10?30 GHz monolithic GaAs travelling-wave divider/combiner

A four-way monolithic GaAs travelling-wave power divider/combiner has been designed, fabricated and evaluated. With a design centre frequency of 20 GHz, a bandwidth of from 10 GHz to 30 GHz has been measured. The insertion loss per dividing or combining action is less than 0.5 dB, with isolation between ports no worse than 20 dB. The input/output VSWRs are better than 2:1 across the same band. This divider/combiner can readily be used with monolithic GaAs power FET amplifiers to produce a several-fold increase in output powers over the 10 to 30 GHz frequency range.     

Performance analysis of information dissemination by flooding

Performance properties are established for the dissemination by flooding of a database that is initially distributed among the nodes of a communications network. An example of this general process is the dissemination of network status information as a component of the adaptive routing mechanism in a network like Arpanet. Bounds are given on the progress of the dissemination process at a sequence of times before the completion of the process, whereas earlier results only bounded the time until completion. The present bounds further extended earlier analysis by treating the diameter explicitly as a parameter. Specialized versions of the bounds are given for k-connected networks. The bounds yield a recognition property whereby a node can recognize that it has received the entire database without having a priori knowledge of the size of the database. An earlier assumption about a fixed time for correct message transmission over any edge is relaxed to assume only an upper bound on these transmission times     

Parametric modeling of somatosensory evoked potentials

In this paper, we examine methods of characterizing somatosensory evoked potentials (SEP's) in both the time and frequency domains. We have found that the truncated impulse response (TIR) method produced an accurate time domain model of the SEP signals at model orders greatly reduced from the original state space matrix. The TIR method was valuable for smoothing signals that were slightly corrupted by noise. In this case, the simulated data sequence was close to the original data sequence in the mean squared error sense. For signals that were greatly corrupted by noise, the TIR method was not able to perform as well. Therefore, the TIR method was not a feature extraction method but was valuable for data simulation. In the frequency domain, we have used the autoregressive moving average model (ARMA) to parameterize the SEP signal. An overdetermined set of Yule-Walker equations was created to determine the autoregressive (AR) parameters of the original data with the model order established by the singular value decomposition. From these AR parameters, a residual time series was generated which was used to find the moving average parameters. The resulting ARMA model was used to produce a simulated data sequence. The frequency domain characteristics of the simulated sequence and the corresponding power spectral density of the ARMA filter were very close to the periodogram of the original data sequence. Accurate parameterization was achieved for the SEP waveforms at low filter lengths.     

Biochemical oxidation of caprolactam-containing wastewater from the production of synthetic fibres

Conclusions The chemical mutagenesis method is recommended for use in local purification installations for cleaning up of caprolactam-containing wastewater.Use of this method permits one to carry out a biochemical clean-up of wastewater having a caprolactam content up to 600 mg/liter while increasing the oxidative power of the aeration tank by a factor of two.Translated from Khimicheskie Volokna, No. 6, p. 46, November–December, 1985.     

Three-Phase Induction Generator for Single-Phase Line

Hydroelectric generators of less than 20 kilowatts can be in remote areas served only by a single-phase line. For high efficiency and low cost, a three-phase induction generator should be used. This three-phase generator can operate with balanced voltages and currents when the ``phase-splitting' circuit uses two capacitors connetted to two different single-phase voltage sources.     

PHOSPHORUS AND PHOSPHATE LEVELS IN THE ALEURONE CELLS OF CEREAL GRAINS

The aleurone cells of barley, wheat, rice, rye, oats and triticale contained, comparatively, higher percentages of phosphorus than the aleurone cells of sorghum, maize or millet. The aleurone tissues of barley, wheat and rice had more phosphate than corresponding tissues of sorghum and maize. Phosphate was not detected in the aleurone tissue of maize but was found in trace amounts in the aleurone tissue of sorghum.     

Convective transfer processes in chemically stable and reacting liquids with an internal structure

Dynamic processes are studied in media with softly and hardly internal destroyable configurations. A method is examined for the measurement of properties of media with spatial separation of the chemical transformation stages and thermal hydrodynamic measurements.Translated from Inzhenerno-Fizicheskii Zhurnal, Vol. 53, No. 5, pp. 781–789, November, 1987.     

Hydrothermal corrosion of magnesiapartially-stabilized zirconia

Changes in the phase compositions and microstructures of magnesia-partially-stabilized zirconia (Mg-PSZ) were studied in water at 80–300 °C, 1 m HCl solutions at 80–140 °C and 1 m CH₃COOH-CH₃COONa buffer solutions at pH 3 and 80–140 °C for 10–40 days. The tetragonal to monoclinic phase transformation and the degradation of the fracture strength occurred in water above 200 °C. On the other hand, although no noticeable tetragonal to monoclinic phase transformation proceeded in 1 m HCl solutions and 1 m CH₃COOH-CH₃-COONa buffer solutions at pH 3 below 140 °C, the fracture strength of Mg-PSZ greatly degraded. The dissolution of Mg²⁺ ion was observed in water above 200 °C and in 1 m HCl solutions above 80 °C.