A carboxyalkanethiol monolayer modified electrode for blocking of ascorbic acid oxidation and its application to a biosensor

Upon the application of amperometric biosensor to the biological fluid, ascorbic acid interferes the amperometric determination of analytes, because the oxidative potential of ascorbic acid is lower than that of electro active substances such as H₂O₂ produced by the enzymatic reaction. In this study we propose a method to block ascorbic acid based on the electrostatic interaction with self-assembled monolayer (SAM) and its application of the surface modified electrode to biosensor. In order to form SAM on the gold electrode with carboxyl group, 7-carboxy-heptanethiol (7-CHT) was used. The 7-CHT modified electrode did not show anodic response to ascorbic acid, but oxidized phenanthroline cobalt complex [Co(phen)₃²⁺], which can be used as a mediator of biosensor. Thus, the 7CHT-modified electrode was applied to biosensor mediated with Co(phen)₃²⁺. Fructose dehydrogenase (FDH) was immobilized to the 7-CHT modified electrode. Fructose was determined selectively with the FDH/7-CHT modified electrode at the range of 0.2-2 mM.     

Electron-microscopic procedure for acrylic rubber

The electron-microscopic visualization of acrylic rubber dispersed in a heterogeneous structural resin composition consisting of a rubber-modified two-phase plastic comprising essentially a butyl acrylate rubber phase and an acrylonitrile–styrene copolymer phase, respectively, has been accomplished. This procedure consists of the following: The molded resin specimen is treated with hydrazine hydrate solution to produce the acrylic acid hydrazides. Allow the treated specimen to soak in osmium tetroxide solution. The acrylic rubber may be indirectly fixed and stained. Some micrographs of ultrathin sections of two or three resin compositions, cut by an ultramicrotome, are presented.     

Thermal strain of high strength polyethylene fiber in low temperature

High strength polyethylene fiber (Toyobo, Dyneema® fiber: hereinafter abbreviated to DF) has a negative thermal expansion coefficient. Relation between fiber structure and thermal strain of DF used as reinforcement of DF reinforced plastic (DFRP) for cryogenic use was investigated. The crystallinities and orientation angles of several kinds of polyethylene fibers having different modulus from 15 to 134Gpa (herein after abbreviated to DFs) were measured by NMR and X‐ray. We obtained the parameters of the mechanical series‐parallel model composed of crystal and amorphous by crystallinity and modulus. Thermal expansion coefficients of DFs were estimated by mechanical series‐parallel model. All DFs having different modulus showed negative thermal expansion coefficients in the temperature range from 180 to 300K, and absolute values of those markedly increased by increasing tensile modulus of DF. The estimated thermal expansion coefficients showed negative values, and thermal strains showed a similar curve to observed ones mostly. Average thermal expansion coefficients in the temperature range from 180 to 300K estimated by mechanical model agreed with the observed ones. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 93: 2918–2925, 2004     

Enzymatic syntheses of N-lauroyl-β-alanine homologs in organic media

Enyzmatic amidation of the primary amines β-alanine ethyl ester and 3-aminopropionitrile with methyl laurate by means of immobilized lipase (Candida antarctica lipase, CAL) resulted in the formation in good yield of N-lauroyl-β-alanine ethyl ester and 3-(N-lauroylamino)-propionitrile, respectively. When 3-amino-propionitrile was used as substrate, diisopropyl ether was a suitable solvent. Changing the reaction temperature (12–80°C) did not affect the yields, and room temperature was a suitable temperature for this reaction. In the investigation of reaction conditions, the use of equimolar amounts (5 mmol) of substrate and ester, along with 0.5 g of CAL, in diisopropyl ether gave the best yield (99.3%) after 24 h of incubation at 24°C. The enzyme activity in the amidation reaction did not decrease even after six uses. With β-alanine ethyl ester hydrochloride as substrate, diisopropyl ether was unsuited as a solvent owing to the low solubility of the substrate in this solvent. In this reaction, the best yield (82.0%) was attained by using dioxane as solvent. CAL achieved higher extents of amide synthesis with long-chain than with short-chain ester substrates. The enzyme accepted only nonbulky primary amines as substrates.     

Gain‐Scheduled Control via Switching of LTI Controllers and State Reset

This paper proposes a synthesis method of gain‐scheduled control systems that switch linear time‐invariant controllers according to hysteresis of the scheduling parameter. Stability and L₂‐gain analysis and synthesis methods for switched systems are applied to the switched gain‐scheduled control synthesis using reset of the controller state, where also the reset law is computed via linear matrix inequalities (LMIs). In addition to optimization of an upper bound of L₂‐gain, we reduce jumps of control input via an auxiliary optimization. Numerical examples are presented to illustrate the switched gain‐scheduled controller.     

High‐resolution technology for FPD manufacturing

Using shorter wavelength for exposure light is one way to achieve high resolution while keeping sufficient depth of focus. We show exposure results for high resolution to confirm the effect of deep UV exposure light. With deep UV light, 1.2‐µm line and space pattern and 1.8‐µm contact hole pattern are resolved while keeping sufficient depth of focus.     

Mathematics for/from Society: The Role of the Module in Modernizing Japanese Architectural Production

This paper presents an examination of the process of the development of module in the works and theories of Japanese architect Ikebe Kiyoshi (1920-79). Ikebe based his idea of module on the belief that “Beauty is Mathematics.” He applied his ideas of module in various ways from the 1940s to the 1970s. Analyzing his ideas and works against their historical background, the social and creative meanings of the idea of module and of mathematics in architecture will be re-examined. This allows us to see how Ikebe developed his ideas of module from a characteristic mathematical approach, and how he developed his idea of mathematical logic into his creative theories based on the flexible nature of people’s lifestyles and social conditions. Going beyond the cultural and social differences and the limitations of Le Corbusier’s Modulor, the idea of module as the method for organizing human space in a harmonious manner was reframed in Ikebe’s works, and was developed in a more flexible mathematical way.     

Sudden death of adults in Japan

Epidemiological features, risk factors and preventive methods of sudden death (SD) derived from studies the authors have performed since 1987 together with colleagues in Niigata University School of Medicine were reviewed. When SD was defined as death occurring within 24 hours of the onset of symptoms, the annual incidence was 145/100,000 for people aged 15 years and older in Niigata Prefecture. The incidence increased sharply along with the advance of age, while the proportion of SD to natural death due to circulatory diseases was higher in younger people. Though diseases of the circulatory system made up approximately 90 percent of all causes of death, SD due to ischemic heart disease was less frequent in Japan than in western countries. SD showed various patterns in seasonal and "within-a-day" occurrences according to sex, age and cause of death. The months of the highest SD occurrence differed by occupation and matched the busiest work periods. A decrease in sleeping hours and mental stress experienced during the preceding week were related to the occurrence of both sudden death and non-fatal acute myocardial infarction. People having structural circulatory diseases were shown to be predisposed to SD when stress occurred, because fatal arrhythmia is easily induced by the above factors in such people. Health examinations were shown to have preventive effects, though limited, against SD. Differences in the resuscitated rates in cases where a witness was present and where one was not indicates that educating people about correct resuscitation methods is important to minimizing SD.