Measurement of Onset of Structural Relaxation in Melt-Quenched Phase Change Materials

Chalcogenide phase change materials enable non-volatile, low-latency storage-class memory. They are also being explored for new forms of computing such as neuromorphic and in-memory computing. A key challenge, however, is the temporal drift in the electrical resistance of the amorphous states that encode data. Drift, caused by the spontaneous structural relaxation of the newly recreated melt-quenched amorphous phase, has consistently been observed to have a logarithmic dependence in time. Here, it is shown that this observation is valid only in a certain observable timescale. Using threshold-switching voltage as the measured variable, based on temperature-dependent and short timescale electrical characterization, the onset of drift is experimentally measured. This additional feature of the structural relaxation dynamics serves as a new benchmark to appraise the different classical models to explain drift.     

用脉冲激光沉积法在Al2O3上沉积类金刚石薄膜

为了研究沉积时间和衬底温度对类金刚石薄膜的影响,在用脉冲激光沉积法在Al2O3衬底上制备类金刚石薄膜的实验中,保持其他实验参数不变,先取沉积时间分别为15 min和40 min来沉积薄膜;再取衬底温度分别30℃和300℃来沉积薄膜.用显微镜观察薄膜是否有起皱现象,用Raman光谱仪检测薄膜的微观结构,用原子力显微镜检测...     

Conducted EMI Reduction in Power Converters by Means of Periodic Switching Frequency Modulation

Spread spectrum clock generation techniques were originally developed to reduce electromagnetic interference (EMI) in communications and microprocessor systems working in the range of hundreds of megahertz. Nowadays, the switching frequency of power converters has been increasing up to values that make worthy the application of such switching frequency modulation techniques to reduce EMI emissions in power converters. Although random modulations have been applied before to power converters, periodic patterns can provide some advantages. First, theoretical principles of frequency modulation using three periodic patterns for the modulating function are presented. The influence of some important modulation parameters on the EMI reduction is analyzed and some considerations about the EMI filters design are also presented. The effectiveness of such methods in terms of EMI reduction is demonstrated theoretically and confirmed with experimental results obtained from tests carried out on two converters. The first one is a 2.5 W buck converter that can be switched up to 1 MHz and the second one is a 600 W boost converter switching at 40 kHz. In both cases, attenuations obtained in conducted EMI are evaluated. Finally, special attention has been paid to input current and output voltage ripple in order to evaluate possible undesired side-effects produced by this technique.     

BOSS系统工程助推中国移动服务再上新台阶

对中国移动通信业务运营支撑系统（BOSS）的总体方案进行了描述，说明了该系统的总体设计思路以及系统的结构和组成。     

Throughput-based fair bandwidth allocation in OBS networks

Fair bandwidth allocation (FBA) has been studied in optical burst switching (OBS) networks, with the main idea being to map the max-min fairness in traditional IP networks to the fair-loss probability in OBS networks. This approach has proven to be fair in terms of the bandwidth allocation for differential connections, but the use of the ErlangB formula to calculate the theoretical loss probability has made this approach applicable only to Poisson flows. Furthermore, it is necessary to have a reasonable fairness measure to evaluate FBA models. This article proposes an approach involving throughput-based-FBA, called TFBA, and recommends a new fairness measure that is based on the ratio of the actual throughput to the allocated bandwidth. An analytical model for the performance of the output link with TFBA is also proposed.     

Asymptotic Bias and Variance of Conventional Bispectrum Estimates for 2-D Signals

In this paper, we derive the asymptotic bias and variance of conventional bispectrum estimates of 2-D signals. Two methods have been selected for the estimation: the first one – the indirect method – is the Fourier Transform of the weighted third order moment, while the second one – the direct method – is the expectation of the Fourier component product. Most of the developments are known for 1-D signals and the first contribution of this paper is the rigorous extension of the results to 2-D signals. The calculation of the bias of the direct method is a totally original contribution. Nevertheless, we did all calculations (bias and variance) for both method in order to be able to compare the results. The second contribution of this paper consists of the comparison of the theoretical bispectrum estimate bias and variance with the measured bias and variance for two 2-D signals. The first studied signal is the output of a non-minimal phase linear system driven by a non-symmetric noise. The second signal is the output of a non-linear system with Gaussian input data. In order to assess the results, we performed the comparison for both methods with different sets of parameters. We show that the maximum bias coefficient is the one of the 1-D case multiplied by the dimensionality of the signal for both methods. We also show that the estimate variance coefficient is the 1-D case coefficient with a power equal to the signal dimensionality.Received October 21, 2002; Revised December 2003; Accepted March 25, 2004; First Online Version published in December 2004     

On the stationary distribution of speed and location of random waypoint

In "Stationary distributions for the random waypoint mobility model" (TMC, Vol. 3, No, 1), Navidi and Camp find the stationary distribution of the random waypoint model, with or without pause on a rectangular area. In this short note, we show that, under the stationary regime, speed and location are independent.     

变频器在制药厂空调系统中的应用

在制药厂车间中，空调系统是非常重要的一环，除完成对车间内温湿度的精确控制之外，还有一个重要的作用，就是控制车间与室外空气的压差，使车间内保持微正压状态，维持车间的洁净度达到GMP要求。     

三角形天线瞬态响应特性的模拟与改进

利用时域有限差分方法(FDTD)对三角形天线的瞬态响应特性进行了分析,通过改变天线形状以及在天线表面开槽来改善天线的辐射特性的方法,设计了一种在表面开槽的扇形天线,该天线可以有效地减少天线在远场辐射的电(磁)场随时间变化波形尾部的震荡.     

Bandwidth‐efficient turbo coding over Rayleigh fading channels

Introduced in 1993, turbo codes can achieve high coding gains close to the Shannon limit. In order to design power and bandwidth‐efficient coding schemes, several approaches have been introduced to combine high coding rate turbo codes with multilevel modulations. The coding systems thus obtained have been shown to display near‐capacity performance over additive white Gaussian noise (AWGN) channels. For communications over fading channels requiring large coding gain and high bandwidth efficiency, it is also interesting to study bit error rate (BER) performance of turbo codes combined with high order rectangular QAM modulations. To this end, we investigate, in this paper, error performance of several bandwidth‐efficient schemes designed using the bit‐interleaved coded modulation approach that has proven potentially very attractive when powerful codes, such as turbo codes, are employed. The structure of these coding schemes, termed ‘bit‐interleaved turbo‐coded modulations’ (BITCMs), is presented in a detailed manner and their BER performance is investigated for spectral efficiencies ranging from 2 to 7 bit/s/Hz. Computer simulation results indicate that BITCMs can achieve near‐capacity performance over Rayleigh fading channels, for all spectral efficiencies considered throughout the paper. It is also shown that the combination of turbo coding and rectangular QAM modulation with Gray mapping constitutes inherently a very powerful association, since coding and modulation functions are both optimized for operation in the same signal‐to‐noise ratio region. This means that no BER improvement is obtainable by employing any other signal constellation in place of the rectangular ones. Finally, the actual influence of the interleaving and mapping functions on error performance of BITCM schemes is discussed. Copyright © 2002 John Wiley & Sons, Ltd.