LIPID AND CHOLESTEROL OXIDATION,COLOR CHANGES,AND VOLATILE PRODUCTION IN IRRADIATED RAW PORK BATTERS WITH DIFFERENT FAT CONTENT1

An emulsion-type product was prepared to determine the effect of irradiation on lipid and cholesterol oxidation, color change, and volatile production in raw pork with different fat contents. Lipid oxidation increased with an increase in fat content or irradiation dose. Irradiated batters had higher cholesterol oxides than nonirradiated, and the major cholesterol oxides formed in irradiated pork batters were 7α- and 7β-hydroxycholesterol. Hunter color a- and b-values of raw pork batters were decreased by irradiation regardless of fat content. Irradiation increased the amount ofvolatiles significantly. Although lipid oxidation of high fat products (10 and 15% fat) was higher than that of low fat products (4%), high fat products did not always produce greater amount of volatiles. In summary, irradiation increased lipid and cholesterol oxidation, volatiles production and had detrimental effects on the color of raw pork batters under aerobic condition.     

Oxidation behaviour of a Mo(Si,Al)2 based composite at 1500 °C

The oxidation of a Mo(Si,Al)₂ composite is investigated at 1500 °C in dry air using exposure times from 1 to 1000 h. Cross sections are examined with Scanning Electron Microscopy (SEM) and the phase composition is analyzed by X-ray diffraction (XRD). The material forms a continuous and protective alumina layer, the growth of the alumina layer following parabolic kinetics. Immediately below the scale Mo(Si,Al)₂ is replaced by a Mo₅(Si,Al)₃ layer due to the flux of aluminum to the scale. The Al concentration in the Mo(Si,Al)₂ phase in the underlying substrate decreases from 27% before exposure to 16–17% after 1000 h. The continuous alumina layer becomes covered by a top layer consisting of alumina grains embedded in a viscous melt with approximate composition 7 Na₂O–15 Al₂O₃–78 SiO₂. With time, sodium is volatilized from the melt and the top scale layer transforms to a mixture of alumina, mullite and silica melt.     

Evolution of maturity levels of the particle surface and bulk during soot growth and oxidation in a flame

We performed a study of the evolution of soot composition and fine structure, i.e., maturity level, in an atmospheric ethylene-air diffusion flame. We used laser-induced incandescence (LII) to provide information about maturity level of the bulk primary particle and X-ray photoelectron spectroscopy (XPS) to provide complementary information about particle-surface-maturity level. The results demonstrate that the bulk material and the particle surface evolve separately in the flame. Increased soot-maturity level is associated with increased long-range order of the particle fine structure. This increased order leads to an increase in the absorption cross-section in the visible and near-infrared and a shift of the absorption to longer wavelengths with increasing maturity level of the bulk particle. These trends result in a decrease in the dispersion exponent (?) and increase in the absorption cross-section scaling factor (?), as inferred from LII measurements. LII measurements demonstrate that bulk-maturity level increases with height-above-the-burner (HAB) until it reaches a plateau in the center of the flame at the maximum in the soot volume fraction. Bulk-maturity level only slightly decreases as soot is oxidized at larger HABs. Increased maturity level also leads to an increase in long-range sp² hybridization. XPS measurements of the sp²/defect ratio demonstrate an increase in soot surface-maturity level with increasing HAB, but the surface-maturity level increases more gradually with HAB than the bulk-maturity level. Whereas the bulk-fine-structure order decreases slightly in the oxidation region, the surface order decreases dramatically, indicating that oxidation occurs preferentially at the surface under these conditions.

Copyright © The Authors. Published with license by American Association for Aerosol Research     

Social influence during the initial phase of a fire evacuation—Analysis of evacuation experiments in a cinema theatre

Unannounced evacuation experiments in a cinema theatre were analysed. The analysis focused on investigating if people are influenced by others during the initial phase of a fire evacuation. This type of influence is called social influence. Three separate behaviour types were identified and studied and the recognition and pre-movement time was measured. The results suggest that social influence is an important factor and that it becomes more important when the fire cue, e.g., the alarm, is unclear or uninformative. Results also indicate that social influence increases with decreasing distance between visitors. This result implies that individuals are influenced more by people who are close than by people who are further away.     

Summary of the Closing Session

Plausible costs of photovoltaic power plants of concentration are presented. Costs are based as much as possible on the recent experience of solar thermal plants. Efficiencies, on the existing world experience of PV power plants. The result is that the costs of concentrating photovoltaic plants should be of 0.08 ECUs/ kWh, about 1/3 of that of flat module plants, and of the same order of magnitude, even lower, than those attributed to solar thermal plants of present technology.

For the future, high concentration systems based on Si or tandem cells seem to be the most promising, also in the range of costs of the advanced solar thermal plants.     

Key technologies for IMT-advanced mobile communication systems

WINNER is an ambitious research project aiming at identification, development, and assessment of key technologies for IMTAdvanced mobile communication systems. WINNER has devised an OFDMA-based system concept with excellent system-level performance for flexible deployments in a wide variety of operating conditions. The WINNER system provides a significant step forward from current 3G systems. Key innovations integrated into the system concept include flexible spectrum usage and relaying, adaptive advanced antenna schemes and pilot design, close to optimal link adaptation, hierarchical control signaling, and a highly flexible multiple access scheme. The end-to-end performance assessment results demonstrate that the WINNER concept meets the IMTAdvanced requirements.