Influence of wastewater characteristics on methane potential in food-processing industry wastewaters

In this study, we identified the influence of wastewater characteristics on the theoretical and practical methane potential using different food industrial wastewaters as substrates. Ten composite wastewater samples from five industries were investigated. The ultimate practical methane yields (B(o)) were compared to the theoretical methane yields (B(o,th)) in order to evaluate the biodegradability of the tested wastewaters and the influence of their physico-chemical characteristics. The analytical method applied to quantify the wastewaters' organic content proved to influence the estimation of their theoretical yields. The substrate:inoculum ratio as well as the dilution factor of the wastewaters influenced the ultimate practical methane yields differently in each of the wastewaters assessed. Substrate chemical oxygen demand (COD) concentrations did not present any influence on ultimate practical methane yields; on the other hand, it was found that they were affected positively by concentrations of total inorganic carbon when wastewaters were 25% and 50% diluted and affected negatively by concentrations of total acetate when wastewaters were undiluted. Carbohydrate and protein concentrations affected negatively the maximum achieved practical methane yields.     

Model description and kinetic parameter analysis of MTBE biodegradation in a packed bed reactor

A dynamic modeling approach was used to estimate in-situ model parameters, which describe the degradation of methyl tert-butyl ether (MTBE) in a laboratory packed bed reactor. The measured dynamic response of MTBE pulses injected at the reactor's inlet was analyzed by least squares and parameter response surface methodologies. Response surfaces were found to be statistically significant and thus suitable for estimating the global minimum as well as the 95% parameter uncertainty regions. The linear parameter uncertainty estimates for the half-saturation constant (K(S)) and the maximum growth rate (micro(max)) were: 0相似文献   

Biodegradability and ecotoxicity of commercially available geothermal heat transfer fluids

Commercially available heat transfer fluids used in borehole heat exchangers were investigated for their composition, their biodegradability as well as their ecotoxicity. The main components of the fluids are organic compounds (often glycols) for freezing protection. Biodegradation of the fluids in laboratory studies caused high oxygen depletion as well as nitrate/iron(III) reduction under anaerobic conditions. Additives such as benzotriazoles for corrosion protection were persistent. Ecotoxicity data show that the commercially available fluids caused much higher ecotoxicity than their main organic constituents. Consequently, with regard to groundwater protection pure water as heat transfer medium is recommended. The second best choice is the usage of glycols without any additives. Effects on groundwater quality should be considered during ecological-economical cost-benefit-analyses of further geothermal energy strategies. The protection of groundwater as the most important drinking water resource must take priority over the energy gain from aquifers.     

City edges in Germany: Quality growth and urban design

Forty years of explosive growth have dissolved the hard edge of old walled cities throughout Germany. Undefined suburban mess has consumed vast areas of land and degraded picturesque German landscapes. The new interest in strengthening local identities coincides with national priorities to enhance the cultural and natural heritage. Policies for quality growth at the city's edge evolve through a series of steps, including the community's vision statements, comprehensive master planning, environmental prioritization of potential development sites, and land banking for mitigation of future impacts. The merits of high density urban form with strategically placed ‘hard’ and ‘soft’ edges include preservation of landscape with special environmental and scenic value; proximity of residential and recreational areas; convenient and car-free transit; and openness contrasts with urban density.     

A fractional-spectral method for vibration of damped space structures

Based on the theory of fractional calculus and the spectral theory of vibration, a new spectrally formulated finite element method of analysis is developed which is capable of making accurate predictions of the dynamic response of structures with added dampers. The frequency-dependence damping characteristic of structural materials can be modelled accurately using the fractional derivative model. It is shown that the proposed method can be extended to develop a nonlinear damping element which can be used to model structural dampers. The approach has an advantage over the usual viscous treatment, which appears to lack physical motivation. The nonlinear damping solution is shown graphically, and the consistency of method is investigated. Using a computer program, the proposed formulation has been used to derive the dynamic response of a tall structure with added viscoelastic dampers.     

Stofftransport durch Schichtsysteme aus Polymeren und dünnen anorganischen Schichten

Mass transport through layer systems consisting of polymers and thin inorganic layers Flexible layer systems from polymeric substrates, thin inorganic layers deposited by vacuum coating and additional polymeric layers are frequently in use to obtain high barrier properties, predominantly against oxygen and water vapour. Especially in cases where additional polymeric coatings are able to fill defects in the inorganic layers, barrier properties of the resulting layer systems show a stronger dependence on their thickness. For the transport of condensable substances, especially of water vapour, an additional porosity in the sub‐nm‐size can be assigned to the inorganic layers. This, however, has a negligible effect on gas permeation. Multilayer structures made from substrates and alternating polymeric and inorganic layers show much better barrier properties than single polymeric substrates coated with single inorganic layers. These improvements, however, are less than previously reported here. Moreover, also in these cases, the condensation of water vapour in sub‐nm pores gives much higher rates for the permeation of substances than expected from simple defect models.     

Irradiation effects on AlGaN HFET devices and GaN layers

AlGaN/GaN heterostructure field effect transistors (HFETs) were irradiated with protons as well as carbon, oxygen, iron and krypton ions of high (68 and 120 MeV) and low (2 MeV) energy with fluences in the range from 1 × 10⁷ to 1 × 10¹³ cm^?2. High energy irradiation with protons, carbon and oxygen produced no degradation in devices while krypton irradiation at the fluence of 1 × 10¹⁰ cm^?2 resulted in a small reduction of 2% in the transconductance. Similarly, for GaN samples irradiated with protons, carbon and oxygen at high energy no changes were seen by XRD, PL and Hall effect, while changes in lattice constant and a reduction in PL intensity were observed after irradiation with high energy krypton. Low energy irradiation with carbon and oxygen at a fluence of 5 × 10¹⁰ cm^?2 results in small change in the device performance while remarkable changes in device characteristics are seen at a fluence of 1 × 10¹² cm^?2 for carbon, oxygen, iron and krypton irradiation. Similarly changes are also observed by XRD, PL and Hall effect for the thick GaN layer irradiated at the fluence of 1 × 10¹² cm^?2. The device results and GaN layer properties are strongly correlated.     

Ultrathin SiO(2) layers on Si(111): preparation, interface gap states and the influence of passivation

An essential prerequisite for the successful application of Si/SiO(2) nanostructures in photovoltaics is the realization of well-defined and abrupt interfaces with low densities of interface gap states. Here, a complete in situ process from preparation and hydrogen passivation to interface gap state analysis by near-UV photoelectron spectroscopy without breaking ultrahigh vacuum (UHV) conditions is introduced. It is demonstrated that by RF plasma oxidation of Si(111) substrates with thermalized neutral oxygen atoms, ultrathin SiO(2) layers can be realized with compositionally and structurally abrupt Si/SiO(2) interfaces and a minimal amount of intermediate oxidation states bridging the transition from Si to SiO(2). Plasma oxidized samples have significantly lower interface gap states than samples oxidized by thermal oxidation at 850?°C. Interface gap state densities were further reduced by in situ hydrogen plasma passivation with nearly thermalized H atoms. The resulting reduction of interface recombination velocity and the increase of effective majority and minority carrier lifetimes are revealed by constant photocurrent measurements and quasi-steady-state photoconductance, respectively.     

Fundamental role of the retarded potential in the electrodynamics of superluminal sources

We calculate the gradient of the radiation field generated by a polarization current with a superluminally rotating distribution pattern and show that the absolute value of this gradient increases as R(7/2) with distance R, within the sharply focused subbeams that constitute the overall radiation beam from such a source. In addition to supporting the earlier finding that the azimuthal and polar widths of these subbeams become narrower (as R(-3) and R(-1), respectively) with distance from the source, this result implies that the boundary contribution to the solution of the wave equation governing the radiation field does not always vanish in the limit where the boundary tends to infinity (as is commonly assumed in textbooks and the published literature). While the boundary contribution to the retarded solution for the potential can always be rendered equal to zero by means of a gauge transformation that preserves the Lorenz condition, the boundary contribution to the retarded solution of the wave equation for the field may be neglected only if it diminishes with distance faster than the contribution of the source density. In the case of a rotating superluminal source, however, the boundary term in the retarded solution for the field is by a factor of the order of R(1/2)larger than the source term of this solution, in the limit where the boundary tends to infinity. This result explains why an argument based on the solution of the wave equation governing the field in which the boundary term is neglected [such as that presented by Hannay, J. Opt. Soc. A 23, 1530 (2006)] misses the nonspherical decay of the field that is generated by a rotating superluminal source. The only way one can calculate the free-space radiation field of an accelerated superluminal source is via the retarded solution for the potential. Our findings have implications also for the observations of the pulsar emission: The more distant a pulsar, the narrower and brighter its giant pulses should be.