新型超微晶软磁合金FePCCuMoSi微观结构缺陷的正电子湮没研究

用正电子湮没方法研究了新型超微晶软磁合金的微观结构缺陷，样品选用的是在不同温度下退火的Ｆｅ８１Ｐ１２Ｃ３Ｃｕ１Ｍｏ０．５Ｓｉ２．５合金，结果表明，合金的微观结构构陷大小，密度随退火温度有规律地变化，这种现象可能与非晶的晶化过程有关。     

Cervicovaginal foetal fibronectin in the prediction of preterm labour in a low-risk population

Ten groups of 14 immunosuppressed NMRI-mice (nu/nu) were raised and kept under germ-reduced conditions. The control animals were fed a germ-reduced diet, nine other groups received the same diet with selegiline (CAS 14611-51-9, Deprenyl) or lipoic acid (thioctic acid, CAS 62-46-4) admixed at various amounts. The 50% survival rate, the total life span of each group and the areas under the curves were determined to evaluate life expectancy as compared to the controls. The racemate of lipoic acid at high dosage (350 mg/kg body weight) reduced the life span significantly. The S(-)-enantiomer of lipoic acid (75 mg/kg body weight) increased the 50% survival rate, whereas the physiologic R(+)-enantiomer (9 mg/kg body weight) expanded the total life span of its group. Alteration of only one out of three parameters was not considered significant. All other groups except for one did not differ from controls: only animals which obtained 75 micrograms selegiline per kg of body weight and per day exerted increased life expectancies by all three parameters. This group exhibited also in statistical evaluation a significantly (p < 0.05) prolongated survival time up to about 200% as compared to the control animals.     

Effect of crosslinking agent content, monomer functionality, and repeat unit chemistry on properties of unfilled resins

Seven mechanical/physical properties were used to evaluate 10 unfilled resins: eight aromatic dimethacrylates and two urethane dimethacrylates. Physical property tests included compressive strength, Young's modulus in compression, uniaxial tensile strength, intrinsic yield point, toothbrush abrasion, Knoop hardness, and water sorption. Controlled changes were made in the following four material parameters: amount of crosslinking diluent present in the uncured monomer, functionality of the monomer, repeat unit chemistry of the monomer (urethane vs. aromatic structure) and mode of activation (chemical vs. visible light). Polymers containing a high concentration of crosslinking agent (50 wt%) were found to be tougher and to possess lower hardness than materials containing lesser amounts of crosslinking agent. This was attributed to the flexible nature of the triethylene glycol dimethacrylate crosslinking molecule. Exposure to water plasticized the highly crosslinked materials to the degree that the yield point and elastic modulus were effectively lowered. Most of the tested properties were unaffected by differences in functionality except resistance to toothbrush abrasion, which was enhanced for polymers derived from high functionality monomers. The urethane-based polymers sorbed substantially more water than the aromatic-based materials, which presumably resulted in lower values for surface hardness. However, the urethane resins were very tough, and excellent resistance to toothbrush abrasion was observed. Property differences caused by differences in activation mode were small, although the visible light materials did sorb more water.     

一个矢量形式的双圆弧插值算法

本文在分析数控插补最常用的双圆弧插值算法特点的基础上，将以局部坐标系中的三角运算为核心的传统双圆弧插值算法，改造成为以整体坐标系中的线性运算为核心的矢量形式的双圆弧插值算法，从而减少了计算的复杂性和程序的复杂性，提高了效率和可靠性。     

溶液扩散系数自动测量系统

结合实时法全息干涉计量和数字图象处理技术，提出了一种溶液扩散系数的自动测量系统。在干涉图的处理中，采用了相位检测和曲线拟合技术，得到了亚象素的测量精度。     

重馏分油加氢脱氮反应动力学模型的研究

简要地介绍了一些典型的模型氮化物的ＨＤＮ反应规律。根据胜利ＶＧＯ在３７２２Ｂ催化剂上的大量ＨＤＮ实验数据，提出了如下的ＨＤＮ基本反应动力学方程：ｄＣＮｄｔ＝－ｋ１＋Ｋ＊ＣＮＣＮＰＨ２为了扩大上式的应用范围，详细分析了各种因素（如原料油种类和馏程及Ｈ２Ｓ等）对ＨＤＮ的影响，并开发了相应的经验关联式，从而得到了一个较完整的馏分油ＨＤＮ反应动力学模型。验证实验表明，该模型是成功的。     

Breath and blood ethanol following use of a cough-cold preparation

All leaders in health care today are charged with the responsibility of transforming present practices into new and different ones that are needed for the future. The structural side of transforming is ultimately easier than the human side. However, the most frequent failures come from not concentrating sufficiently on the behavioral side of the change. Structural and psychological change must occur simultaneously and embrace each other for best results.     

Interleukin 4, interferon-gamma, and prostaglandin E impact the osteoclastic cell-forming potential of murine bone marrow macrophages

Interleukin 4 (IL-4) is an immune cytokine that inhibits bone resorption in mice and suppresses osteoclastic cell formation in vitro through an undefined mechanism. In this report, we have established the cellular identity of the IL-4 target cell using a variety of bone marrow/stromal cell coculture methods. Initially, we found that the majority of IL-4's inhibition of osteoclastic cell formation was due to its effect on bone marrow cells, not stromal cells. Consequently, bone marrow macrophages were used as osteoclastic cell progenitors after they had been transiently exposed to IL-4 (48 h), before the addition of stromal cells, 1,25-dihydroxyvitamin D3, and dexamethasone. In this circumstance, IL-4 impaired subsequent osteoclastic cell formation, suggesting that the macrophage may be potentially targeted by many factors known to influence osteoclast formation. Consequently, we discovered that interferon-gamma (IFN gamma), prostaglandin E (PGE), and cell-permeant cAMP analogs also impacted osteoclastic cell formation when used to selectively treat bone marrow macrophages. IFN gamma suppressed osteoclastic cell formation, whereas PGE and cAMP analog treatment led to the formation of significantly enlarged osteoclastic cells. Importantly, PGE antagonized the inhibitory effects of both IL-4 and IFN gamma on the osteoclastic cell-forming potential of bone marrow macrophages. Collectively, these findings establish bone marrow macrophages as osteoclastic cell precursors with the degree of their commitment to the osteoclast pathway sensitive to the effects of soluble mediators, including IL-4, IFN gamma, and PGE.