Modeling and Analysis of a Long Thin Conducting Stripline

A long thin conducting stripline embedded in a dielectric and centered between two large conducting plates, i.e., the stripline environment, is considered. The stripline is modeled as infinitely long, infinitely thin, and perfectly conducting by first considering a stripline of finite length, thickness, and conductivity in a dielectric layer. Starting from Maxwell's equations and assuming that the current on the stripline is a propagating wave in length direction, asymptotic expressions for the fields inside and in the neighbourhood of the stripline are deduced. These expressions are used to model the stripline in the stripline environment, which leads to a boundary-value problem for the electric potential. This problem is solved by two different approaches, leading to integral equations for the current and for an auxiliary function describing the electric potential. A relation between the current and the auxiliary function is deduced, which is used to obtain asymptotic expressions for current and impedance. Results are compared with a numerical solution of the integral equation for the current and with results in literature.     

Electrical conductivity and gas sensitivity of Zn-Sb-O thick films

The thick film of Zn-Sb-O was prepared by coating the paste of nanoparticles mixture (Sb₂O₃:ZnO=1:3) on the alumina substrate, followed by sintering at 500-900 °C for 2 h in air. The electrical resistance and gas-sensing properties to benzene, alcohol and acetone of Zn-Sb-O films were found to be dependent on the change of phase structure caused by sintering temperature.     

Increasing the efficiency of metal-air current sources operating in a pulse-train mode

A considerable (～1.4-fold) increase in the average output power of a chemical current source has been achieved by means of a periodic pulsed manipulation of the load. A scheme used for the pulse-train loading is presented and mechanisms ensuring an increase in the average output power of the current source are considered.     

A threshold temperature effect for a carbon particle heated in plasma

Numerical simulations of the heating of a carbon dust particle (pellet) in hydrogen plasma showed that the character of heating depends in a threshold manner on the initial temperature of the pellet. The heating proceeds at a high rate if the initial temperature is above a certain threshold (“hot” regime), and at a much lower rate for an initial temperature below this threshold (“cold” regime). An important factor in this process is thermionic emission, which leads to positive charging of a pellet in hydrogen plasma due to electron emission from the surface in the hot regime. In the cold regime, the pellet acquires a negative charge that retards the electron flux from plasma to the particle. A method for the experimental observation of this effect is proposed.     

The Influence of Ir and Pt Addition on the Synthesis of Fullerenes at Atmospheric Pressure

The addition of metallic Ir and Pt to a fullerene-forming, atmospheric-pressure plasma reactor was found to influence the generation of carbonaceous products. It was observed that the added metals were efficiently dispersed into the plasma and that their presence increased the yield of fullerenes. The addition of Ir led to a noticeable shift in the fullerene distribution towards C₆₀, whereas the addition of Pt increased the proportion of C₆₀ oxides and decreased the proportion of higher fullerenes. Addition of Ir also caused a reduction of the soot particle size and the formation of a considerable quantity of carbon nanotubes.     

Parallel path consistency

Filtering algorithms are well accepted as a means of speeding up the solution of the consistent labeling problem (CLP). Despite the fact that path consistency does a better job of filtering than arc consistency, AC is still the preferred technique because it has a much lower time complexity. We are implementing parallel path consistency algorithms on multiprocessors and comparing their performance to the best sequential and parallel arc consistency algorithms.^(1,2) (See also work by Kerethoet al. ⁽³⁾ and Kasif⁽⁴⁾) Preliminary work has shown linear performance increases for parallelized path consistency and also shown that in many cases performance is significantly better than the theoretical worst case. These two results lead us to believe that parallel path consistency may be a superior filtering technique. Finally, we have implemented path consistency as an outer product computation and have obtained good results (e.g., linear speedup on a 64K-node Connection Machine 2).     

An integrated system to remote monitor and control anaerobic wastewater treatment plants through the internet.

The TELEMAC project brings new methodologies from the Information and Science Technologies field to the world of water treatment. TELEMAC offers an advanced remote management system which adapts to most of the anaerobic wastewater treatment plants that do not benefit from a local expert in wastewater treatment. The TELEMAC system takes advantage of new sensors to better monitor the process dynamics and to run automatic controllers that stabilise the treatment plant, meet the depollution requirements and provide a biogas quality suitable for cogeneration. If the automatic system detects a failure which cannot be solved automatically or locally by a technician, then an expert from the TELEMAC Control Centre is contacted via the internet and manages the problem.     

Sensory analysis of polystyrene packaging material taint in cocoa powder for drinks and chocolate flakes

Polystyrene packaging material taint was sensorily evaluated in cocoa powder for drinks and chocolate flakes using short-cut signal detection measures on differences between control and test samples and on recognition of styrene. No differences were observed in cocoa powder for drinks and plain chocolate flakes treated with 0.5 dm2 polystyrene of 1 mm thickness. However, differences were detected in milk chocolate flakes and plain chocolate flakes, which were in contact with a larger area or thicker polystyrene packaging material. The latter results were confirmed by the styrene recognition test, so polystyrene is a potential source of off-flavour for chocolate products. The amount of residual styrene in the polystyrene used was about 320 ppm, while the amounts of styrene ranged from 7 to 132 ppb in cocoa drinks and from 414 to 1447 ppb in chocolate flakes.