ORBIT: A parallel computing model of Prolog

This paper proposes a parallel processing model of the Prolog language. The model modifies Or-parallelism by introducing the “process bundle” as a candidate for simultaneous execution. The Process bundle is a subset of backtrack points stacked in depth-first execution. The process bundle includes one or more backtrack points, so it provides a longer process life cycle than the Or-parallel process. A process bundle is dispatched when an idle processor requests a job from an executing processor. The executing processor dispatches a message containing the full environment by which the idle processor can execute the process without any communication with other processors.     

Highly accurate SNR measurement using the covariance of two SEM images with the identical view

Quality of an SEM image is strongly influenced by the extent of noise. As a well-known method in the field of SEM, the covariance is applied to measure the signal-to-noise ratio (SNR). This method has potential ability for highly accurate measurement of the SNR, which is hardly known until now. If the precautions discussed in this article are adopted, that method can demonstrate its real ability. These precautions are strongly related to "proper acquisition of two images with the identical view," "alignment of an aperture diaphragm," "reduction of charging phenomena," "elimination of particular noises," and "accurate focusing," As necessary, characteristics in SEM signal and noise are investigated from a few standpoints. When using the maximum performance of this measurement, SNR of many SEM images obtained in a variety of the SEM operating conditions and specimens can be measured accurately.     

Leak-tightness characteristics concerning the containment structures of the HTTR

The containment structures of the HTTR consist of the reactor containment vessel, the service area, and the emergency air purification system, which minimise the release of fission products in postulated accidents, which lead to fission product release from the reactor facilities. The reactor containment vessel is designed to withstand the temperature and pressure transients and to be leak-tight in the case of a rupture of the primary concentric hot-gas duct, etc. The pressure inside the service area is maintained at a negative pressure by the emergency air purification system. The emergency air purification system will also remove airborne radioactivity and will maintain a correct pressure in the service area.The leak-tightness characteristics of the containment structures are described in this paper. The measured leakage rates of the reactor containment vessel were enough less than the specified leakage limit of 0.1%/d confirmed during the commissioning tests and annual inspections. The service area was kept in a way that the design pressure becomes well below its allowable limitation by the emergency air purification system, which filters efficiency of particle removal and iodine removal well over the limited values.The obtained data demonstrate that the reactor containment structures were fabricated to minimise the release of fission products in the postulated accidents with fission product release from the reactor facilities.     

Safety design

JAERI established the safety design philosophy of the HTTR based on that of current reactors such as LWR in Japan, considering inherent safety features of the HTTR. The strategy of defense in depth was implemented so that the safety engineering functions such as control of reactivity, removal of residual heat and confinement of fission products shall be well performed to ensure safety. However, unlike the LWR, the inherent design features of the high-temperature gas-cooled reactor (HTGR) enables the HTTR meet stringent regulatory criteria without much dependence on active safety systems. On the other hand, the safety in an accident typical to the HTGR such as the depressurization accident initiated by a primary pipe rupture shall be ensured. The safety design philosophy of the HTTR considers these unique features appropriately and is expected to be the basis for future Japanese HTGRs.This paper describes the safety design philosophy and safety evaluation procedure of the HTTR especially focusing on unique considerations to the HTTR. Also, experiences obtained from an HTTR safety review and R&D needs for establishing the safety philosophy for the future HTGRs are reported.     

Influence of variations in creep curve on creep behavior of a high-temperature structure

It is one of the key issues for a high-temperature structural design guideline to evaluate the influence of variations in creep curve on the creep behavior of a high-temperature structure. In the present paper, a comparative evaluation was made to clarify such influence.The evaluation results showed that, in almost all cases of a creep behavior pattern in which creep strain accumulated during a stress cycle caused significant relaxation of the corresponding deformation-controlled stress in the following cycles, the variations in creep behavior with the creep curve were qualitatively similar to those in fundamental creep properties. On the other hand, in many cases of another creep behavior pattern in which creep strain accumulated during a cycle doesn't cause the significant stress-relaxation in the following cycles, the variations in creep behavior for earlier cycles are different from those in fundamental creep properties. Even in these cases, however, those get qualitatively similar after several cycles when their stress-time histories are stabilized.Additional consideration was given to the influence of the relationship between creep rupture life and minimum creep rate, i.e., the Monkman-Grant's relationship, on the creep damage evaluation.The consideration suggested that the Monkman-Grant's relationship be taken into account in evaluating the creep damage behavior, especially the creep damage variations. However, it was clarified that the application of the creep damage evaluation rule of ASME B.&P.V. Code Case N-47 to the “standard case”which was predicted from the average creep property would predict the creep damage on the safe side.     

Determination of Ring-OSF Position in Czochralski Silicon Single Crystals by Numerical Analysis of Distribution of Grown-in Defects

A numerical analysis technique that incorporates Voronkov's model were examined and used to estimate the distribution of defects during crystal growth. By comparisons of the distribution of the density of LSTD and the position of R-OSF in non-nitrogen-doped (non-N-doped) and nitrogen-doped (N-doped) silicon crystals, it is found that the results of the numerical analyses agree with practically evaluated data. The observations suggest that the R-OSF nucleus is a VO2 complex that is formed by bonds between oxygen atoms and residual vacancies consumed during the formation of void defects. This suggests that Voronkov's model can be used to accurately predict the generation and growth of defects in silicon crystals. This numerical analysis technique was also found to be an effective method of estimating the distribution of defects in silicon crystals during crystal growth.     

关于建立故障树的新探索

在诊断专家系统开发的基础上，讨论了故障树的建立问题，基于对系统特性的分析，提出了通过系统故障传递关系和故障传递可达关系，由计算机自动生成故障树的方法，并以大型过程系统为例，从理论上论证了该方法的可行性及其优点。     

Study of melting and crystallization behavior of polyacrylonitrile using ultrafast differential scanning calorimetry

The thermal behavior of polyacrylonitrile (PAN) has been investigated using X-ray diffraction, differential scanning calorimetry (DSC), and ultrafast DSC. In conventional DSC, it is difficult to prevent the concurrent occurrence of the exothermic reactions of PAN with melting. However, in the ultrafast DSC curve, the exothermic peak due to these reactions disappears over the temperature range 0–400 °C at heating rates above 250 °C s⁻¹. Alternatively, the glass transition and the melting of PAN are observed over the temperature range 109–129 °C and 335–362 °C, respectively. Moreover, upon cooling from the molten state at a rate of −7500 °C s⁻¹, PAN crystallization is observed at 204 °C. These findings were observed repeatedly during heating and cooling measurements. From the extrapolation analysis, the zero-entropy-production melting temperature of PAN is found to lie in the temperature range 320–350 °C. Finally, the equilibrium melting temperature of PAN is estimated to be ca. 465 °C.     

Synthesis of High-Molecular-Weight [60]Fullerene Pearl-Necklace Polyamides Derived from Equatorial [60]fullerenobisacetic Acid

Abstract

A series of [60]fullerene pearl-necklace polyamides, consisting of equatorial-[60]fullerenobisacetic acid and various chromophoric aromatic diamines, were synthesized by a phosphorylation route using large amounts of triphenyl phosphite and pyridine as condensing reagents with stepwise addition of the condensing reagents. In the present polymers, [60]fullerene pearls and diamine linkers were attached to one another by cyclopropane connectors. The polyamides had weight-average molecular weights (M_w)of 4.5-5.0×10⁴ g/mol and inherent viscosities (n _inh) of 0.3-0.4 dL/g in N, N-dimethylacetamide (DMAc) at 30 °C. They had glass transition temperatures at 30-125 °C and decomposition temperatures at 300-310 °C. The UV-VIS spectra in DMAc exhibited broad absorption with λ_max at 310-390 nm tailing to longer wavelengths.     

Neuroprotection,Growth Factors and BDNF-TrkB Signalling in Retinal Degeneration

Neurotrophic factors play key roles in the development and survival of neurons. The potent neuroprotective effects of neurotrophic factors, including brain-derived neurotrophic factor (BDNF), ciliary neurotrophic factor (CNTF), glial cell-line derived neurotrophic factor (GDNF) and nerve growth factor (NGF), suggest that they are good therapeutic candidates for neurodegenerative diseases. Glaucoma is a neurodegenerative disease of the eye that causes irreversible blindness. It is characterized by damage to the optic nerve, usually due to high intraocular pressure (IOP), and progressive degeneration of retinal neurons called retinal ganglion cells (RGCs). Current therapy for glaucoma focuses on reduction of IOP, but neuroprotection may also be beneficial. BDNF is a powerful neuroprotective agent especially for RGCs. Exogenous application of BDNF to the retina and increased BDNF expression in retinal neurons using viral vector systems are both effective in protecting RGCs from damage. Furthermore, induction of BDNF expression by agents such as valproic acid has also been beneficial in promoting RGC survival. In this review, we discuss the therapeutic potential of neurotrophic factors in retinal diseases and focus on the differential roles of glial and neuronal TrkB in neuroprotection. We also discuss the role of neurotrophic factors in neuroregeneration.