Nanoscale structural characteristics and electron field emission properties of transition metal–fullerene compound TiC60 films

Transition-metal compound TiC₆₀ thin films were grown by co-deposition from two separated sources of fullerene C₆₀ powder and titanium. Study of structural properties of the films, by Raman spectroscopy, atomic force microscopy, and scanning tunneling spectroscopy reveals that the films have a deformed C₆₀ structure with certain amount of sp³ bonds and a rough surface with a large number of nanoclusters. z–V tunnelling spectroscopic measurements suggest that several charge transport mechanisms are involved in as the tip penetrates into the thin film. Conventional field electron emission (FEE) measurements show a high emission current density of 10 mA/cm² and a low turn-on field less than 8 V/μm, with the field enhancement factors being 659 and 1947 for low-field region and high-field region, respectively. By exploiting STM tunneling spectroscopy, local FEE on nanometer scale has also been characterized in comparison with the conventional FEE. The respective field enhancement factors are estimated to be 99–355 for a gap varying from 36 to 6 nm. The enhanced FEE of TiC₆₀ thin films can be ascribed to structural variation of C₆₀ in the films and the electrical conducting paths formed by titanium nanocrystallites embedded in C₆₀ matrix.     

An on-chip active decoupling circuit to suppress crosstalk in deep-submicron CMOS mixed-signal SoCs

A decoupling circuit using an operational amplifier is proposed to suppress substrate crosstalk in mixed-signal system-on-chip (SoC) devices. It overcomes the parasitic inductance problem of on-chip capacitor decoupling. The effect of the proposed decoupling circuit is not limited by parasitic fine impedance. A 0.13-/spl mu/m CMOS test chip showed that substrate noise at frequencies from 40 MHz to 1 GHz was incrementally suppressed by sequentially activating three of the proposed circuits in parallel. The power dissipation of each circuit was 3.3 mW at a 1.0-V power supply. The test chip measurement showed that the proposed decoupling reduced crosstalk by 31% at 200 MHz, whereas it was reduced by 4.4% with capacitor decoupling. This 7:1 ratio, or 17 dB, corresponds to the gain of the opamp. Design of the opamp and its feedback loop for active decoupling is simple, making the opamp useful for SoC applications.     

Effect of ionic content,solid content,degree of neutralization,and chain extension on aqueous polyurethane dispersions prepared by prepolymer method

There are many variables in the preparation of aqueous polyurethane (PU) dispersions. Carboxylic acid content, solid content, degree of pre/postneutralization of the carboxylic acids, and chain extension all impact dispersion particle size, viscosity, pH, molecular weights, and glass transition temperature. This study evaluated the impact of these variables on a given PU dispersion formulation prepared from isophorone diisocyanate, an aliphatic polyester polyol, dimethylol propionic acid, and hexamethylene diamine with triethyl amine as the neutralizing base and N‐methyl pyrrolidone as the cosolvent. Changes in carboxylic acid content, degree of preneutralization, and chain extension were found to have the expected impacts on dispersions properties. Increased ionic content in the dispersion step led to lower particle size and higher viscosity, increased chain extension with its concurrent increase in molecular improved subsequent film properties. Surprising results were obtained by varying the amount of postneutralization and from increased solids content at the time of dispersion. Unexpectedly, both of these variations led to much higher dispersion viscosities and particle size in solution. To have these changes take place, it is theorized that there is a major change in solution morphology caused by these modifications. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 98: 2514–2520, 2005     

Role of chain symmetry and hydrogen bonding in segmented copolymers with monodisperse hard segments

Thermoplastic segmented polyurethane and polyurea copolymers whose monodisperse hard segments are based on only a single diisocyanate molecule are discussed. The solid-state structure-property behavior of these materials demonstrates that a proper selection of the level of symmetry and/or cohesiveness of the hard microdomains may allow elimination of the traditional requirement of chain extension to obtain melt processable segmented urethanes, and more specifically, urea copolymers with useful structural properties.     

High Pressure Conductivity and Photoconductivity of Polyveratrole

Summary Electropolymerization of o-(CH₃O)₂C₆H₄ (Veratrole) in dry acetonitrile/tetrabutylammonium tetrafluoroborate at platinum electrode, yields a green polymeric conducting solid. As the pressure is increased, the material becomes more conductive, but sharp changes towards lower conductivity occur at 4.2 and 6.2 metric tons pressure, probably due to phase transitions. The photoconductivity shows an exponential increase as temperature is increased, but it shows reversible changes at 200 K, 225 K and 250 K during slow warming, also attributable to phase transitions. Photoconductivity of Polyveratrole increases with the radiation frequency, being higher under blue light than under red of infrared radiation and there is a linear increase of photoconductivity with radiation density. Conductivity transients show that the conductivity increases exponentially with time to the saturation point within few minutes, and it also decreases exponentially when the light is turned off and the circuit is open. This behaviour can be explained by formation and encounter of electron and hole as current carriers. A preliminary study indicates a piezoelectric effect for the material. absorption spectroscopy allowed the measurements of the material band gap.     

Sphere packing with a geometric based compression algorithm

An efficient algorithm for the random packing of spheres can significantly save the cost of the preparation of an initial configuration often required in discrete element simulations. It is not trivial to generate such random packing at a large scale, particularly when spheres of various sizes and geometric domains of different shapes are present. Motivated by the idea of compression complemented by an efficient physical process to increase packing density, shaking, a new approach, termed compression algorithm, is proposed in this work to randomly fill any arbitrary polyhedral or cylindrical domains with spheres of various sizes. The algorithm features both simplicity and high efficiency. Tests show that it takes 181 s on a 1.4-GHz PC to complete the filling of a cylindrical domain with a total number of 26,787 spheres, achieving a packing density of 52.89%.     

Ozonation Impact on Degradation and Toxicity of Non-Ionic Surfactants

Aqueous solutions of five selected non-ionic surfactants: Triton (i-octylphenolethoxylates), Tergitol (2,6,8-trimethyl-4-nonanoloxethylates), Symperonic (n-nonylphenol-oxethylates) and Brij (fatty alcohol ethoxylates) were investigated in this study. Using the bioluminescent bacteria Vibrio fischeri the toxicity of the surfactants solutions were determined. An attempt was made to relate rather low biodegradability of nonionic surfactant solutions measured by the BOD₅/COD ratio (ranging from 1 to 17%) to their toxicity. The ozonation process was carried out in a 1.5 dm³ stirred cell reactor equipped with two ozone detectors. The following parameters were analyzed: pH, COD, BOD₅, DOC, TOC, polarography as well as UV spectrum. The positive effect of ozonation, represented by decay of UV absorption, was visible in almost complete destruction of the surfactants, with exception of Triton X-705 (only 65% degradation after absorption of 2000 mgO₃/dm³). The most striking results were obtained in toxicity tests for ozonated solutions of the non-ionic surfactants – an increase of the bacterial growth inhibition (1.5 to 4 times increase in toxicity due to ozonation). The obtained results were discussed taking into account the literature and our own experimental data on mechanisms of ozonation and biodegradation of non-ionic surfactants of the Triton-type and similar chemical structures.     

Travelling salesman problem tools for microcomputers

The problem of determining minimum total distance to be travelled by a salesman, who is to visit given cities each only once (i.e. the travelling salesman problem) is one of the most studied problems in computational mathematics. Finding an exact solution is not only intractably difficult, but also exceedingly costly. However, we implemented efficient optimal algorithms for both symmetric and asymmetric distance problems. The programs implemented can solve problems up to 180 cities in reasonable computer time.