Synthesis of polyurethane elastomers hypercross-linked by partially hydrated polyhydroxylated C60

Utilization of polyhydroxylated C₆₀ (fullerenols) in a condensation reaction with diisocyanated oligo(tetramethylene oxide) led to the successful fabrication of elastomeric poly (urethane-ether) networks. These polymer networks exhibit interesting thermal behavior at low temperatures, improved tensile strength and elongation at ambient temperatures, and enhanced thermal mechanical stability at high temperatures, as compared with those of the parent linear polyurethane analogues; or with the conventional oligo (tetramethylene oxide)-derived polyurethane elastomers cross-linked by trihydroxylated reagents (1,I,1-trismethylol propane) or tetrahydroxylated reagents (pentaerythritol). The presence of a limited quantity of water molecules in the condensation reaction of fullerenols with diisocyanated prepolymers modified the physical properties of the resulting elastomeric products with a notable increase in tensile strength, modulus, and Ts over those of elasotmers prepared under anhydrous conditions. These water molecules contributed effectively to the increase of the number of cross-linking centers during the reaction.     

Pharmacological specificities and modalities of prescriptions for corticoids for asthmatic adults

The efficacy of corticosteroids in asthma has been recognized over 40 years ago. Since that time, the advent of inhaled forms has further improved the therapeutic of these drugs which are now recognized as the fundamental treatment for asthma, and described in detail by national and international consensus. Based on a large body of literature, it can now be recommended to prescribe inhaled corticosteroids for symptomatic asthma patients. Long-term treatment is required and dosage not exceeding 1000 micrograms/d (beclometasone dipropionate equivalent) in adults are safe. Differences in the pharmacological characteristics of the various systematic and inhaled corticosteroids can be used to adapt treatment and administration route to each patient and achieve good patient compliance with optimal therapeutic efficacy.     

Percutaneous balloon pericardiotomy for patients with recurrent pericardial effusion: using a novel double-balloon technique with one long and one short balloon

Percutaneous balloon pericardiotomy is effective and less invasive for the treatment of recurrent pericardial effusion. This study suggests that the double-balloon method with 1 longer and 1 shorter balloon is the procedure of choice for percutaneous balloon pericardiotomy.     

Variants of chromosome 9 in phenotypically normal individuals

The human chromosome 9 displays the highest degree of structural variability. Four different types of variants are described including pericentric inversion, extra G-positive band in the q arm, additional G-positive band in the p arm and duplication of band 9q21-q22. It is important to demonstrate inheritance from a phenotypically normal individual in order to differentiate between a variant chromosome and an abnormal chromosome.     

Computer-aided design and analysis of direct-driven wheel motordrive

This paper presents the computer-aided design (CAD) and performance analysis of a novel direct-driven wheel brushless DC motor drive for electric vehicles (EVs). The proposed motor is a permanent magnet square-wave motor, whose rotor with rare earth magnets forms the exterior of the motor, which can be fitted with a wheel tire to realize the direct drive for each wheel of an EV. The interior stator with its windings is rigidly mounted onto the suspension and frame structure of the vehicle. In order to achieve the direct drive without any mechanical transmission for EVs, the wheel motor has been designed as a low-speed high-torque motor. The design and optimization of the motor geometry was achieved with the aid of finite-element electromagnetic field analysis. Simulation studies on the transient performance of the motor drive were also carried out. This involved the creation of the motor transient model and formulation of a motor control strategy to ensure the wheel motor drive runs efficiently in the entire permitted speed and load range. The application of CAD techniques in the design of this very unconventional drive is described in this paper     

Increased analytical precision in the hollow cathode discharge emission source by improved discharge current control.

A significant improvement in the precision of the hollow cathode as an emission source is reported. Precision of 1% or less has been observed several times over periods of several hours. An average long-term stability of 4.3% for Ll and 6.0% for Na in the emission signal from microsamples (less than 50 nL) deposited in the hollow cathode discharge source is reported. The improved precision is attributed primarily to the introduction of electronics that hold the discharge current more nearly constant and to the shielding of all wiring to the source from the power supply. A current-controlled switch that is capable of driving a hollow cathode discharge in either dc or pulsed mode is described. This switch is capable of generating current pulses as short as 2 microseconds through a resistive load and greatly improves the discharge stability and repeatability at turn-on in both the dc and pulsed modes. The characteristics of pulses produced by this switch are presented; however, analytical performance is reported only for the dc mode. Temporal current plots are presented for the new instrumentation and compared to plots taken with commonly used current-controlled power supplies. Instrumentation, operation, and sample preparation procedures are described. Typical temporal profiles of the emission signal from microsamples deposited in AI and stainless steel hollow cathodes are given.     

Stem cell factor enhances the adhesion of AML cells to fibronectin and augments fibronectin-mediated anti-apoptotic and proliferative signals

Acute myeloid leukaemia (AML) cells express the SCF receptor c-kit (CD117) on their cell surface and demonstrate enhanced adhesion to fibronectin (FN) following exposure to stem cell factor (SCF). Increased adhesion occurs within 5 min, is dose dependent, and persists beyond 2 h. Baseline and enhanced adhesion occur through the surface FN receptor very late antigen-5 (VLA-5, CD49e/CD29) which is expressed by AML cells. Unstimulated AML cells exposed to FN undergo less apoptosis than controls (inhibition 22.5 +/- 7.0%, P = 0.02, n = 8). Exposure to SCF alone without FN also inhibits AML cell apoptosis (by 19.0 +/- 7.7% compared to controls, P = 0.06, n = 8). Simultaneous exposure to SCF and FN increases the inhibition of AML cell apoptosis to 37.8 +/- 7.9% (P = 0.005 compared to control, P = 0.04 compared to FN alone, P = 0.06 compared to SCF alone) demonstrating that SCF not only enhances the propensity of AML cells to adhere to FN, but also results in an additive survival benefit following FN contact. Some but not all the reduction in apoptosis is mediated through VLA-5. The combination of SCF and FN also affects proliferation, resulting in a synergistic enhancement of AML cell proliferation in half the cases studied. When normal CD34+ human haemopoietic progenitors were studied, FN had little effect on their apoptosis and failed to enhance the anti-apoptotic effect of SCF. It did, however, synergise with SCF in promoting CD34+ cell proliferation. Exposure of AML cells to SCF and FN, both of which can be found in high concentration in the bone marrow stroma, inhibits apoptosis. Cytokines and extracellular matrix proteins augment each others' effects since SCF enhances adhesion to fibronectin, which in turn augments the survival signal delivered by the cytokine alone. Cytokine and adhesion receptors can combine to affect cell characteristics including proliferation and survival.     

Display of functional alphabeta single-chain T-cell receptor molecules on the surface of bacteriophage

The ability to display functional T-cell receptors (TCR) on the surface of bacteriophage could have numerous applications. For instance, TCR phage-display could be used to develop new strategies for isolating TCRs with unique specificity or it could be used to carry out mutagenesis studies on TCR molecules for analyzing their structure-function. We initially selected a TCR from the murine T-cell hybridoma, DO11.10, as our model system, and genetically engineered a three domain single-chain TCR (scTCR) linked to the gene p8 protein of the Escherichia coli bacteriophage fd. Immunoblotting studies revealed that (1) E. coli produced a soluble scTCR/p8 fusion protein and (2) the fusion protein was packaged by the phage. Cellular competition assays were performed to evaluate the functionality of the TCR and showed the DO11.10 TCR-bearing phage could significantly inhibit stimulation of DO11.10 T hybridoma cells by competing for binding to immobilized MHC/peptide IA(d)/OVA(323-339). Flow cytometric analysis was carried out to evaluate direct binding of DO11.10 TCR-bearing phage onto the surface of cells displaying either IAd containing irrelevant peptide or OVA peptide. The results revealed binding of DO11.10 TCR-bearing phage only on cells expressing IA(d) loaded with OVA peptide showing TCR fine specificity for peptide. To illustrate the generality of TCR phage-display, we also cloned and displayed on phage a second TCR which recognizes a peptide fragment from human tumor suppressor protein p53 restricted by HLA-A2. These findings demonstrate functional TCR can be displayed on bacteriophage potentially leading to the development of novel applications involving TCR phage-display.     

Dbp5p, a cytosolic RNA helicase, is required for poly(A)+ RNA export

The DBP5 gene encodes a putative RNA helicase of unknown function in the yeast Saccharomyces cerevisiae. It is shown here that Dbp5p is an ATP-dependent RNA helicase required for polyadenylated [poly(A)+] RNA export. Surprisingly, Dbp5p is present predominantly, if not exclusively, in the cytoplasm, and is highly enriched around the nuclear envelope. This observation raises the possibility that Dbp5p may play a role in unloading or remodeling messenger RNA particles (mRNPs) upon arrival in the cytoplasm and in coupling mRNP export and translation. The functions of Dbp5p are likely to be conserved, since its potential homologues can be found in a variety of eukaryotic cells.