Construction and field measurement of high-speed railway test embankment built on Indian expansive soil “Black Cotton Soil”

The railway embankment applied to high-speed railways is required to have high performance in terms of strength and deformation characteristics. Especially in the case of railway embankments that support slab tracks, the allowable settlement is very small. There are two technical challenges in constructing high-speed rail embankments to support slab tracks in India. The first challenge is dealing with problematic black cotton soil (BCS), which is widely distributed in India but very unusual soil in Japan. The second challenge is posed by the strict deformation requirement in the construction of the embankments. In this study, a 6 m-high test embankment was constructed on BCS in India. The deformation of the embankment and changes in water content were measured over a period of 18 months. In the construction of the test embankment, two different BCS countermeasures were applied. The results of the tests on this embankment were compared with those from an embankment without countermeasures. Complicated deformation behaviors, including settlement and the uplift of embankment, were observed in the section without countermeasure. However, in the embankment with cement-mixed gravelly soil (CGS) slab improvement with geosynthetics, the much lower amplitude of embankment deformation is evidence of the effectiveness of this countermeasure. The cohesive non-swelling soil (CNS) layer applied immediately below the embankment to reduce the water content fluctuation of BCS was not effective enough for use for high-speed railway embankment. Besides determining the technical challenges for the BCS countermeasures, the results of this study confirmed that a high-performance embankment can be constructed with Indian embankment material by performing sufficient compaction management.     

Emission of Particulate Matter 2.5 (PM2.5) from Sewage Sludge Incinerators in Japan

Because fine particulate matter ≤2.5 µm in diameter (PM2.5) causes health problems, PM2.5 emissions are of concern. However, little research on stationary sources has been conducted. To determine the concentration and filtration behavior of PM2.5, dust was collected from five fluid-bed sewage sludge incinerators (SSIs) sorted by particle size using cascade impactors. The average PM2.5 concentration was 0.00014–4.8 mg/Nm³. The total estimated amount of PM2.5 emissions from the SSIs for all plants in Japan was 0.96–8.9 tons/year. Since the SSIs with dry Electrostatic Precipitators (EP) contributed 75–99% of the total emissions, replacing dry EPs with bag filters would significantly reduce the PM2.5 emissions from SSI.     

Inflammatory Biomarkers as Differential Predictors of Antidepressant Response

Although antidepressants are generally effective in the treatment of major depressive disorder (MDD), it can still take weeks before patients feel the full antidepressant effects. Despite the efficacy of standard treatments, approximately two-thirds of patients with MDD fail to respond to pharmacotherapy. Therefore, the identification of blood biomarkers that can predict the treatment response to antidepressants would be highly useful in order to improve this situation. This article discusses inflammatory molecules as predictive biomarkers for antidepressant responses to several classes of antidepressants, including the N-methyl-d-aspartate (NMDA) receptor antagonist ketamine.     

STD‐NMR‐Based Protein Engineering of the Unique Arylpropionate‐Racemase AMDase G74C

Structure‐guided protein engineering achieved a variant of the unique racemase AMDase G74C, with 40‐fold increased activity in the racemisation of several arylaliphatic carboxylic acids. Substrate binding during catalysis was investigated by saturation‐transfer‐difference NMR (STD‐NMR) spectroscopy. All atoms of the substrate showed interactions with the enzyme. STD‐NMR measurements revealed distinct nuclear Overhauser effects in experiments with and without molecular conversion. The spectroscopic analysis led to the identification of several amino acid residues whose substitutions increased the activity of G74C. Single amino acid exchanges increased the activity moderately; structure‐guided saturation mutagenesis yielded a quadruple mutant with a 40 times higher reaction rate. This study presents STD‐NMR as versatile tool for the analysis of enzyme–substrate interactions in catalytically competent systems and for the guidance of protein engineering.     

Assessing material qualities and efficiency limits of III–V on silicon solar cells using external radiative efficiency

The paper presents a quantitative approach to the investigation and comparison of the material qualities of III–V on silicon (III–V/Si) solar cells by using external radiative efficiencies. We use this analysis to predict the limiting efficiencies and evaluate the criteria of material quality in order to achieve high‐efficiency III–V/Si solar cells. This result yields several implications for the design of high‐efficiency III–V/Si solar cells. Copyright © 2016 John Wiley & Sons, Ltd.     

Negative Pore Air Pressure Generation in Backfill of Retaining Walls During Earthquakes and its Effect on Seismic Earth Pressure

In order to investigate the seismic behavior of conventional type and geosynthetic-reinforced soil retaining walls, 1-g model shaking tests were conducted. Model walls having a height of about 50 cm were placed on a subsoil layer and backfilled with a layer of dense dry Toyoura sand. They were subjected to several steps of horizontal irregular excitations. As a result, generation of negative pore air pressure in the backfill was observed. The maximum amplitude of the negative pore air pressure during each shaking step increased with the base acceleration. Based on analyses of the measured data, it was inferred that such negative pore air pressure was caused by outward wall displacement relative to the backfill and not by dilative behavior of the backfill. It would cause a reduction in the seismic earth pressures exerted from the backfill. This feature suggests an advantage of a rigid full-height facing for reinforced soil walls over the segmental types of facing. A simplified numerical procedure to evaluate earth pressure was applied while considering the effects of the negative pore air pressure, and it could qualitatively simulate the measured behavior in terms of the seismic earth pressure and the angle of failure plane in the backfill.     

Poly(4-diphenylaminostyrene) with a well-defined polymer chain structure: Controllable optical and electrical properties

The effect of polymer chain structure on the optical and electrical properties are reported for poly(4-diphenylaminostyrene) (PDAS), which was prepared by the living anionic polymerization of 4-diphenylaminostyrene (DAS) with the benzyllithium (BzLi)/N,N,N′,N′-tetramethylethylenediamine (TMEDA) system. The optical properties of PDAS are strongly affected by the stereoregularity of the PDAS polymer chain; intramolecular excimer-forming fluorescence was observed from PDAS with a syndiotactic-rich configuration. The highest occupied molecular orbital (HOMO) and lowest unoccupied molecular orbital (LUMO) energy levels of PDAS were approximately −5.4 and −2.0 eV, respectively, regardless of the polymer chain structure. The hole and electron drift mobilities for PDAS were in the order of 10⁻⁴ to 10⁻⁵ (cm²/V s) and 10⁻⁵ (cm²/V s), respectively, with negative slopes. The distance of each triphenylamino (TPA) group in the polymer chain was a major factor influencing the drift mobility of PDAS. The current-voltage (I-V) characteristics of PDAS were controllable according to the polymer chain structure of PDAS.     

Highly unsaturated fatty acid might act as an antioxidant in emulsion system oxidized by azo compound

Now it is recognized that DHA is oxidatively stable fatty acid compared with linoleic acid (LA) in emulsified system, although DHA is oxidatively unstable in a bulk system. In fact, an emulsified mixture of DHA and LA behaves as in a bulk system, namely the oxidative stability of DHA becomes lower than that of LA. Therefore, in this study, tridocosahexaenoate (DDD) and glycerol trilinoleate (LLL) were separately emulsified using TritonX-100 as an emulsifier and DDD emulsion was mixed with the oxidizing LLL emulsion using a water-soluble radical initiator, 2,2'-azobis(2-aminopropane) dihydrochloride. As a result, DHA suppressed the oxidation of LA, while DHA was not significantly oxidized. This suppression ability was examined using glycerol trieicosapentaenoate, glycerol trilinolenate, or glycerol trioleate instead of DDD and it was found that this activity was increased with the increasing number of double bonds in the structure. Furthermore, the same type of experiment was carried out using a lipid-soluble radical initiator, 2,2'-azobisisobutyronitrile and the similar result was obtained. These results indicated that a highly polyunsaturated fatty acid might act as an antioxidant in an emulsion system oxidized by an azo compound.     

Purification and Characterization of Organic Solvent and Detergent Tolerant Lipase from Thermotolerant Bacillus sp. RN2

The aim of this study was to characterize the organic solvent and detergent tolerant properties of recombinant lipase isolated from thermotolerant Bacillus sp. RN2 (Lip-SBRN2). The isolation of the lipase-coding gene was achieved by the use of inverse and direct PCR. The complete DNA sequencing of the gene revealed that the lip-SBRN2 gene contains 576 nucleotides which corresponded to 192 deduced amino acids. The purified enzyme was homogeneous with the estimated molecular mass of 19 kDa as determined by SDS-PAGE and gel filtration. The Lip-SBRN2 was stable in a pH range of 9-11 and temperature range of 45-60 °C. The enzyme was a non metallo-monomeric protein and was active against pNP-caprylate (C8) and pNP-laurate (C12) and coconut oil. The Lip-SBRN2 exhibited a high level of activity in the presence of 108% benzene, 102.4% diethylether and 112% SDS. It is anticipated that the organic solvent and detergent tolerant enzyme secreted by Bacillus sp. RN2 will be applicable as catalysts for reaction in the presence of organic solvents and detergents.