W and 0.45 A/W are achieved with a 6-/spl mu/m fiber mode diameter and cleaved fiber, respectively, providing relaxed alignment tolerances (/spl plusmn/1.6 /spl mu/m and /spl plusmn/2 /spl mu/m, respectively), compatible with cost-effective packaging techniques. DSTPs also offer a wide bandwidth greater than 40 GHz and transverse-electric/transverse-magnetic polarization dependence lower than 0.2 dB. Furthermore, a DSTP saturation current as high as 11 mA results in optical power handling greater than +10 dBm and a high output voltage of 0.8 V. These capabilities allow the photodiode to drive the decision circuit without the need of a broad-band electrical amplifier. The DSTP devices presented here demonstrate higher responsivities with large fiber mode diameter and better optical power handling capabilities and are compared with classical side-illuminated photodiodes.     

Impact of crosstalk in an arrayed-waveguide multiplexer onN×N optical interconnection

The impact of crosstalk in an arrayed-waveguide N×N wavelength multiplexer is investigated precisely in relation to its application to wavelength-routing N×N all optical networks. In such systems multiple crosstalk light which has the same wavelength as the signal results in signal-crosstalk beat noise. We confirm that the noise is Gaussian and obtain the relation between crosstalk and power penalty. It is shown that the crosstalk must be less than -38 dB for a 16×16 system to keep the power penalty below 1 dB at a bit error rate of 10^-9     

Increasing the service properties of weld joints by electrohydroimpulse treatment

Known examples of the positive influence of electrohydroimpulse treatment on the quality of weld joints of various steels, particularly including an increase in their long-term and cyclic strength and also corrosion resistance, are analyzed. It is shown that in this case there is a reduction in residual macro- and micro-stresses and also a change in the parameters of the dislocation structure of the joint metal in the direction of stabilization of it.Translated from Problemy Prochnosti, No. 4, pp. 119–123, April, 1996.     

Chronic pain in elderly people

Using the fear-potentiated startle paradigm in rats, 4 experiments examined whether the inhibitory effect of a feature is evident after its offset following serial feature-negative discrimination training (A+ and X-->A-). When startle probes were presented shortly after the offset of X on X-->A test trials, the inhibitory properties of X were observed immediately after its offset. Furthermore, trace reinforcement of X (X-->+), but not delay reinforcement (X+), disrupted the ability of X to inhibit fear-potentiated startle on X-->A trials. Trace conditioning to X was also retarded after A+ and X-->A- training. These results suggest that the inhibitory properties of the serially trained feature are present after its offset and raise the possibility that either temporal information regarding nonreinforcement or poststimulus attributes of X acquire inhibitory properties.     

Asymmetric dilation of multiwavelength cross-connect switches forlow-crosstalk WDM optical networks

We predict that, for wavelength division multiplexing optical-network applications, an asymmetrically dilated configuration of a 2×2 cross-connect is significantly better in terms of overall crosstalk when the levels of the bar-port crosstalk and the cross-port crosstalk are significantly different from each other, as is the case with optical-frequency filters which utilize grating-assisted coupling. As a verification, we present a simulation study with 2×2 polarization-diversified acousto-optic tunable filters. We present a recursive method to extend the principle of asymmetric dilation to larger-size cross-connect switches, and make a recommendation for an asymmetrically dilated 4×4 cross-connect configuration     

Application of neural networks and machine learning in networkdesign

Communication network design is becoming increasingly complex, involving making networks more usable, affordable, and reliable. To help with this, we have proposed an expert network designer (END) for configuring, modeling, simulating, and evaluating large structured computer networks, employing artificial intelligence, knowledge representation, and network simulation tools. We present a neural network/knowledge acquisition machine-learning approach to improve the END's efficiency in solving the network design problem and to extend its scope to acquire new networking technologies, learn new network design techniques, and update the specifications of existing technologies     

Densification involved in the UV-based photosensitivity of silicaglasses and optical fibers

A comprehensive survey of photosensitivity in silica glasses and optical fiber is reviewed. Recent work on understanding the mechanisms contributing to germanium or aluminum doped fiber photosensitivity is discussed within the framework of photoelastic densification models