Polarization-controlled single-mode VCSEL

Relative intensity noise (RIN) in a vertical-cavity surface-emitting laser (VCSEL) was greatly reduced through the use of polarization control to eliminate competition between two orthogonal polarization states by ensuring there was only one polarization state. Polarization was stable with optical feedback of up to 10%. Polarization control was achieved by inducing a small loss anisotropy in fundamental transversal mode VCSEL's. Anisotropic post structures, such as a rectangular post, an oblique post, or a zigzag-sidewall post, were found to be effective in creating loss anisotropy without serious degradation of other VCSEL characteristics such as light-output power or beam profile     

Day-night variations of behavioral and autonomic thermoregulatory responses to lipopolysaccharide in rats

This study investigated the day-night differences in behavioral and autonomic thermoregulatory responses to bacterial lipopolysaccharide (LPS) in rats. Male rats were housed individually in cages with a 12: 12 h light dark cycle at an ambient temperature of 24 degrees C. The rats were placed in a box with a temperature gradient and intraperitoneally injected with LPS (10 micrograms/kg). The preferred ambient temperature (Tpr) was estimated by the location of the rats in the box, and intraperitoneal temperature (Tb) was measured by a biotelemetry system. Measurements were taken during the light and dark phases of the day. LPS produced fever in both phases. The magnitude of rise in Tb did not differ between the two periods. In the dark phase, Tpr significantly increased during the development of fever and decreased during the defervescence, while it did not change throughout the febrile course during the light phase. In a separate experiment, rats were loosely restrained and placed in a direct calorimeter. Their colonic temperature (Tcol), evaporative and nonevaporative heat loss and heat production were measured before and after intraperitoneal injections of LPS (10 micrograms/kg). Measurements were taken during the light and dark phases of the day. LPS induced fever in both phases. The magnitude of change in T col, heat loss, and heat production due to LPS did not differ between the two periods. These results suggest that the fertile response of rats to intraperitoneal LPS is not affected by the time of day. However, it seems that during LPS-induced fever, thermoregulatory behavior is not fully activated during the light phase of the day.     

Fabrication of blue-light emission fused-silica substrates by using Si-ion implantation and high-temperature annealing

We fabricated fused-silica substrates which emit blue light by using Si-ion implantation and high-temperature annealing. Photoluminescence peak wavelengths are around 400 nm, and the peak intensities can be remarkable after annealing above 1150 °C.     

An experimental BiCMOS video 10 bit ADC

The possibility of realizing a high-quality, low-power, and low-cost video 10 bit analog-to-digital converter is examined utilizing BiCMOS circuit and process technology. A single-power-supply, 10 bit 10 MHz operation, 500 mW power dissipation, and a 4.2×6.2 mm chip size with 4200 elements were obtained     

Bottom-up multi-agent reinforcement learning by reward shaping for cooperative-competitive tasks

Applied Intelligence - A multi-agent system (MAS) is expected to be applied to various real-world problems where a single agent cannot accomplish given tasks. Due to the inherent complexity in the...     

Stress corrosion cracking of aged Al---4%Cu alloy in NaCl solution

Stress-corrosion lives and pitting potentials of Al---4%Cu alloys with various aging structures have been measured in de-aerated 1M NaCl under conditions of controlled potential. It was found that the alloys aged having the higher susceptibility to stress-corrosion cracking showed two pitting potentials corresponding to pitting at grain boundaries and grain bodies, respectively. The susceptibility to stress corrosion cracking of the alloys appeared above the pitting potentials for grain boundaries. The maximum susceptibility to stress-corrosion cracking was obtained when the alloy was aged to attain the largest difference in pitting potentials between grain boundaries and grain bodies.     

Gelation of poly(vinyl alcohol) solutions at low temperatures (20 to −78°C) and properties of gels

The flow points of atactic poly(vinyl alcohol) (a-PVA) gels with H₂O/dimethyl sulfoxide (DMSO) = 90/10 (v/v) chilled at 20 to ?78°C for 24 h depended on the chilling temperature and were 0–30°C for gels with the initial polymer concentrations (C_i) of 2–5 g/dL, whereas those for H₂O/DMSO = 50/50 chilled at 0 to ?78°C were independent of the chilling temperature and were 70–75°C. Syneresis occurred after eight cycles of freezing (?24°C) and thawing (20°C) for a-PVA hydrogels at concentrations above C_i = 4 g/dL and two such cycles for syndiotacticity-rich PVA (s-PVA) hydrogels at concentrations above C_i = 1 g/dL. The extent of syneresis per one cycle for s-PVA hydrogels was higher than that for a-PVA hydrogels at the initial cycles. In the a-PVA hydrogels with an initial polymer concentration of ca. 30 g/dL, syneresis was expected not to occur even after 20 cycles. If all the free water in the gels is assumed to have transuded by syneresis after 20 cycles, the residual water is bound water and is estimated to be six water molecules per one vinyl alcohol monomer unit. © 1994 John Wiley & Sons, Inc.     

Electrochemical properties of boron-carbon-nitride films formed by magnetron sputtering

The electrochemical behavior of B_1.0C_2.4N_1.0 thin film was investigated in acidic, neutral and alkaline solutions. The anodic polarization curve of the film in 1 M NaOH showed the anodic dissolution of the film. The curve of the film in 1 M HCl showed no anodic dissolution. The cathodic polarization curve in 1 M NaCl showed shift to a negative potential side, but the anodic polarization curve was the same as that of Pt. The anodic dissolution in 1 M NaOH depended on potentials, that is, no anodic dissolution was recognized in a potential range of −0.2 to 0.1 V but the dissolution rate increased with increasing potential in a range of 0.1-0.6 V. The anodic current density of the film is directly proportional to the dissolution rate at potentials higher than 0.1 V. The dissolution rate of the film was increased with increasing solution pH.     

Preparation of Silicon Carbide and Aluminum Silicon Carbide from a Montmorillonite–Polyacrylonitrile Intercalation Compound by Carbothermal Reduction

Both silicon carbide and aluminum silicon carbide have simultaneously been obtained directly from naturally occurring aluminosilicate by carbothermal reduction for the first time. A precursor of a montmorillonite–polyacrylonitrile (PAN) intercalation compound was heated at 1700°C in Ar. For comparison, montmorillonite–carbon mixtures were similarly heated. α-SiC, β-SiC, and Al₄Si₂C₅ formed from the montmorillonite–PAN intercalation compound. Mainly α-Al₄SiC₄ was obtained with ternary carbides from the montmorillonite–carbon mixtures in addition to a large amount of β-SiC. Hence, aluminum silicon carbide formation was affected by the mixing condition of the starting materials.