Motorcyclist fatalities and the repeal of mandatory helmet wearing laws

Previous studies had estimated that repeal of mandatory helmet wearing laws resulted in increases in the number of fatalities ranging from nearly 40% to essentially zero. This study was performed to determine more definitively the influence on motorcyclist fatalities of these repeals. After repeal, motorcyclist fatalities increased more in the states which repealed their laws than in those which did not in 24 cases out of 26, with the 95% confidence interval for the average effect being 25 +/- 6%. It is therefore concluded that repeals of mandatory helmet wearing laws for motorcyclists were followed by substantial increases in motorcyclist fatalities.     

Direct sampling of chemical weapons in water by photoionization mass spectrometry

The vulnerability of water supplies to toxic contamination calls for fast and effective means for screening water samples for multiple threats. We describe the use of photoionization (PI) mass spectrometry (MS) for high-speed, high-throughput screening and molecular identification of chemical weapons (CW) threats and other hazardous compounds. The screening technology can detect a wide range of compounds at subacute concentrations with no sample preparation and a sampling cycle time of approximately 45 s. The technology was tested with CW agents VX, GA, GB, GD, GF, HD, HN1, and HN3, in addition to riot agents and precursors. All are sensitively detected and give simple PI mass spectra dominated by the parent ion. The target application of the PI MS method is as a routine, real-time early warning system for CW agents and other hazardous compounds in air and in water. In this work, we also present comprehensive measurements for water analysis and report on the system detection limits, linearity, quantitation accuracy, and false positive (FP) and false negative rates for concentrations at subacute levels. The latter data are presented in the form of receiver operating characteristic curves of the form of detection probability P(D) versus FP probability P(FP). These measurements were made using the CW surrogate compounds, DMMP, DEMP, DEEP, and DIMP. Method detection limits (3sigma) obtained using a capillary injection method yielded 1, 6, 3, and 2 ng/mL, respectively. These results were obtained using 1-microL injections of water samples without any preparation, corresponding to mass detection limits of 1, 6, 3, and 2 pg, respectively. The linear range was about 3-4 decades and the dynamic range about 4-5 decades. The relative standard deviations were generally <10% at CW subacute concentrations levels.     

Book review

Tropical Librarianship W. J. Plumbe The Scarecrow Press, Inc. Matuchen, N.J. and London, 1987     

Investigation of thermal effects in quantum-cascade lasers

The development of a thermal model for quantum cascade lasers (QCLs) is presented. The model is used in conjunction with a self-consistent scattering rate calculation of the electron dynamics of an InGaAs-AlAsSb QCL to calculate the temperature distribution throughout the device which can be a limiting factor for high temperature operation. The model is used to investigate the effects of various driving conditions and device geometries, such as epilayer down bonding and buried heterostructures, on the active region temperature. It is found that buried heterostructures have a factor of eight decrease in thermal time constants compared to standard ridge waveguide structures in pulsed mode and allow a /spl sim/78% increase in heat sink temperature compared to epilayer down mounted devices in continuous-wave mode. The model presented provides a valuable tool for understanding the thermal dynamics inside a quantum cascade laser and will help to improve their operating temperatures.     

Method for error recovery of line spectral frequencies

The authors have exploited the ideas used in vector quantisation for error recovery of scalar quantised LSFs. The good performance of this method has provided high resistance of the LSFs to channel errors, outperforming other schemes by, possibly, a considerable margin. Better objective and subjective performances were obtained with this new method which obviates the need for more powerful FEC schemes for transmission over noisy channels.<>     

RF performance of a 418-MHz radio telemeter packaged for humanvaginal placement

The electrical and communication performance of a 0.8-μW UHF temperature telemeter designed for human vaginal placement is discussed; a solenoidal loop antenna was used, occupying a volume of 0.1 cm³ . In situ, measured power absorption was between 19-25 dB, resulting in an effective operating range of 10 m. Capacitive loading lowered the antenna's resonant frequency by 1.4% and there was a significant polarization change in the radiated output     

Microfluidic arrays for bioimprint of cancer cells

We report the development and characterization of a microfluidics-based bioimprint process using high-density microchannel arrays for cell-culture and polymer delivery. The tubeless PDMS arrays consist of multiple independent microchannels and allow for parallelized bioimprint via automated dispensing and passive pumping. Using the microchannels, a 400 nm thin test pattern was replicated into a methacrylate biopolymer to demonstrate process applicability. Bioimprints of cobalt chloride stimulated Ishikawa endometrial cancer cells exhibiting exocytosis-like pore structures were compared with controls using AFM to exemplify a process application. The devices can be used for high-throughput cell assays, cell developmental studies and the formation of phenotype-specific biomimetic scaffolds.     

The effect of varying barrier height on the operationalcharacteristics of 1.3-μm strained-layer MQW lasers

This paper presents an empirical study of the effects that barrier layer composition has on the operational characteristics of 1.3-μm-wavelength InGaAsP-InP multiquantum-well (MQW) strained-layer ridge-waveguide lasers. A systematic empirical investigation of how this design choice affects practical device operation was undertaken by examining threshold current, efficiency, and modal gain as a function of temperature in five different laser structures. The results of these studies indicate that small barrier heights improve device performance, despite the loss of electronic confinement in the shallow conduction band quantum wells. Indeed, it appears that carrier uniformity in the MQW structure may be improved by carrier redistribution due to thermal or tunneling effects, which in turn enhances the operation of the low barrier height structures