Mechanisms of neuronal calcium homeostasis destabilization caused by hyperstimulation of glutamate receptors

The present paper summarizes the data obtained in studying the mechanisms of glutamate-induced deterioration of neuronal Ca2+ homeostasis. In the cultured mammalian central neurons, a short-term (< 1 min) glutamate (GLU, 100 mu) challenge is known to induce a readily reversible (transient) neuronal [Ca2+]i increase. In contrast, a long-term (15-30 min) GLU exposure leads to the appearance of high [Ca2+]i plateau or to the partial recovery of the increased [Ca2+]i. Experiments show that impaired [Ca2+]i recovery in the postglutamate period cannot be explained by the increased [Ca2+]i permeability of the neuronal membrane, as earlier considered. Moreover, a sustained elevation of [Ca2+]i during and after chronic GLU application is associated with a progressive decrease in Ca2+ permeability. The major cause of GLU-induced Ca2+ overload is the mitochondrial depolarization resulted from excessive Ca2+ influx into the mitochondria, the generation of free radicals and the opening of a "giant pore" in the inner mitochondrial membrane. This in turn suppresses both ATP synthesis and Ca2+ electrophoretic uptake into the mitochondrial matrix. In combination with [Ca2+]i-dependent acidification, this leads to the suppression of Ca2+ release from the cell via Na+/Ca2+ exchanger and Ca2+/H+ pump of the neuronal membrane. Therefore, [Ca2+]i recovery following a long-term GLU treatment becomes strongly or even irreversibly compromised.     

Design, fabrication, and testing of a bistable electromagneticallyactuated microvalve

A bistable electromagnetically actuated microvalve was designed, processed, and tested. The valve was designed to control a water flow of 0.05-0.5 μs from a reservoir at a pressure of 1-2000 Pa. The two valve components were fabricated in silicon, the upper piece comprises an electroplated gold coil, and the lower piece is an Ni/Fe alloy beam. The bistable capability was achieved by balancing the elastic forces on the beam with the magnetic forces due to a 46-μm-thick rolled magnetic foil. The design includes the flow through the orifice, squeeze film damping due to beam motion, beam elasticity, and electromagnetics. The microvalve was tested for power consumption, flow rate, time response, Ni/Fe alloy composition, and magnetic foil properties. The valve operates at 1-2 V in both air and water     

A microfabricated electrochemical actuator for large displacements

A large-displacement electrochemical actuator was designed, fabricated, and tested. The large displacement is obtained by using a corrugated membrane made by physical vapor deposition of Parylene sandwiched with an intermediate layer of sputtered platinum. The layered structure is approximately 8-μm thick, with 26 grooves approximately 120-μm deep, and with a radial period of 350 μm. The electrochemical cell consists of platinum electrodes with a 1 M H₂ SO₄ solution. Hydrogen and oxygen gas is generated to displace the membrane. Although the actuator can operate at a voltage as low as 1.23 V, the experimentally determined efficiency of converting electrical energy to mechanical work is only 0.37%. The governing equations for the conservation of mass, momentum (equilibrium), energy, and the entropy generation rate were formulated assuming that the gas bubbles either nucleate without growth or grow without nucleation. For the nucleation case, simulations were performed for constant pressure isothermal actuation, and the average experimental efficiency was bounded by simulations with gas bubble radii between 1×10^-6 m and 1×10^-6 m. The predicted ratio of the power dissipated to the electrical power supplied is 1.37 for isothermal actuation     

Human oogenesis in organ culture

The authors compared the extent of development of the germ cells of the human fetus ovaries developing in the organ culture and of control ovaries obtained of fetuses of "equivalent" age. The capacity to enter the meiosis prophase under conditions of the organ culture was expressed by the germ cells of fetuses of 8-9 week of gestation, and older; only individual oocytes reached the leptotene stage in the explants of the ovaries of 7-8 week fetuses. The oocytes at the leptotene, zygotene and pachitene stage appeared in the culture at the same periods as in the organism. However, the percentage of cells of these stages in the explant was as a rule lower than in control ovaries. In case of pulse administration of thymidine-3H into the culture labeled oocytes at the zygotene stage appeared in 4, and at the pachitene stage - in 14 days.     

Comparison of Operant Escape and Innate Reflex Responses to Nociceptive Skin Temperatures Produced by Heat and Cold Stimulation of Rats.

In behavioral tests, rats performed learned escape responses to thermal stimulation of the paws by 44.0. 47.0. or 0.3 degrees C. Licking, guarding, and jumping reflexes were evaluated at these temperatures. The frequency, latency, and duration of escape and reflex responses were compared and were related to hind-paw skin temperatures measured during stimulation of awake and anesthetized rats. The duration and latency of escape from heat were appropriately related to stimulus intensity. Escape occurred reliably for each intensity. Reflexes occurred unreliably and at long latency to 44.0 or 0.3 degrees C and were not appropriately related to heat intensity. The reflexes were relatively insensitive to thermal nociceptive stimulation other than heating of the skin at a high rate. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Avalanches on a conical bead pile: scaling with tuning parameters

Uniform spherical beads were used to explore the scaling behavior of a granular system near its critical angle of repose on a conical 3D bead pile. We found two tuning parameters that could take the system to a critical point. The existence of those tuning parameters violates the fundamental assumption of self-organized criticality, which proposed that complex dynamical systems self-organize to a critical point without need for tuning. Our avalanche size distributions were well described by a simple power-law, as is characteristic of a critical point, with the power τ = 1.5 when dropping beads slowly onto the apex of a bead pile from a small height. However, we could also move the system from the critical point using either of two tuning parameters: the height from which the beads fell onto the top of the pile or the region over which the beads struck the pile. As the drop height increased, the system did not reach the critical point yet the resulting distributions were independent of the bead mass, coefficient of friction, or coefficient of restitution. All our apex-dropping distributions for any type of bead (glass, stainless steel, zirconium) showed universality by scaling onto a common curve with τ = 1.5 and σ =?1.0, where 1/σ is the power of the tuning parameter. From independent calculations using the moments of the distribution, we find values for τ = 1.6 ± 0.1 and σ =?0.91 ± 0.15. When beads were dropped across the surface of the pile instead of solely on the apex, then the system also moved from the critical point and again the avalanche size distributions fell on a common curve when scaled similarly using the same values of τ and σ. We also observed that an hcp structure on the base of the pile caused an emergent structure in the pile that had six faces with some fcc or hcp structure; this structure did not affect the distribution of avalanche sizes.     

Selecting and assessing challenge problems

Abstract

Organisations conducting research programs often focus the work of their scientists and technologists on challenge problems (CPs). These challenges are designed to ensure that progress is measurable and relevant to the goals of the program sponsor. Generating and selecting pertinent CPs is difficult, as is assessing their value. We describe a method of generating and selecting CPs and its application in a highly collaborative, multi-organisation research program. Thirty-eight biologists, chemists, mathematicians and computer scientists across academic, commercial and government organisations generated and ranked their top choices from among 12 richly described candidate challenge problems. A ranked-choice voting formula was applied. Five CPs were highly scored; the remaining seven were distributed across a lower range of scores. The program sponsor subsequently directed researchers to address six CPs, including the elected five. Analysis of the rationales that participants offered for their CP rankings revealed four domain-independent dimensions of value: capability, speed, impact and synergy. These dimensions of value can help managers of interdisciplinary research programs systematically select a portfolio of CPs that will efficiently apply utilise resources towards program goals and facilitate measurement of scientific progress.     

Inhomogeneous dopant distribution in III–V nanowires

We present a theoretical study of the dopant spatial distribution in III–V nanowires grown by molecular beam epitaxy. The evolution of the dopant concentration is obtained by solving the non-stationary diffusion equation. Within the model, it is shown why and how the dopant inhomogeneity appears, as observed experimentally in the case of Be doping of GaAs nanowires and in other material systems.     

Consumer Input for Developing Human Food Products Made with Sorghum Grain

Abstract: Because sorghum grain has important characteristics (for example, great antioxidant profile) for introduction into the regular human diet, producers and industry aim to develop successful products using sorghum as the base. The 1st step in developing products attractive for consumers is understanding consumer needs and expectations. Conjoint analysis determines attributes which may be important or unimportant for one product. In this study, focus groups and conjoint analysis were used to establish which attributes are helpful for promoting purchase intent of sorghum grain products. Once those characteristics were chosen, a national survey was conducted to confirm the selection. During the focus groups, the heath aspects of grain products seemed to be the most appealing for consumers, whereas conjoint analysis showed that sensory attributes were the principal drivers for purchase intent. Practical Application: The data presented in this study are essential for industry as a starting point for developing sorghum grain based food products. It is necessary to address consumers’ demands to ensure new products’ success in the market, and the present study clearly shows this consumers’ input.