Characterization of optically active and photocurable ORMOSIL thin films deposited using the Aerosol process

Aerosol-gel process is a deposition method based on the sol-gel polymerization of a liquid film produced from an ultrasonically sprayed aerosol. This process offers an attractive alternative for the deposition of photocurable SiO₂—TiO₂ ORMOSIL films. 3-(trimethoxysilyl) propylmethacrylate and tetraisopropyl-orthotitanate complexed with methacrylic acid were used as sol-gel precursors. Doping with a terbium:sulphosalicylic acid complex was also studied to test the deposition of spectroscopically active photocurable films. FTIR spectroscopy has been used to study the precursor solutions and ORMOSIL films. It is shown that titanium precursor incorporation enhances the solution reactivity, which yields optical quality thin films. Photopolymerization and photoluminescence properties of the films are reported and discussed with respect to the experimental parameters. The results allow envisaging the UV-imprinting fabrication of Aerosol-gel-derived active waveguides.     

Negative thermal expansion of laminates

Measurements have been carried out on the in-plane and through the thickness thermal expansion coefficients of glass polypropylene fibre composites of 50% volume fraction between room temperature and 120°C. Only in the temperature range 20° to 75°C are reproducible results obtained. It is confirmed that in-plane negative values may be obtained in specific directions. The physical reason for this and its connection with the necessary appearance of a large Poisson ratio is pointed out. The expansivity of the matrix material depends strongly on temperature. Very good agreement between the experimental values and those predicted from the properties of the two constituents is found provided that the value for the expansivity of the polyoropylene is that within the temperature range considered. It is shown that the polypropylene matrix does not provide a matrix which is stable enough in its properties to enable the system to yield consistent negative values of expansivity. An alternative system is proposed and a single experiment confirms that a negative value of the thermal expansivity of as large as –50 × 10^–6 K^–1 may be obtained.     

A versatile data acquisition system for time resolved X-ray scattering using gas proportional detectors with delay line readout

A data acquisition system for time resolved X-ray scattering experiments using linear, quadrant or area gas proportional detectors with delay line readout based on commercially available hardware (National Instruments) is described. The system can easily be configured for recording data from point detectors (e.g. photomultipliers and photodiodes) and/or ancillary data only. Applications involving measurements with two different types of time to digital converters illustrate the features and performances of the system.     

Feasibility study of absolute activity measurement with metallic magnetic microcalorimeters

We report on a feasibility study on precise determination of mass-specific activity of low-energy emitting radioisotopes. Conventional methods of activity measurement suffer from source self-absorption and a strong decrease in detection efficiency for low-energy electrons and photons. We propose a new method based on metallic magnetic microcalorimeters with the source embedded in the detector target in a 4π geometry. First results with a ⁵⁵Fe source show that electrons and photons are detected with a detection efficiency close to unity and with little loss of energy for electrons. The aim of this study is to provide standards of activity with very low uncertainties in the framework of radiation metrology.     

On energy arguments applied to the hydrodynamic impact force

The hydrodynamic impact problem is investigated within the framework of potential-flow theory. The vertical load acting on the rigid body is derived based on either momentum or energy conservation, and using the concept of added mass together with a homogeneous Dirichlet condition for the potential on the free surface as usually done to model an impact problem. It is demonstrated that the use of this simplified dynamic free-surface condition, instead of the fully nonlinear one, has a direct influence on the computation of the loads. In particular, the equivalence of momentum and energy analysis is in general not recovered. The situation is then highlighted by performing an asymptotic analysis of the two-dimensional blunt-body asymmetric impact problem. The asymptotic solution is given explicitly and validated through comparisons with experimental results. The energy distribution is then studied. It is shown that the contradiction between momentum and energy analysis can be removed, provided that the flux of energy through the jets is taken into account in the energy balance. If the simplified free-surface condition is indeed valid in the far-field, nonlinear terms must be retained near the body, in the spray-root domains. To leading order, the energy distribution during the gravity-free inertia stage does not depend on the blunt-body shape. The general analysis based on momentum or energy conservation suggests that this result also applies for arbitrary body shape as soon as a homogeneous Dirichlet condition can be applied as a dynamical free-surface boundary condition. In this case, and for a constant vertical impact velocity, half the work performed by the body would seem to be transferred to the fluid as kinetic energy within the spray.     

Wave dynamics on a thin-liquid film falling down a heated wall

The dynamics of a thin liquid film falling down a uniformly heated wall is studied. The model introduced by Kalliadasis et al. [J. Fluid Mech. 475 (2003) 377] for the same problem is revisited and its deficiencies, namely the prediction of a critical Reynolds number with 20% error, cured. For the energy equation a high-order Galerkin projection in terms of polynomial test functions is developed. It is shown that not only does this more refined formulation correct the critical Reynolds number, but it also gives, with an appropriate expansion close to criticality, the long-wave theory. Bifurcation diagrams for permanent solitary waves are constructed and compared with the solution branches obtained from different models. It is shown that, in all cases, the long-wave theory exhibits limit points and branch multiplicity, while the other models predict the continuing existence of solitary waves. Time-dependent computations show that the free surface and interfacial temperature approach a train of coherent structures that resemble the infinite-domain stationary solitary pulses.     

SQUID NMR Studies of the Second Layer of 3He at High Density

Nuclear magnetism in the second layer of ³He films on graphite has been studied as a function of density in the zero-field limit at temperatures down to 300 µK. Total surface coverages in this study ranged from 20 atoms/nm² (the lowest coverage at which the effective exchange parameter turns ferromagnetic) through the two-phase region (ending at about 24 atoms/nm²) and into the single-phase imcommensurate solid region up to 31.2 atoms/nm². The surface layers were studied using both pulsed and cw NMR measured with our SQUID NMR system in magnetic fields of 500 µT and lower. As the surface density continues to increase in the single-phase region, the exchange constant decreases consistently with a picture of steric hindrance impeding ferromagnetic exchange. Several different observational features scale with this inferred exchange: low-field magnetization, NMR frequency shift, and the temperature of onset of significant magnetization.