Photoluminescence and X-ray Diffraction of Distributed Bragg Reflector

Spectral and structural characteristics of distributed Bragg reflector (DBR) in vertical-cavity surface-emitting lasers were studied with photoluminescence and double- crystal X- ray diffraction measurement. The expected high quality epitaxial DBR structure was verified. In the X- ray double- crystal rocking curves of DBR the zeroth- order peak, the first and second order satellite peaks were measured. Splitting of diffraction peak appeared in the rocking curves was analyzed. The effects of introduced deep energy levels on the structural perfection and optical properties were discussed.     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

一种动态开关电容运算放大器共模负反馈电路

本文主要介绍了一种应用于Cascode结构运放中的开关电容共模负反馈电路，它具有稳定性好、对运放频率特性影响小、不消耗额外功率等优点。对电路运用Hspice进行了模拟，并给出了模拟结果。     

基于聚类算法实现信号盲分类

本文解决了信号处理、工业控制等领域存在的非平稳信号盲分类问题。在聚类中广泛应用的K-Means算法及其它基于中心的聚类算法有两个共同的缺陷-需要预先确定类数目且随机初始化中心引起性能不稳定。本文提出的算法较好地解决了这两个问题，提高了算法稳定性，实现了非平稳信号盲分类。提取非平稳信号的小波系数作为聚类的样本空间，分析聚类结果的统计偏差以估计类的数目，采用调和均值准则进行分类。最后给出的仿真结果表明本文提出的方法较传统的K-Means算法明显降低分类错误率。     

Modelling biological processes under anaerobic conditions through integrating titrimetric and off-gas measurements-applied to EBPR systems.

An innovative method for modelling biological processes under anaerobic conditions is presented and discussed. The method is based on titrimetric and off-gas measurements. Titrimetric data is recorded as the addition rate of hydroxyl ions or protons that is required to maintain pH in a bioreactor at a constant level. An off-gas analysis arrangement measures, among other things, the transfer rate of carbon dioxide. The integration of these signals results in a continuous signal which is solely related to the biological reactions. When coupled with a mathematical model of the biological reactions, the signal allows a detailed characterisation of these reactions, which would otherwise be difficult to achieve. Two applications of the method to the enhanced biological phosphorus removal processes are presented and discussed to demonstrate the principle and effectiveness of the method.     

CMOS gyrator-C active transformers

A systematic approach for synthesising gyrator-C active transformers using MOS transistors is presented. The topology of gyrator-C active inductors and their characteristics are briefly reviewed first. This is followed by the development of ideal gyrator-C active transformers, where only the capacitor loads of the transconductors synthesising active transformers are considered. The self and mutual inductances of both the primary and secondary windings of active transformers are investigated in detailed. Non-ideal gyrator-C active transformers are developed with the consideration of both the resistance and capacitance loads of transconductors. The intrinsic relation between the self and mutual inductances is derived. The configuration of gyrator-C active transformers with multiple primary and secondary windings is also developed. The proposed active transformers offer large and tunable self and mutual inductances with virtually no silicon area requirement. Several practical implementations of the proposed active transformers have been realised in TSMC-0.18 mum 1.8 V CMOS technology and analysed using SpectreRF with BSIM3v3 device models. Simulation results on voltage transfer characteristics, self and mutual inductances, quality factors, stability, the effect of process variations, and noise are presented. The application of the proposed active transformers is exemplified using a 1.6 GHz active transformer quadrature oscillator.     

Fatigue Behavior and Retrofit Investigation of Distortion-Induced Web Gap Cracking

This paper studies a Kansas Department of Transportation welded plate girder bridge that developed fatigue cracks at small web gaps close to the girder top flange. Repair had been previously performed by softening the connection plate end with a slot retrofit, but cracks were recently found to have reinitiated at some of the repaired details and are again propagating. A comprehensive finite-element method study was performed to investigate the cracking behavior observed in the bridge and to recommend appropriate measures for future bridge retrofit. The analytical results show that stresses developed at the top flange web gaps could exceed yielding under the loading of an HS15 fatigue truck. The current slot repair used in the bridge was found to have introduced higher magnitude fatigue stresses in the web gap. To achieve a permanent repair of the bridge, it is recommended that a welded connection plate to flange attachment be used during future bridge retrofit. The web gap details should be able to withstand unlimited number of load cycles once this additional repair is performed.     

项目管理软件的开发思路

详细介绍了项目管理的发展及项目管理软件的现状。通过对P3管理软件的分析论述，得出项目管理软件系统的开发方案。     

Prolog逻辑程序的测试方法

Prolog逻辑程序设计语言具有不同于传统程序设计语言的特点.本文根据测试Prolog程序的实践,提出了一系列为Prolog程序生成测试用例的准则.按这些准则测试实际程序效果良好.这是在逻辑程序测试新领域迈出的一步.     

Ozonation of CI Reactive Black 5 using rotating packed bed and stirred tank reactor

This study investigates the ozonation of CI Reactive Black 5 (RB5) by using the rotating packed bed (RPB) and completely stirred tank reactor (CSTR) as ozone contactors. The RPB, which provides high gravitational force by adjusting the rotational speed, was employed as a novel ozone contactor. The same ozone dosage was separately introduced into either the RPB or the CSTR for the investigation, while the experimental solution was continuously circulated within the apparatus consisting of the RPB and CSTR. The decolorization and mineralization efficiencies of RB5 in the course of ozonation are compared for these two methods. Moreover, the dissolved and off‐gas ozone concentrations were simultaneously monitored for the further analysis. As a result, the ozone mass transfer rate per unit volume of the RPB was significantly higher because of its higher mass transfer coefficient and gas–liquid concentration driving force. Furthermore, ozonation kinetics was found to be independent of the gravitational magnitude of an ozone gas–liquid contactor. Therefore, the results suggest employing RPBs as ozone‐contacting devices with the advantage of volume reduction. The experimental results, which can be used for further modeling of the ozonation process in the RPB, also show the requirement of correct design for the RPB. Consequently, the present study is useful for the understanding of practical application of RPBs. Copyright © 2004 Society of Chemical Industry