Ratcheting in a nonlinear viscoelastic adhesive

Uniaxial time-dependent creep and cycled stress behavior of a standard and toughened film adhesive were studied experimentally. Both adhesives exhibited progressive accumulation of strain from an applied cycled stress. Creep tests were fit to a viscoelastic power law model at three different applied stresses which showed nonlinear response in both adhesives. A third order nonlinear power law model with a permanent strain component was used to describe the creep behavior of both adhesives and to predict creep recovery and the accumulation of strain due to cycled stress. Permanent strain was observed at high stress but only up to 3% of the maximum strain. Creep recovery was under predicted by the nonlinear model, while cycled stress showed less than 3% difference for the first cycle but then over predicted the response above 1000 cycles by 4–14% at high stress. The results demonstrate the complex response observed with structural adhesives, and the need for further analytical advancements to describe their behavior.     

Gains and losses of the XII-VII component of the "baby-sitter" procedure: a morphometric analysis

The classic hypoglossal transfer to the facial nerve is invariably followed by complications caused by tongue atrophy. In 1984, Terzis introduced the "baby-sitter" procedure which involved a formal cross-facial procedure, in addition to partial neurectomy of the hypoglossal nerve, and an end-to-side coaptation with the ipsilateral facial nerve. This reported study provides, for the first time, quantification of the number of hypoglossal motor fibers needed to successfully restore eye sphincter function, using an end-to-side coaptation with preservation of the tongue. Thirty adult Sprague-Dawley rats were divided into six groups: control, denervated, perineurial window, 20 percent partial neurectomy (PN), 40 percent PN, and 80 percent PN. The procedure involves interposing a nerve graft (saphenous) between the partially severed XII nerve and the upper zygomatic branch of the facial nerve. Evaluation of the behavioral data (blink reflex) revealed good-to-superb return of the blinking mechanism in the 40 percent group, without significant tongue atrophy. Electrophysiologic data in the 40 percent neurectomy group demonstrated superiority to the other groups. Quantitative axonal morphometry of the coaptation sites and graft, as well as motor end-plates of the orbicularis oculi muscle and tongue showed the 40 percent partial neurectomy group to be the optimal group.     

Modeling the microstructural changes during hot tandem rolling of AA5XXX aluminum alloys: Part I. Microstructural evolution

A comprehensive mathematical model of the hot tandem rolling process for aluminum alloys has been developed. Reflecting the complex thermomechanical and microstructural changes effected in the alloys during rolling, the model incorporated heat flow, plastic deformation, kinetics of static recrystallization, final recrystallized grain size, and texture evolution. The results of this microstructural engineering study, combining computer modeling, laboratory tests, and industrial measurements, are presented in three parts. In this Part I, laboratory measurements of static recrystallization kinetics and final recrystallized grain size are described for AA5182 and AA5052 aluminum alloys and expressed quantitatively by semiempirical equations. In Part II, laboratory measurements of the texture evolution during static recrystallization are described for each of the alloys and expressed mathematically using a modified form of the Avrami equation. Finally, Part III of this article describes the development of an overall mathematical model for an industrial aluminum hot tandem rolling process which incorporates the microstructure and texture equations developed and the model validation using industrial data. The laboratory measurements for the microstructural evolution were carried out using industrially rolled material and a state-of-the-art plane strain compression tester at Alcan International. Each sample was given a single deformation and heat treated in a salt bath at 400 °C for various lengths of time to effect different levels of recrystallization in the samples. The range of hot-working conditions used for the laboratory study was chosen to represent conditions typically seen in industrial aluminum hot tandem rolling processes, i.e., deformation temperatures of 350 °C to 500 °C, strain rates of 0.5 to 100 seconds and total strains of 0.5 to 2.0. The semiempirical equations developed indicated that both the recrystallization kinetics and the final recrystallized grain size were dependent on the deformation history of the material i.e., total strain and Zener-Hollomon parameter (Z), where and time at the recrystallization temperature.     

Epitaxially grown graphene based gas sensors for ultra sensitive NO2 detection

Epitaxially grown single layer and multi layer graphene on SiC devices were fabricated and compared for response towards NO₂. Due to electron donation from SiC, single layer graphene is n-type with a very low carrier concentration. The choice of substrate is demonstrated to enable tailoring of the electronic properties of graphene, with a SiC substrate realising simple resistive devices tuned for extremely sensitive NO₂ detection. The gas exposed uppermost layer of the multi layer device is screened from the SiC by the intermediate layers leading to a p-type nature with a higher concentration of charge carriers and therefore, a lower gas response. The single layer graphene device is thought to undergo an n-p transition upon exposure to increasing concentrations of NO₂ indicated by a change in response direction. This transition is likely to be due to the transfer of electrons to NO₂ making holes the majority carriers.     

Prophylactic efficacy of tilmicosin for bovine respiratory tract disease

The prophylactic administration of injectable tilmicosin for pneumonia in weaned beef calves was investigated in 1,806 animals. Comparisons were made among calves receiving an "on-arrival" injection of tilmicosin, calves receiving a single injection of long-acting oxytetracycline, and calves receiving no prophylaxis. Morbidity and mortality attributable to pneumonia, morbidity and mortality attributable to all causes, and case fatality were significantly lower in the group of calves that received tilmicosin, compared with calves that received long-acting oxytetracycline and calves that received no prophylactic antibiotic. Mean time to initial pneumonia treatment was significantly extended in calves that received prophylaxis, compared with those that received no antibiotic on arrival at the feedlot. Calves that received tilmicosin gained significantly more weight than calves that received oxytetracycline. Calves that were not treated for pneumonia during the trial period gained significantly more weight than did those calves that were treated for pneumonia regardless of experimental group. The majority of mortalities were attributable to fibrinous pneumonia (31/34). Important bacterial isolates (Pasteurella spp, Haemophilus somnus, Actinomyces pyogenes) obtained at necropsy did not have resistance to tilmicosin in association with administration of tilmicosin as prophylaxis for pneumonia. However, bacterial resistance to trimethoprim/sulfonamide and to oxytetracycline were commonly found in these postmortem isolates.     

New method for selectivity enhancement of SiC field effect gas sensors for quantification of NO x

A silicon carbide based enhancement type metal insulator field effect transistor with porous gate metallization has been investigated as a total NO _x sensor operated in a temperature cycling mode. This operating mode is quite new for gas sensors based on the field effect but promising results have been reported earlier. Based on static investigations we have developed a suitable T-cycle optimized for NO _x detection and quantification in a mixture of typical exhaust gases (CO, C₂H₄, and NH₃). Significant features describing the shape of the sensor response have been extracted and evaluated with multivariate statistics (e.g. linear discriminant analysis) allowing quantification of NO _x . Additional cleaning-cycles every 30?min improve the stability of the sensor further. With this kind of advanced signal processing the influence of sensor drift and cross sensitivity to ambient gases can be reduced effectively. Measurements have proven that different concentrations of NO _x can be detected even in a changing mixture of other typical exhaust gases under dry and humid conditions. In addition to that, unknown concentrations of NO _x can be detected based on a small set of training data. It can be concluded that the performance of GasFETs for NO _x determination can be enhanced considerably with temperature cycling and appropriate signal processing.     

Film Blowing of Layered Silicate Nanocomposites

Bubble formation and stability in the film blowing processing of in situ polymerized and melt-compounded polyamide 6-based layered silicate nanocomposites (LSNs) are correlated to their underlying rheology, structure, and crystallization behavior. The layered silicates enhance melt elasticity, induce γ -form crystallinity, and increase crystallization rates without having any significant effect on the extent of crystallinity. A bubble stability quantification method employed to assess the level of instability during the film blowing process finds the in situ polymerized LSNs to be more stable than PA6, while melt-compounded LSNs do not display such an improved processability. All of the LSN films produced by film blowing possess superior mechanical properties compared to neat nylon 6, despite their relatively rougher film surfaces.     

Combined Petri net modelling and AI-based heuristic hybrid search for flexible manufacturing systems—part II. Heuristic hybrid search

This two-part paper presents modelling and scheduling approaches of flexible manufacturing systems using Petri nets (PNs) and artificial intelligence (AI)-based heuristic search methods. In Part I, PN-based modelling approaches and basic AI-based heuristic search algorithms were presented. In Part II, a new heuristic function that exploits PN information is proposed. Heuristic information obtained from the PN model is used to dramatically reduce the search space. This heuristic is derived from a new concept, the resource cost reachability matrix, which builds on the properties of B-nets proposed in Part I. Two hybrid search algorithms, (1) an approach to model dispatching rules using analysis information provided by the PN simulation and (2) an approach of the modified stage-search algorithm, are proposed to reduce the complexity of large systems. A random problem generator is developed to test the proposed methods. The experimental results show promising results.     

Using computer animated graphics with science instruction with children.

The effects of animated presentations and practice were studied in a computer-based science lesson involving fourth- and fifth-grade students. Three levels of visual elaboration (static graphics, animated graphics, and no graphics) were crossed with three levels of practice (behavioral, cognitive, and no practice). Behavioral practice consisted of traditional questioning and cognitive practice consisted of a structural simulation. Animated graphics were superior to static graphics and no graphics so long as practice was provided. Behavioral practice was effective only when paired with lessons containing animated graphics. Cognitive practice was generally superior to the other practice conditions and did not appear dependent on visual elaboration. These results suggest that animated presentations can promote learning under certain conditions, and they also demonstrate a successful application of interactive graphics in the design of cognitively based practice activities. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Effect of temperature on the absorption loss of chalcogenide glass fibers

The change in the absorption loss of IR-transmitting chalcogenide glass fibers in the temperature range of -90 degrees C /= 6 mum the change in loss was mainly due to multiphonon absorption. The change in loss for tellurium-based glass fibers increased significantly at T = 60 degrees C. The increase in the loss at short wavelengths (lambda /= 9 mum, multiphonon absorption dominated the loss spectrum.