Study on purple pigmentation in five cases with purple urine bag syndrome

We reported five patients with purple urine bag syndrome (PUBS). Four patients had indicanuria, and, in three of them, purple pigmentation was reproduced by inoculating urinary isolates, in the broth with indoxyl sulfate. Klebsiella pneumoniae, Pseudomonas aeruginosa and Enterococcus avium were considered to produce the purple pigment in three patients. However, attempts to reproduce the purple pigment failed in two patients, and one of them did not have indicanuria. These results suggest that indicanuria is not necessarily required for the development of PUBS.     

Soft-decision Viterbi decoding with diversity combining formulti-beam mobile satellite communication systems

Diversity combining methods for mobile satellite communication systems employing convolutional encoding and soft-decision Viterbi decoding are evaluated. Computer simulation clarifies that the pre-Viterbi-decoding maximal ratio combining method has better performance than other methods in Rician fading channels. The simulation results agree with the Pe (bit error probability) performance derived from the numerical analysis for slow fading using the approximate Pe performance of Viterbi decoding in AWGN (additive white Gaussian noise) channels and the probability density function of Rician fading. Applying this diversity method to the multi-beam mobile satellite communication systems, a satellite beam diversity reception scheme is proposed. A computer simulation result shows that the proposed scheme decreases the packet error rate of the control signals to less than 1/100 around the satellite beam boundary     

A 1000 A/20 kV/25 kHz-500 kHz Volt-Ampere-Wattmeter for loads withpower factors from 0.001 to 1.00

Many industrial processes and scientific experiments utilize large amounts of ac power at frequencies from 3 kHz to 500 kHz. The phase angle and the impedances of these loads often vary over a wide range. This paper describes an instrument to provide an accurate measurement of currents (1 A to 1000 A), voltages (100 V to 20 kV), and powers (100 W to 20 MW) over the frequency range from 25 kHz to 500 kHz. It deals with loads having power factors down to nearly zero and with load impedances from 10 Ω to 20 kΩ. The paper contains practical details of both the design and the calibration of the front-end voltage and current transducers. The characteristics of a nearly ideal broadband current transducer are presented. Overall instrument calibration, verification and traceability problems are considered in detail     

Models for the elastic deformation of honeycombs

A theoretical model has been developed for predicting the elastic constants of honeycombs based on the deformation of the honeycomb cells by flexure, stretching and hinging. This is an extension of earlier work based on flexure alone. The model has been used to derive expressions for the tensile moduli, shear moduli and Poisson's ratios. Examples are given of structures with a negative Poisson's ratio. It is shown how the properties can be tailored by varying the relative magnitudes of the force constants for the different deformation mechanisms. Off-axis elastic constants are also calculated and it is shown how the moduli and Poisson's ratios vary with applied loading direction. Depending on the geometry of the honeycomb the properties may be isotropie (for regular hexagons) or extremely anisotropic. Again, the degree of anisotropy is also affected by the relative magnitude of the force constants for the three deformation mechanisms.     

Microstructures of high-J c melt-textured YBa2Cu3O7−x /Ag superconductors

Silver has been previously added to the melt-textured YBa₂Cu₃O_7?x in order to increase the critical current density (J _c ) of these materials. However, the effect of this addition on theJ _c is presently unclear. The purpose of this study is to investigate the effect of silver on both critical current density and the microstructure of the melt-textured YBa₂Cu₃O_7?x superconductors by means of X-ray diffraction, optical polarized microscopy, and transmission electron microscopy (TEM). TheJ _c of the MTG YBCO/Ag samples is more than 10⁴A/cm² under the 5 kOe magnetic field. It has been shown that as the concentration of silver increases, the fraction of the 211 phase dispersed within the 123 matrix decreases. Therefore, theJ _c slightly decreases. These results, together with the effect of the 211 phase, dislocations, and other structure defects on flux pinning, are described in this paper.     

Evaluation of the recombinant 38-kilodalton antigen of Mycobacterium tuberculosis as a potential immunodiagnostic reagent

The diagnosis of infection caused by Mycobacterium tuberculosis is of increased public health concern following increases in the number of cases in developed countries and major increases in developing countries associated with the spread of human immunodeficiency virus (HIV) infection. The specificity of purified protein derivative skin testing for the detection of infection is compromised by exposure to environmental mycobacteria. Examination of sputum detects the most infectious patients, but not those with extrapulmonary disease. The 38-kDa antigen of M. tuberculosis contains two M. tuberculosis-specific B-cell epitopes. We overexpressed the gene for this antigen in Escherichia coli and evaluated the recombinant product in in vitro assays of T-cell function and as a target for the antibody response in humans. The sensitivity and specificity of the antigen as a skin test reagent were also assessed in outbred guinea pigs. We found that 69% of healthy sensitized humans recognize the antigen in vitro, as manifested by both cell proliferation and the production of gamma interferon. Untreated patients initially have a lower frequency of response (38%); this recovers to 72% during therapy. A total of 292 patients (20 with HIV coinfection) and 58 controls were examined for production of antibody to the 38-kDa antigen by using a commercially available kit. The sensitivity of the test in comparison with that of culture was 72.6%, and the specificity was 94.9%. The antigen was also tested for its ability to induce skin reactions in outbred guinea pigs sensitized by various mycobacterial species. The antigen provoked significant skin reactions in M. tuberculosis-, M. bovis BCG-, and M. intracellulare-sensitized animals. The significance of these findings and the usefulness of this antigen in immunodiagnosis are discussed.     

Iron requirements and iron balance during pregnancy. Is iron supplementation needed for pregnant women?

Among fertile, nonpregnant, Danish women, 33% have absent or reduced iron stores; 22% have serum ferritin values above 70 micrograms/l, i.e., iron reserves of more than 530 mg, corresponding to the net iron losses during a normal pregnancy. During pregnancy, the demands for absorbed iron increase from 0.8 to 7.5 mg/day. Controlled studies show that iron-treated pregnant women have higher serum ferritin levels, i.e., larger iron stores, and higher haemoglobin levels than placebo-treated women. A supplement of 66 mg ferrous iron daily from the beginning of the 2nd trimester prevents iron deficiency anaemia. In Denmark, general iron prophylaxis with 60-70 mg ferrous iron daily from 20 weeks of gestation is recommended by the health authorities.     

Application of microwaves and millimeter waves for thecharacterization of teeth for dental diagnosis and treatment

This paper presents applications of microwaves and millimeter waves for the characterization of teeth. This is done by measuring the complex permittivity over the frequency range from 0.04 to 40 GHz. These measurements have revealed that dental caries are significantly more lossy to microwaves and millimeter waves than the healthy tooth, and this difference can be used for dental diagnosis. The experimental results have been confirmed by using the finite-difference time-domain (FDTD) method. In addition, millimeter-wave heating of the lossy dental caries can be used as a sterilization treatment. It is concluded that millimeter waves can be used for dental medical diagnosis as well as dental medical treatment