Hydrogels based on graft copolymers of collagen synthesis

Graft copolymerization of 2-hydroxyethyl methacrylate in combination with hydrophobic monomers onto soluble collagen was employed in the synthesis of hydrogels. The hydrogels were formed by simultaneous graft copolymerization and crosslinking. In order to study the effect of various crosslinking agents on the water retention character of the hydrogels, three different crosslinking agents, namely, N,N′-methylene bis acrylamide, 1,4-butanediol dimethacrylate, and hexamethylene urethanediacrylate were used. Hexamethylene urethanediacrylate crosslinked systems require a minimum amount of crosslinking agent to attain maximum water content in comparison to the other systems.     

Axial pressure profiles in non-newtonian flow: Part I: Theoretical and experimental considerations

The flow behavior of polymeric fluids in tubes can be determined from measurements of the radial stress profile in the flow direction. This subject, the focus of our research, will be examined in Part II of this communication. Part I describes a research designed to test the accuracy of stress measurement with pressure transducers in a variety of recess mount geometries. No mount geometry errors were detected for the fluids used in this work over a shear rate range of 1 to 2000 sec^?1. Part I also contains a survey of the literature and theoretical considerations pertinent to the entire work.     

High temperature swelling of coal/tetralin mixtures in a high pressure microdilatometer

High pressure microdilatometer experiments were performed on a subbituminous (Wyodak) and a bituminous (Illinois no. 6) coal in helium and hydrogen atmospheres with and without added tetralin. Wyodak coal samples showed no swelling but contractions ranging between 24 and 40 vol% upon heating at 20 and 100 °C min^{− 1} under helium or hydrogen pressures between 150 and 1000 psig (˜1.0–6.9 MPa). Under the same conditions, Illinois no. 6 coals displayed contractions (25–60 vol%) prior to swelling up to 117 vol%. Upon tetralin addition (at 35–190 wt% of the coal), Wyodak coal samples did not swell but showed an increasing contraction with increasing helium or hydrogen pressure due to a slight softening and fusion of the coal particles. In contrast, addition of tetralin at much lower concentrations (5–35 wt%) had a marked effect on the contraction and swelling behaviour of Illinois no. 6. A maximum swelling of 200 vol% was obtained at a tetralin addition of 30 wt%. The increased swelling results from more extensive softening and fusion of coal particles in the presence of tetralin. Both coals showed a decreasing char yield with increasing tetralin concentration. The substantially lower extent of interaction observed between Wyodak coal samples and tetralin compared to Illinois no. 6 coal can be attributed to the differences in pore structure and/or chemical constitution of the two coal samples. Examination of the resultant solids by optical microscopy revealed the microstructural changes produced by thermal treatment in dilatometer experiments.     

Light-sensitive elastomers modified by 4-(N-dimethylmaleimido)-benzenesulphenyl chloride

New light-sensitive polymers were prepared by modification of four different elastomers with 4-(N-dimethylmaleimido)-benzenesulphenyl chloride (DMI-BSCI). Polydienes modified by DMI-BSCI form block copolymers. These polymers show a strong increase of the glass transition temperature T_g whereby the T_g increase of modified poly(octenamer) is much smaller. Higher modified polydienes have two T_g. Modified poly(octenamers) show a melting temperature dependence T_m on the content of trans double bonds which is characteristic of statistical copolymers. The ratio of rate constants with which trans- and cis-structures in poly(octenamer) are occupied by DMI-BSCI, is

$\text{k}{}_{\mathrm{trans}}\text{k}{}_{\mathrm{cis}}\text{= 0.34}$

     

Lipids ofCrassostrea virginica. I. Preliminary investigations of aldehyde and phosphorous containing lipids in oyster tissue

Oyster tissue contained 2.4% lipid, 0.14 μmole aldehyde per milligram lipid and at least 10 μg phosphorous per milligram lipid. The neutral lipid represented 58%, the glycolipid 6%, and the polar lipid 36% of the total lipid recovered after silicic acid column chromatography. Aldehydes were found in all fractions, but the presence of plasmalogen was verified in only the neutral and polar lipid fractions. At least 68% of the plasmalogen in oyster lipid was found in the polar lipid fraction. At least 13% of the phosphorous in oyster lipids was present as phosphonolipid. The distribution of phosphate and phosphonate lipids was: diacyl phospholipid 38.1%, plasmalogen phospholipid 21.8%, sphingophosphonolipid 13.5%, glyceryl ether phospholipid 8.3%, sphingophospholipid 6.9%, plasmalogen phosphonolipid 6.4%, diacyl phosphonolipid 2.6%, and glyceryl ether phosphonolipid 2.4%. When the per cent of phosphorous as phosphonolipid within the plasmalogen and glyceryl ether classes was calculated, similar values were obtained. These results support the hypothesis that there is a product precursor relationship between these two classes of lipids. Some of the data taken from a thesis to be submitted to the Graduate School, University of Maryland, by Leslye Johnson in partial fulfillment of the requirements for the M.S. degree in biochemistry.     

Living carbocationic polymerization

Conventional cationic polymerization can be converted into living carbocationic polymerization (LC^⊕Pzn) by the introduction of common anion into the charge. Thus the conventional polymerization of isobutylene (IB) induced by the 2-chloro-2,4,4-trimethylpentane (TMPCl)/TiCl₄ combination yields LC^⊕Pzn of IB upon the addition of tetrabutyl ammonium chloride (n-Bu₄NCl), most likely due to then-Bu₄NCl+TiCl₄ ?n-Bu₄N^⊕+TiCl ₅ ^⊕ equilibrium. A kinetic model has been developed and tested which corroborates these propositions. By this model we have gained for the first time quantitative insight into the quasiliving equilibrium.     

Interactive sonification to assist children with autism during motor therapeutic interventions

Personal and Ubiquitous Computing - Interactive sonification is an effective tool used to guide individuals when practicing movements. Little research has shown the use of interactive sonification...     

Characterizing the deformation of cold-rolled copper sheet

An advanced x-ray diffraction technique allows the development of texture components to be monitored and provides supplementary information about the cold work and residual stresses in cold-rolled copper sheet. The new technique confirms the results of an ultrasonic test, except for the ultrasonic test’s sensitivity to grain size. The new x-ray diffraction technique could be adapted to provide in-process, nondestructive evaluation of thin copper sheet, even for material moving at high speeds.     

Subroutine based detection of APT malware

Statistical detection of mass malware has been shown to be highly successful. However, this type of malware is less interesting to cyber security officers of larger organizations, who are more concerned with detecting malware indicative of a targeted attack. Here we investigate the potential of statistically based approaches to detect such malware using a malware family associated with a large number of targeted network intrusions. Our approach is complementary to the bulk of statistical based malware classifiers, which are typically based on measures of overall similarity between executable files. One problem with this approach is that a malicious executable that shares some, but limited, functionality with known malware is likely to be misclassified as benign. Here a new approach to malware classification is introduced that classifies programs based on their similarity with known malware subroutines. It is illustrated that malware and benign programs can share a substantial amount of code, implying that classification should be based on malicious subroutines that occur infrequently, or not at all in benign programs. Various approaches to accomplishing this task are investigated, and a particularly simple approach appears the most effective. This approach simply computes the fraction of subroutines of a program that are similar to malware subroutines whose likes have not been found in a larger benign set. If this fraction exceeds around 1.5 %, the corresponding program can be classified as malicious at a 1 in 1000 false alarm rate. It is further shown that combining a local and overall similarity based approach can lead to considerably better prediction due to the relatively low correlation of their predictions.